Where is the maintenance light reset button 5 for MG ZS?

[Danielle]

MG ZS does not have a manual maintenance light reset button. To reset the maintenance light, you need to visit a 4S shop and have a technician use a diagnostic computer to perform the reset. The relevant information about MG ZS is as follows: MG ZS is built on SAIC's SSA+SUV architecture platform, featuring the leading-in-class Banma Zhixing 3.0 system, equipped with the highest-level MGPILOT L2+ autonomous driving system in its class, and upgraded with the 260TGI twin-injection turbocharged engine paired with Aisin's latest generation 6AT powertrain, achieving the highest power-to-displacement ratio in its class at 125 horsepower. The new vehicle launch offers three powertrain options: 1.3T+6AT, 1.5L+CVT, and 1.5L+5MT, totaling seven models.

[VonAnderson]

Having driven the MG ZS for many years, I've memorized the maintenance light reset procedure. After turning off the car, there's no need to start the engine—just turn the key to the ON position to illuminate the dashboard lights. On the instrument panel, near the speedometer, there's a small button, usually the round one labeled 'trip reset.' Simply press and hold it for about 10 to 15 seconds, and you'll notice the maintenance light blink a few times before turning off, indicating the reset is complete. I perform this operation after every service—it's quick and hassle-free. However, be cautious: if you reset the light immediately after it comes on without performing maintenance, potential vehicle issues might be overlooked. The best practice is to change the oil and check the tires first before resetting. Button locations may vary slightly across different model years, so for first-time attempts, refer to the user manual's diagrams to avoid pressing the wrong button. The entire process should be done quietly in the garage—never attempt it while driving to prevent accidents.

[JasonDella]

The MG ZS maintenance light reset procedure is quite straightforward. After turning off the engine, rotate the ignition switch to the ON position without starting. Locate the trip reset button on the instrument cluster – it's usually near the left steering column stalk or in a corner of the dashboard. Press and hold for about 10 seconds until the light goes off, then release to complete the reset. The whole process is as simple as rebooting a phone, with no technical difficulty. Remember to clean your hands before operation to avoid grease stains. If the button doesn't respond or the light persists, it might be due to model variations – check the MG community for FAQs or use the official app for illustrated supplements. Develop regular maintenance habits, and you'll feel more at ease when the light stays off after reset.

[DelAnnie]

Maintenance light reset is crucial for safety, requiring strict adherence to MG ZS procedures. After parking and turning off the ignition, switch the key to the ON position without starting the engine. Locate the reset button on the instrument panel, typically a circular knob labeled "trip" or "reset"—its position varies slightly with dashboard design but remains easily identifiable. Press and hold firmly for 10-15 seconds until the light blinks and extinguishes before releasing. Always perform this operation with the vehicle stationary to avoid distracted driving. If unsure about the button's location, consult the user manual for illustrated guidance. After resetting, promptly verify if warning lights illuminate normally to prevent nighttime driving hazards. Remember to confirm completion of maintenance before resetting; otherwise, the reminder function will be disabled.