Where is the manufacturer of MyRoute tires located?

1 Answers
Maeve
07/25/25 1:57am
MyRoute tires are produced by their own manufacturer, which is located in Germany. Here is some information about tires: 1. Tires are one of the most important components of a car. The ability of a car to move is largely due to the performance of the tires. 2. Tires support the weight of the car body, bear the load of the car, reduce the impact force during driving, and maintain a certain level of handling stability while the car is in motion. 3. Currently, Michelin from France, Bridgestone from Japan, and Goodyear from the United States are known as the three giants of the world tire industry.
Was this review help?
14
2
Share
More Forum Discussions

Where is the windshield washer fluid located in the Audi A3?

The windshield washer fluid in the Audi A3 is located in the engine compartment. After opening the engine hood, you will find a blue cap, which indicates the windshield washer fluid reservoir. The capacity of the washer fluid tank is limited, so avoid overfilling it when adding fluid. There is a scale on the washer fluid filler neck to help you monitor the fluid level. Once you have finished adding the fluid, securely close the engine hood. The Audi A3 is a compact sedan from Audi, equipped with two engine options: a 1.4-liter turbocharged engine and a 2.0-liter turbocharged engine. The 1.4-liter turbocharged engine delivers a maximum power of 150 horsepower and a maximum torque of 250 Nm, while the 2.0-liter turbocharged engine produces a maximum power of 190 horsepower and a maximum torque of 320 Nm.
14
5
Share

Who is responsible if a pedestrian is hit while running a red light?

If a pedestrian is hit while running a red light, the pedestrian bears full or primary responsibility, while the motor vehicle driver is either not at fault or bears secondary responsibility. The specific compensation liabilities for the motor vehicle driver are as follows: 1. If the motor vehicle driver is not at fault when a pedestrian is hit while running a red light, they only need to bear no more than 10% of the compensation liability; 2. If the motor vehicle driver bears secondary responsibility when a pedestrian is hit while running a red light, they bear 10% to 30% of the compensation liability. According to relevant provisions of the Road Traffic Safety Law, in the event of a traffic accident between a motor vehicle and a non-motor vehicle driver or pedestrian, if there is evidence that the non-motor vehicle driver or pedestrian was at fault, the compensation liability of the motor vehicle driver may be appropriately reduced based on the degree of fault. If the motor vehicle driver is not at fault, they bear no more than 10% of the compensation liability.
2
2
Share

What are the penalties for driving with an expired license if caught by traffic police?

Driving with an expired license and being caught by traffic police will result in a fine and detention for up to 15 days. In cases of major traffic accidents causing casualties, criminal liability will be pursued according to the law. The Road Traffic Safety Law of the People's Republic of China stipulates that driving with an expired motor vehicle driver's license is considered unlicensed driving. The ten situations that constitute unlicensed driving are: 1. Not having a driver's license; 2. Illegally obtaining a driver's license without taking the test; 3. Driver's license being revoked or canceled; 4. Illegally obtaining a driver's license without meeting the driving conditions; 5. Driver's license has expired; 6. Driver's license is temporarily suspended; 7. Driving a civilian motor vehicle with a military or armed police force driver's license; 8. Driving in China with a foreign motor vehicle driver's license; 9. Driving a vehicle beyond the highest permitted vehicle type; 10. Not carrying the driver's license.
11
0
Share

What Does Interval Speed Measurement Mean?

Interval speed measurement refers to the setup of two adjacent monitoring points on the same road section. The average speed of a vehicle on that road section is calculated based on the time it takes for the vehicle to pass between the two monitoring points. The vehicle is then judged for speeding violations according to the speed limit standard on that road section. With traditional single-point speed measurement devices, drivers who are familiar with the locations of speed measurement points could avoid penalties by braking to reduce speed, which could easily lead to rear-end collisions. Interval speed measurement, by calculating the average speed, provides a more scientific and fair method to detect speeding violations. When a speeding violation is detected through interval speed measurement, the information of the violating vehicle is simultaneously displayed on LED screens in real-time to notify the violator and warn other vehicles.
19
2
Share

What are the steps to remove the speed limit on a new national standard electric vehicle?

New national standard electric vehicle speed limit removal steps are: 1. Without turning on the power, hold the brake lever, turn the throttle to the maximum, then turn on the power while still holding the brake lever and continuously rotate the throttle to its maximum limit; 2. Whether in full speed or limited speed mode, with the power off, hold the brake lever while turning the throttle to the maximum, then turn on the power switch, keeping the throttle at maximum and holding the brake for 3 to 5 seconds to enter full speed mode. The new national standard electric vehicle has a speed limit of 25 km/h, and a beeping sound will alert when the speed exceeds 15 km/h. Purchasing a new national standard electric vehicle allows for speed limit removal by replacing the controller.
4
1
Share

How to use ETC?

ETC usage method: 1. The ETC transaction sensing range is 8 meters. When encountering a stationary vehicle ahead, maintain a distance of over 10 meters to prevent automatic fee deduction for the preceding vehicle in case its ETC device malfunctions or is absent; 2. The ETC lane recognition speed limit is 20km/h - excessive speed will prevent successful vehicle device information reading. ETC (Electronic Toll Collection) is an automatic highway/bridge toll system that uses dedicated short-range communication between an onboard unit installed on the vehicle's windshield and roadside microwave antennas in toll station lanes. Through computer network technology and bank backend settlement processing, it enables vehicles to pass through highway/bridge toll stations without stopping while completing payment.
6
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.