Where is the location of the daytime running light switch on the new Tiida?

1 Answers
VonLucille
07/29/25 8:08pm
The daytime running light switch on the new Tiida is located near the fog lights. Below is a detailed introduction about car lights: 1. Headlights: The main purpose of headlights is to illuminate the road and objects ahead of the vehicle to ensure driving safety. The high beam and low beam can be alternately used as a signal for overtaking at night. Headlights are installed on both sides of the front of the car, with 2 or 4 units per vehicle. The bulb power is 45-60W for high beam and 25-55W for low beam. 2. Fog lights: Fog lights are installed near the headlights or slightly lower than the headlights. In conditions of low visibility such as fog, snow, heavy rain, or dust, fog lights serve to illuminate the road and provide signals for oncoming vehicles. The light is mostly yellow. Yellow light has longer wavelengths and good fog penetration performance. The bulb power is generally 35W.
Was this review help?
2
2
Share
More Forum Discussions

How to Adjust the Rearview Mirror on the New Sagitar?

The method to adjust the rearview mirror on the new Sagitar is as follows: 1. Rotate the button to the L position, then move the button up, down, left, or right to adjust the angle of the left mirror; 2. Rotate the button to the R position, then move the button up, down, left, or right to adjust the angle of the right mirror; 3. After adjusting to the desired position, rotate the button to the middle to close the adjustment. The new Sagitar is a brand under FAW-Volkswagen, with body dimensions of 4753mm in length, 1800mm in width, and 1462mm in height. In terms of appearance, the two waistlines on the side of the new Sagitar are the highlights, adding a sense of toughness and making it look neat, with a good visual effect.
4
4
Share

How to Turn on the Fog Lights of the Volkswagen New Santana?

To turn on the fog lights of the Volkswagen New Santana: 1. Pull the knob out one notch to activate the front fog lights; 2. Pull the knob out another notch to also activate the rear fog lights. The Volkswagen New Santana's fog lights are installed at the front and rear of the vehicle, designed to illuminate the road and provide safety warnings during rainy or foggy conditions, thereby improving visibility for the driver and surrounding traffic participants. The Volkswagen New Santana is a sedan with body dimensions of 4546 mm in length, 1710 mm in width, and 1427 mm in height. In terms of exterior design, the front fascia of the New Santana features noticeable changes, with a wider and more substantial grille, retaining the classic Volkswagen V-shaped smile. The headlight system employs circular projector lamps, which enhance nighttime illumination and safety.
14
5
Share

How to open the fuel tank cap of the Envision?

The method to open the fuel tank cap of the Envision is to press the fuel tank cap to open it. The fuel tank cap is divided into an inner cap and an outer cap, with the outer cap mostly being electronically controlled or cable-operated for opening. The electronic control button or cable-operated lever is usually located on either side of the driver's seat, marked with a fuel pump icon. Simply pressing or pulling it will automatically open the fuel tank door. The Envision is a mid-size SUV with body dimensions of 4686mm in length, 1839mm in width, and 1691mm in height. In terms of power, the Envision offers a choice between a 1.5-liter turbocharged engine and a 2.0-liter turbocharged engine.
12
5
Share

What are the width, height, and length of the BMW X5?

The BMW X5 has a width of 1933mm, a height of 1776mm, and a length of 4857mm, with a wheelbase of 2975mm. It is a four-wheel-drive SUV model. The BMW X5 is equipped with 2.0T and 3.0T turbocharged engines. The 2.0T turbocharged engine has a maximum power of 195kw and a maximum torque of 400nm. The 3.0T turbocharged engine has a maximum power of 250kw and a maximum torque of 450nm. In terms of transmission, both models of the BMW X5 are matched with an 8-speed automatic transmission. For the interior, apart from the driving dashboard, the entire console appears lower, enhancing the brightness of the cabin space. The central LCD display has been replaced with a large screen featuring a thin, independent design.
8
0
Share

How to reset the tire pressure warning light on Haval H2s?

To reset the tire pressure warning light on Haval H2s: 1. Turn on the ignition, press the CLR button on the right side of the driver information center display; 2. Use the up/down arrows on the INFO button to navigate to the DIC menu; 3. Hold the CLR button until the percentage changes to 100%, and the oil life indicator will be reset. The Haval H2s is a compact SUV with body dimensions of 4146mm (length) × 1772mm (width) × 1638mm (height). In terms of power, the Haval H2s is equipped with a 1.5T engine, paired with either a 6-speed manual or 7-speed dual-clutch transmission.
4
4
Share

How to Remove the License Plate Light?

The method to remove the license plate light is to pull apart the plastic clips on both sides of the light cover. Alternatively, you can use a flathead screwdriver to pry open the clips. According to relevant regulations, all vehicles must turn on the license plate light at the rear when driving at night. The brightness of the rear license plate light must be sufficient for a person with normal vision to clearly read the license plate number from a distance of 20 meters at night. It is required that the license plate light must be controlled by the same switch as the parking lights. For example, LED bulbs are usually slightly taller than the original bulbs, and the side of the light cover with the 3C certification mark should face downward. The license plate light is turned on together with the width indicator lights during nighttime or low-light conditions to illuminate the license plate.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.