Where is the Jetour Production Plant Located?

How to Eliminate the Engine Malfunction Light on a Focus?

When the engine malfunction light is on, you can follow these steps: First, check whether the engine is running normally and if there are issues such as shaking or black smoke. If so, avoid restarting the engine. Particularly, do not restart if the red light is on. If the engine can start, turn it off for 5-10 minutes. Then, without pressing the brake, press the start button once or turn the key halfway to the 'on' position without depressing the clutch. The car will perform a self-check after powering on. Wait for 5-10 seconds and observe whether the malfunction light on the dashboard turns off. If the light remains on, visit a service station as soon as possible to diagnose the issue. The service station can use a portable diagnostic tool to read the fault code, identify the problem, and perform targeted repairs. There are seven main reasons why the engine malfunction light may illuminate: 1. Sensor failure: This includes sensors such as coolant temperature, crankshaft position, air flow, intake temperature, and oxygen sensors. If these sensors are damaged, have poor contact, or interrupted signals, the car's ECU cannot accurately obtain engine data, triggering the malfunction light. 2. Fuel or oil quality issues: If fuel or engine oil not meeting the manufacturer's specifications is used, it may cause engine wear and trigger the malfunction light. 3. Poor combustion of the air-fuel mixture: This can lead to engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the malfunction light will illuminate as a warning. Causes include faulty spark plugs, ignition coils, fuel pumps, or clogged fuel lines. 4. Turbocharging issues: Problems with the intake boost pipes or turbocharger can also trigger the malfunction light. The most common issue is turbocharger damage, often accompanied by oil leaks, high oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. 5. Intake problems: Clogged engine intake pipes can lead to serious issues, including the malfunction light turning on. A dirty or uncleaned air filter can cause intake problems. 6. Exhaust problems: Exhaust system faults, such as rear oxygen sensor failure, catalytic converter issues, or exhaust camshaft and bearing problems, can trigger the malfunction light. The catalytic converter is the most common culprit, often due to leaded gasoline, improper lubricant additives, physical damage, or fuel system faults. 7. Anti-theft system failure: If the car's electronic anti-theft system malfunctions or the anti-theft controller is incompatible with the engine ECU, the engine may not operate correctly, and the malfunction light will illuminate.

17

0

Share

What is the minimum ground clearance of the Envision S?

The minimum ground clearance of the Envision S is 190mm. The minimum ground clearance of the Envision S refers to the distance between the lowest point (excluding the wheels) and the supporting plane, which indicates the vehicle's ability to pass over obstacles such as rocks and tree stumps without collision. A higher ground clearance for the Envision S improves off-road capability, but if the ground clearance is too high, the stability at high speeds may decrease. The Chinese name for the Buick ENVISION is 'Angkewei' (Envision), which is a midsize SUV. The Envision S has a wheelbase of 2779mm, with length, width, and height dimensions of 4662mm, 1883mm, and 1631mm, respectively. Generally, the ground clearance for sedans ranges between 110mm and 150mm, while SUVs typically have a ground clearance between 200mm and 250mm. However, the ground clearance of the Envision S is not static; it also depends on the load condition. Therefore, changes in ground clearance should be considered based on variations in the Envision S's load. When selecting a vehicle, ground clearance can be one of the reference factors. The choice should depend on the vehicle's intended use and the road conditions. For well-paved urban roads, a vehicle with lower ground clearance may be preferred for increased stability and comfort. For frequent travel to remote areas or driving on poor road conditions, a vehicle with higher ground clearance may be chosen to enhance off-road performance and avoid undercarriage scrapes or damage.

2

4

Share

What is the normal starting voltage for a car?

The normal starting voltage for a car should not be lower than 12.1V. Under normal circumstances, the battery voltage before starting the car ranges between 11.8V and 12.8V, while the battery voltage after starting ranges between 13.2V and 14.8V. When the car's engine is not running, the battery voltage should be between 12.2V and 12.8V. If it drops below 11.6V, starting the car becomes difficult, and it is advisable to turn off other electrical appliances. When the battery voltage falls below 10V, the car generally cannot be started. During the use of a car battery, it is essential to keep the battery clean and dry while ensuring the vent holes remain unobstructed. Avoid continuous use of the starter; each attempt should not exceed 5 seconds, with a 10 to 15-second rest between attempts. A battery filled with electrolyte should not be left in a state of insufficient charge for extended periods and must be charged regularly to prevent damage. The electrolyte level should be 10 to 15mm above the plates; if the level is too low, add distilled water promptly, not additional electrolyte.

19

5

Share

What to Do When the Volkswagen Car Key Cannot Be Pulled Out?

Solutions for when the Volkswagen car key cannot be pulled out: 1. Key cannot be pulled out after turning off the engine: The gear is not fully returned to the P position. Check if there are any obstructions in the gear slot, remove them, start the car, and move the gear again to ensure it is fully returned. 2. Key cannot be turned after insertion: This is actually the car's steering wheel automatic lock function. While gently turning the key with your right hand, wiggle the steering wheel left and right with your left hand, and the key can then be turned. The Volkswagen T-Cross is a compact SUV under SAIC Volkswagen. Taking the T-Cross 2021 280TSI DSG Comfort Edition as an example, its dimensions are 4218mm in length, 1760mm in width, and 1599mm in height, with a wheelbase of 2651mm, and the body adopts a 5-door, 5-seat structure.

16

5

Share

Is the 2021 Levin a Three-Cylinder or Four-Cylinder?

The 2021 Levin equipped with a 1.5L naturally aspirated engine is a three-cylinder, while those with a 1.2L turbocharged or 1.8L naturally aspirated engine are four-cylinders. The Levin is a compact car under GAC Toyota. Taking the 2021 Levin 185T CVT Luxury Edition as an example, its dimensions are 4640mm in length, 1780mm in width, and 1455mm in height, with a wheelbase of 2700mm. The body adopts a 4-door, 5-seat sedan structure. In terms of power, the 2021 Levin 185T CVT Luxury Edition is equipped with a 1.2L naturally aspirated engine with an aluminum alloy block, delivering a maximum power of 85kW and a maximum torque of 185Nm, paired with a 10-speed continuously variable transmission.

12

4

Share

What are the conditions when P0507 idle control speed exceeds the specified value?

P0507 idle control speed exceeds the specified value conditions: When the vehicle starts in warm condition, it first starts with high idle speed at around 1000 rpm, then the speed drops to 720 rpm, and finally the idle speed rises to 800 rpm and stabilizes at this idle speed. Inspect the intake system and confirm that the carbon canister solenoid valve N80 and exhaust gas pressure regulating valve are damaged. After replacement, the engine flow meter value returns to normal. The increase in idle speed means that to optimize the power supply of the electrical system and the charging condition of the battery, the battery management system can request the engine control unit to increase the engine speed to meet the current state demand.

16

3

Share

Where is the Jetour Production Plant Located?

How to Eliminate the Engine Malfunction Light on a Focus?

What is the minimum ground clearance of the Envision S?

What is the normal starting voltage for a car?

What to Do When the Volkswagen Car Key Cannot Be Pulled Out?

Is the 2021 Levin a Three-Cylinder or Four-Cylinder?

What are the conditions when P0507 idle control speed exceeds the specified value?

What is the reason for the Audi A6L cigarette lighter not working?

Where is the battery located in the Fujian Mercedes-Benz V260?

Does Auto Start-Stop Damage the Car?

How to reset the maintenance light on Changan CS75 Plus?