Where is the Locator Placed in a Car?

1 Answers
GideonMarie
07/30/25 9:14am
The locator is placed in a concealed location under the decorative panel of the car's front windshield or around the dashboard. Key points for installing a car locator: 1. To prevent theft and damage, the device should be placed in a hidden location as much as possible; 2. Avoid placing it near emission sources, such as wireless backup radars, anti-theft devices, and other in-car communication equipment; 3. It can be secured using zip ties or Velcro. A locator, also known as a GPS positioning system, is used for vehicle tracking. With GPS and electronic maps, it can display the vehicle's real-time location, zoom in or out as needed, follow moving targets to keep them on the screen, and enable multi-window, multi-vehicle, and multi-screen tracking simultaneously.
Was this review help?
13
2
Share
More Forum Discussions

Why is the cold air from a diesel car's air conditioner not cold?

The reasons why the cold air from a diesel car's air conditioner is not cold are as follows: 1. Too much refrigerant: This leads to a decrease in cooling efficiency. 2. Too little refrigerant: Insufficient refrigerant causes the condenser to become dirty, and a loose compressor drive belt can also result in the air conditioner not cooling properly. 3. Excessive impurities: If there are too many impurities in the refrigerant and the refrigeration oil, minor blockages can occur, leading to insufficient cooling capacity. If there is excessive dirt in the refrigerant and refrigeration oil throughout the entire air conditioning system, it will inevitably clog the filter screen of the filter, reducing the cooling passage capacity and increasing resistance. This also means less refrigerant flows to the expansion valve, resulting in insufficient cooling capacity.
20
0
Share

In Subject 4, does the left yield to the right or the right yield to the left?

Right-turning vehicles yield to left-turning vehicles. Below are some rules regarding vehicle yielding: 1. When both vehicles are going straight, yield to the right: At an intersection where both vehicles intend to proceed straight without traffic signals, simultaneous straight movement is highly dangerous. Thus, the 'yield to the right' principle is established, requiring the vehicle to yield to the right-side vehicle going straight. This rule applies not only at intersections but also when vehicles from both sides merge into the same lane, where the right-side vehicle should be allowed to change lanes first. 2. Right-turning vehicles yield to straight-going vehicles: To ensure traffic efficiency, right-turning vehicles must yield to straight-going vehicles. At intersections without traffic signals, both left-turning and right-turning vehicles must yield to straight-going vehicles.
19
0
Share

How to Take Out a Car Spare Tire?

Here is the introduction on how to take out a car spare tire: 1. Hidden spare tire: (1) Lift the trunk floor. (2) Unscrew the fixing device. (3) Take out the spare tire. 2. Rear-mounted spare tire: (1) Open the anti-theft lock. (2) Rotate and remove the protective cover. (3) Use a socket or wrench to unscrew the fixing nuts. (4) Take out the spare tire. 3. Undercarriage-mounted spare tire: (1) Remove the dust cover to see a screw. (2) Connect the screw socket to the screw port. (3) Rotate the screw socket counterclockwise, and the spare tire will slowly descend under the traction of the steel cable (or chain). (4) Pull down the steel cable (or chain), then remove the clip below.
5
3
Share

What to Do When the Car Tail Light is Cracked?

If the car tail light is broken, it needs to be replaced immediately. The replacement steps are as follows: 1. Disconnect the power: For safety, always disconnect the power first. Open the car's trunk lid and cut off the vehicle's power to ensure no electrical operation afterward. 2. Remove the dust cover on the back of the tail light: This is a necessary step for tail light replacement. Remove the dust cover to facilitate the replacement process. 3. Perform the replacement: Before replacing the tail light, identify the specific light that needs to be replaced. Press and hold the rotating handle at the back of the light and unscrew it. Then, install the new light, paying attention to the model and color. 4. Reinstall the tail light and dust cover: After installing the new tail light, reattach the dust cover.
14
5
Share

What Causes Water Leakage Under the Co-Driver Seat in a Car?

Water leakage under the co-driver seat in a car is likely caused by a door leak. Below are related explanations regarding water leakage under the co-driver seat: Solutions: If you hear obvious water sloshing sounds when opening/closing the door or while driving, it indicates water accumulation inside the door. In this case, simply use a thin wire or small screwdriver to unclog the drainage holes—this can be easily done yourself. Detailed scenarios of leakage: If the window regulator has been replaced, it may be due to improper adhesion of the door waterproof membrane after the replacement, as the membrane needs to be peeled off during the regulator replacement process. If the waterproof membrane is not properly sealed, heavy rain can cause water to enter the cabin. You can either reseal it yourself or replace the waterproof membrane.
19
3
Share

What are the manifestations of mild fatigue in Subject 4?

Manifestations of mild fatigue in Subject 4: Frequent yawning and heavy eyelids. Below are detailed introductions about Subject 4: 1. Examination Subjects: The subjects of the driver's license test are uniformly set nationwide, divided into four subjects: theoretical knowledge, field driving skills, road driving skills, and civilized driving-related knowledge. Subject 4, also known as the Subject 4 theoretical test or driver's theoretical test, is part of the motor vehicle driver's license assessment. 2. Meaning: After the implementation of the Ministry of Public Security's Order No. 123, the Subject 3 test was divided into two parts, adding a safety and civilized driving knowledge test besides the road test. 3. Test Composition: The test paper consists of 50 questions, mainly in the form of cases, pictures, animations, etc., with a full score of 100 points, and a passing score of 90.
5
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.