Where is the manual maintenance light reset button located on the Lynk & Co 01?
2 Answers
The trip meter reset button on the combination instrument panel serves as the maintenance light reset button. Maintenance light reset procedure: First, turn off the engine and remove the key. Then, press and hold the right button below the instrument panel while inserting and turning the key to the ignition-on position. Once the ignition is on, release the right button - a small wrench icon will appear. After the wrench icon appears, press the left button below the instrument panel once to make the wrench icon disappear. Reason for maintenance light illumination: When the vehicle reaches a certain mileage, the onboard computer detects that maintenance is required and illuminates the warning light on the instrument panel. For optimal vehicle reliability, it's recommended to perform maintenance immediately when the maintenance reminder light comes on.
As a long-time owner of the Lynk & Co 01, I gotta say the maintenance light reset isn't about physical button location—it's an electronic procedure. Here's the quick rundown: First, turn off the engine but keep the ignition in the ON position (don't start the car). Then find the control button on the left side of the steering wheel, hold it for a few seconds until the dashboard screen pops up a menu. Use the directional buttons to select the maintenance reset option and confirm. The whole process takes about a minute or two, and the maintenance light will go off. Remember, this light comes on to remind you to change oil or get service—never just reset it without actual maintenance, or you'll risk engine wear, reduced lifespan, and poor fuel economy. DIY reset saves time and money (no dealership trip needed), but if you forget the steps, just check the owner's manual. Pro tip: Always verify maintenance is truly completed before resetting—safety first, folks.
