Where is the license plate number Lu K from?

What do the three wires of the rear wiper motor mean?

It means one is the positive power supply, one is the ground, and the other is the wiper positioning signal. The functions of the three wires in the wiper motor rotor: One is the common terminal A, the one with a small resistance to A is the high-speed terminal B, and the one with a large resistance to A is the low-speed terminal C. Usually, the resistance between B and C is the smallest (or sometimes the largest). The other two are the return identification wires, which internally act as a switch (in the form of a slider or camshaft) and only disconnect when the wiper blade reaches the lowest point. Measurement method for the three wires of the wiper motor: One is the positive wire, one is the ground wire, and the other is the signal wire. Measure the resistance against the motor casing respectively. The highest resistance indicates slow speed, the lowest indicates fast speed, and the other indicates medium speed. No resistance or infinite resistance indicates a fault.

2

5

Share

Is it illegal to change the color of car lights?

Arbitrarily changing the color of car lights is illegal. Car light brightness regulations: The high and low beam angles of car lights must comply with standards; the low beam position: when the headlights are projected on a screen 10 meters away, the horizontal deviation of the low beam to the left should be ≤170mm, and to the right should be ≤350mm. Car light brightness adjustment: To increase the brightness of headlights, replace the bulbs with higher-power ones and modify the circuit; after modifying the original headlight circuit to serve as a switch circuit, the vehicle's headlights can be replaced with 90/100W halogen bulbs, significantly improving brightness and nighttime driving safety.

10

0

Share

When Will New Energy Vehicles Be Fully Implemented?

2008 marked the beginning of the comprehensive implementation of new energy vehicles in China. Advantages of new energy vehicles: New energy vehicles are more environmentally friendly; they are not subject to traffic restrictions based on license plate numbers; they offer safer and more stable driving. Significance of developing new energy: It can effectively address environmental pollution issues; new energy serves as the cornerstone of future energy for human society, being abundant, widely distributed, renewable, and non-polluting; new energy is clean, with minimal pollutant emissions, harmonizing with the ecological environment of Earth, which is essential for human survival. Adopting new energy is a major measure to protect the ecological environment and pursue sustainable socio-economic development.

15

2

Share

Are Chaoyang Tires Symmetrical Tread?

Chaoyang tires come in both symmetrical and asymmetrical tread patterns. Function of symmetrical tread on tires: The tread pattern is usually a continuous rib design or tread block, with the same appearance on both the inner and outer tread surfaces. The tires typically feature a "wave-type" pattern. If all four tires are of the same size, symmetrical tread tires can be rotated by directly swapping the drive wheels to non-drive wheels, and crossing the non-drive wheels to the drive wheels. Function of asymmetrical tread on tires: Asymmetrical tread tires have unique patterns on each side of the tread. The outer tread usually has numerous grooves to enhance water drainage and wet road handling, while the inner tread has fewer grooves to improve grip. Asymmetrical tread tires have inner and outer side markings on the tire sidewall.

17

0

Share

What is the size of the rear wheel axle nut for a motorcycle?

The size of the rear wheel axle nut for a motorcycle is 50-80 N.m. Functions of motorcycle engine oil: Mainly includes lubrication, cleaning, heat dissipation, anti-corrosion, wear resistance, and shock absorption. Motorcycle rear wheel assembly structure: Includes the rear wheel axle and two parallel swingarm tubes, with adjustment holes on the swingarm tubes for fixing the rear wheel axle. It also includes a chain adjustment device, which consists of a connecting piece inside the swingarm tube for connecting the rear wheel axle and a driving piece for moving the connecting piece along the length of the swingarm tube. The connecting piece has an axle hole for fixing the rear wheel axle, and a protective sleeve is placed between the rear wheel axle and the axle hole to support the rear wheel axle.

4

Share

What Causes the Steering Wheel to be Sometimes Light and Sometimes Heavy?

Generally, it is caused by leakage of the seal responsible for sealing one side of the high-pressure chamber. Another possibility is improper adjustment of the directional limit valve. Correct way to hold the steering wheel: Keep your eyes looking straight ahead. Gently hold the upper left side of the steering wheel with your left hand, and lightly grip the upper part with your right hand, keeping both hands relaxed and naturally hanging down. At this time, the thumbs of both hands should naturally point straight to the upper part of the steering wheel, while the other four fingers should lightly grip from the outside inward. Correct way to turn the steering wheel: Imagine the steering wheel as a clock. When your left hand reaches the 3 o'clock position and your right hand is at the 9 o'clock position, release your right hand. Continue turning with your left hand until it reaches the 6 o'clock position, then have your right hand grasp the 12 o'clock position. Continue turning until reaching the 3 o'clock position, completing one full turn.

20

1

Share

Where is the license plate number Lu K from?

What do the three wires of the rear wiper motor mean?

Is it illegal to change the color of car lights?

When Will New Energy Vehicles Be Fully Implemented?

Are Chaoyang Tires Symmetrical Tread?

What is the size of the rear wheel axle nut for a motorcycle?

What Causes the Steering Wheel to be Sometimes Light and Sometimes Heavy?

Is it necessary to change summer tires in winter?

What brand is the helmet with three vertical bars?

What is the recommended speed for a new car's first drive?

What Causes the Rattling Noise When Accelerating or Releasing the Throttle in a Passat?