Where is the maintenance light reset button 5 for MG ZS?

1 Answers
LoganMarie
07/29/25 10:55pm
The maintenance light reset button 5 for MG ZS is located on the instrument panel. The first maintenance for MG ZS is at 3,000 kilometers, with maintenance intervals of 10,000 kilometers each. The three-guarantee validity period is 2 years or 50,000 kilometers, and the warranty period is 3 years or 100,000 kilometers. The following is an introduction to car maintenance: 1. Definition of car maintenance: Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. 2. Scope of car maintenance: Modern car maintenance mainly includes the maintenance of the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. 3. Purpose of car maintenance: The purpose of car maintenance is to keep the car clean, maintain normal technical conditions, eliminate hidden dangers to prevent failures, slow down the deterioration process, and extend the service life.
Was this review help?
12
3
Share
More Forum Discussions

What is the difference between high and low power versions of Volkswagen's 2.0T engine?

Volkswagen's 2.0T high and low power versions differ in that the low-power version achieves good fuel efficiency through a higher compression ratio, while the high-power version uses a lower compression ratio to enhance explosive power. 1. Different power outputs achieved through ECU control: Some automakers choose to achieve different power outputs through ECU control, with the most typical example being Volkswagen's 1.4T EA211. These engines are originally designed for high power, and reducing the pressure to lower the power output has no adverse effects. This is also what car owners understand as increasing or decreasing power through reprogramming. 2. Different power outputs achieved through different turbochargers: Some automakers do not change the engine's hardware structure but adjust the power output by using different turbochargers. A typical example is Volvo's 2.0T engine used in the XC90. The high-power T6 version adopts a twin-charging mode with both turbocharging and supercharging, while the two low-power versions, T5 and T4, use single turbocharging.
14
5
Share

How Many Kilometers Should 0W40 Engine Oil Be Replaced?

It is recommended to replace it every 5,000 kilometers or three months. The meaning of 0W40 engine oil: The 0W in 0W40 indicates the cold-start performance of the engine oil. Using engine oil with a lower value before the W makes it easier to start the engine in cold weather. Below is the relevant introduction: Engine oil replacement intervals for different cars: Mineral oil should be replaced every six months or 5,000 kilometers, semi-synthetic oil every six months or 7,500 kilometers, and full synthetic oil every six months or 10,000 kilometers. New cars should strictly follow the maintenance intervals specified in the manual to avoid serious damage. Precautions for changing engine oil in new cars: The amount of engine oil added should be appropriate, as indicated by the dipstick. After adding the engine oil, start the engine and check for any leaks in the components. After starting the engine, run it for 3 minutes and check the engine oil level again. When the oil level reaches the normal mark and there are no leaks, reset the maintenance light, and the oil change is complete.
11
3
Share

What are the differences between the new Sagitar R-Line and the regular Sagitar?

The differences between the Sagitar R-Line and the regular Sagitar include aspects such as powertrain and exterior design. Specific details are as follows: Powertrain: The regular Sagitar offers two powertrain options: 1.2T and 1.4T, available in both manual and automatic transmissions. The manual version comes with a 5-speed manual gearbox. The Sagitar R-Line, however, is exclusively equipped with a high-power 1.4T engine, paired with a 7-speed dual-clutch transmission. This powertrain delivers a maximum power of 150Ps and a peak torque of 250Nm, providing robust performance. Exterior Design: The Sagitar R-Line features a more sporty body kit, which includes exclusive front and rear bumpers, side skirts, a small rear spoiler, and dual five-spoke aluminum alloy wheels. Additionally, the blackened front and rear light clusters, exterior mirror housings, and the R-Line badge on the front grille highlight its distinctive identity compared to the regular Sagitar.
7
5
Share

How to Break in a New Car for Better Fuel Efficiency?

Warm up the engine when starting cold: It's necessary to warm up the engine during a cold start. After the vehicle has been parked, the engine components may not be fully lubricated. Proper warm-up helps the oil form a protective film between the engine parts and other components. Reduce abnormal engine wear during operation by maintaining reasonable driving speeds: Keeping a reasonable speed can help a car in the break-in period achieve better fuel efficiency. Generally, the most fuel-efficient speed for most cars is not very high, typically falling within the range of 65-90 km/h. To save fuel, try to keep the vehicle's speed within this range. Timely maintenance is crucial: New car maintenance is essential, especially for vehicles in the break-in period. Follow the manufacturer's recommendations in the owner's manual for timely oil changes and other maintenance tasks. Additionally, inspect the car's chassis regularly. Proper maintenance can help monitor daily fuel consumption. Avoid prolonged high-speed driving: Be cautious when driving a new car on highways for extended periods. Continuous high-speed driving can cause the engine to operate under high load for too long, potentially leading to increased component wear, which is not conducive to the car's break-in process.
3
1
Share

How to Escape When a Car Falls into Water?

When a car falls into water, it is crucial to stay calm and find a way to escape as quickly as possible. Below is a detailed guide on how to escape from a submerged car: 1. Opening the Door to Escape: If the car has just fallen into the water, occupants must remain calm and immediately unfasten their seatbelts and open the doors, as this is the safest and quickest way to escape. Activate the electronic central locking system immediately to prevent door lock failure. When the water level is around 30 cm, the doors can still be opened. However, when the water reaches about 60 cm, the doors will no longer open. If the water levels inside and outside the car are equal, the doors can be opened. Therefore, if the initial escape opportunity is missed, use the precious time before the cabin is completely submerged to let water in. Once the water levels inside and outside are equal and the pressure balances, quickly open the door to escape. 2. Breaking the Window to Escape: If the doors are not opened in time, as water floods the car, the electrical system may fail, making it impossible to open the doors or windows. In this case, use a sharp object inside the car to break the window. The best tool for this is a safety hammer. When using the safety hammer, aim for the window that is still above water, typically the side or rear window. Strike the edges or corners of the window glass, not the center. If no safety hammer is available, use other sharp objects like the metal rods of a car headrest, high heels, or an umbrella to break the window. 3. Escaping Through the Trunk: Since most cars are front-heavy, the front will sink first, causing the rear to tilt upward. Use this time before the rear is submerged to climb into the back seat. Fold down the rear seat backrest, locate the trunk lock cover, and pry it open with a key or another hard object. Turn the white lock cylinder clockwise to pop open the trunk (methods may vary by car model). Once outside the car, keep your face upward, follow the bubbles to the surface, and try to grab onto floating objects while swimming to the surface for help.
18
3
Share

How is the purchase tax on imported vehicles collected?

The calculation method for the purchase tax on imported vehicles is as follows: Taxable price = Customs duty-paid price + Customs duty + Consumption tax, Tax payable = Taxable price × 10%. Below is a detailed explanation regarding the purchase tax on imported vehicles: 1. Legal basis: The "Administrative Measures for the Collection of Vehicle Purchase Tax" came into effect on January 1, 2006, setting the vehicle purchase tax rate at 10%. This is the same as the tax rate currently collected by the traffic management authorities. The new "Measures" will replace the original "Interim Regulations on Vehicle Purchase Tax". The vehicle purchase tax is levied once, and vehicles that have already been taxed will not be subject to additional taxes before scrapping or during resale. 2. Role of vehicle purchase tax: Vehicle purchase tax plays an important role in national revenue, serving functions such as reasonably raising construction funds, standardizing government actions, and adjusting income disparities.
10
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.