Where is the NIO ES6 produced?

1 Answers
VonAlessandra
07/30/25 9:31am
The NIO ES6 is manufactured in Hefei, produced by the JAC factory. Below is additional information about the NIO ES6: 1. The NIO ES6 is a pure electric mid-size SUV with body dimensions of: length 4850mm, width 1965mm, height 1758mm, a wheelbase of 2900mm, and a curb weight of 2200kg. 2. The NIO ES6 uses a ternary lithium battery, with a total motor power of 320kW and a front motor maximum power of 160kW, paired with a fixed gear ratio transmission. 3. Its front suspension uses a double-wishbone independent suspension, and the rear suspension uses a multi-link independent suspension.
Was this review help?
11
2
Share
More Forum Discussions

What to Do When a Car Is Flooded?

Xiao Yu
1
4
Share

What are the solutions for brake failure?

Brake failure solutions are: 1. Use engine braking combined with the handbrake, first release the accelerator pedal, shift to manual mode and sequentially downshift from higher to lower gears; 2. Utilize terrain or emergency escape lanes, find suitable sections to decelerate, such as uphill roads or emergency escape lanes set up on highways or continuous downhill sections. Causes of brake failure include: 1. Severe overloading, which increases the vehicle's momentum under gravitational acceleration; 2. Improper operation, such as prolonged downhill driving causing brake pads to overheat, brake drums to carbonize, and brake function to completely fail.
8
3
Share

Reasons for Vehicle Vibration at Idle Speed

Reasons for vehicle vibration at idle speed: 1. Dirty throttle body; 2. Excessive carbon deposits inside the engine; 3. Faulty spark plugs or ignition coils; 4. Unstable oil pressure; 5. Aging engine mounts. Solutions for vehicle vibration at idle speed: 1. Clean the throttle body and remove engine carbon deposits in a timely manner; 2. Inspect spark plugs, high-voltage wires, and ignition coils; 3. Check oil pressure and replace damaged components if necessary. Methods for troubleshooting and resolving engine idle vibration issues: 1. Inspection of the idle speed control motor; 2. Inspection of the throttle position sensor; 3. Inspection of fuel injectors and crankshaft position sensor.
7
4
Share

What are the reasons for rapid consumption of car antifreeze?

The reasons for rapid consumption of car antifreeze are: 1. Radiator damage, poor sealing of upper and lower water chambers causing coolant leakage; 2. Overflow tank, water pump joint surface and loose connections in the cooling system pipelines leading to coolant leakage. Solutions for excessive antifreeze consumption: Regularly inspect all sealing points and connections, ensure proper tightening where needed, and never reuse leak-proof gaskets or tapes. The full name of antifreeze is antifreeze coolant, which prevents the coolant from freezing and cracking the radiator or damaging the engine cylinder block or head during cold winter parking.
10
0
Share

What Causes Fluctuating Car Engine Temperature?

Fluctuating engine temperature in a vehicle is usually caused by wiring faults or sensor abnormalities. Related fault descriptions are as follows: Introduction to wiring issues: Primarily involves grounding problems. Poor grounding, insufficient grounding points, or accidental grounding of wires can all lead to unstable engine temperature. First, check the vehicle's grounding points for firmness and signs of rust. Then inspect the instrument cluster's grounding points for looseness or corrosion. Reasons for fluctuating engine temperature: Sudden temperature fluctuations while driving may be caused by system failures, specifically sensor abnormalities. Sensor issues typically stem from quality defects or temporary malfunctions. In such cases, performing a battery reset for initialization can help determine if the fault persists.
6
4
Share

What is the reason for the sudden disappearance of the car dashboard speed display?

The reason is the damage to the vehicle speed sensor. Here are the relevant details: 1. Vehicle Speed Sensor: As the information source for the automotive electronic control system, it is a critical component of the system and one of the core research areas in automotive electronic technology. It detects the speed of electronically controlled vehicles, and the control computer uses this input signal to manage engine idle speed, torque converter lock-up in automatic transmissions, automatic transmission shifting, the opening and closing of the engine cooling fan, cruise control, and other functions. 2. Vehicle Speed: Vehicle speed refers to the distance a car travels per unit of time, commonly referred to as speed, with common units being kilometers per hour or meters per second.
1
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.