Where is the instrument light fuse located on the Tiggo 3?

2 Answers
Kenny
07/29/25 1:22am
The instrument light fuse of the Tiggo 3 is located above the driver's legs, beneath the dashboard, inside the U-shaped covers on both sides of the steering column. Common instrument lights in vehicles include: ABS indicator, EPC indicator, seatbelt indicator, battery indicator, oil pressure indicator, fuel level indicator, coolant temperature indicator, engine indicator, parking brake indicator, high beam indicator, turn signal indicator, front/rear fog light indicators, and vehicle malfunction indicator. Taking the 2020 Tiggo 3 as an example, it is a compact SUV with dimensions: length 4420mm, width 1760mm, height 1670mm, wheelbase 2510mm, minimum ground clearance 190mm, and curb weight 1358kg.
Was this review help?
4
0
Share
HopeLee
08/12/25 5:30am
As a Tiggo 3 owner, I remember the instrument light fuse is usually located in the cabin fuse box, near the area below the steering wheel or behind the left dashboard panel. When opening the fuse box cover, there's typically a labeled diagram inside - look for positions marked "Instrument" or "Indicator Light". In most models, the fuse numbers fall within Zone B or the F5 to F10 range. If the fuse blows, the instrument lights won't function, compromising nighttime driving safety. My advice is to first check the vehicle manual for the exact location rather than guessing to save time, then purchase a matching 10A fuse for DIY replacement - the operation takes just minutes. Occasionally inspecting fuse conditions during routine maintenance can prevent unexpected failures. After all, illuminated dashboard is crucial for clearly reading speed, fuel consumption and other vital information.
Was this review help?
7
3
Share
Expand All
More Forum Discussions

Does the Lynk & Co vehicle automatically lock when the driver leaves?

Lynk & Co vehicles do not automatically lock when the driver leaves. Here are specific details about Lynk & Co: 1. Introduction: Lynk & Co is a high-end luxury brand under Geely, jointly established by Geely and Volvo. Its models include 01, 02, 03, and 05. 2. Lynk & Co 05: The 05 is a compact crossover SUV, equipped with a 2.0-liter turbocharged engine across all variants. The 2.0-liter turbocharged engine in the Lynk & Co 05 delivers a maximum power of 187 kW and a maximum torque of 350 Nm, with the engine's peak power achieved at 5500 rpm and peak torque available between 1800 to 4800 rpm.
2
2
Share

Where is the Elantra alternator fuse located?

Elantra has two fuse boxes. Here is more information: 1. Location of Elantra fuse boxes. One is located in the engine compartment. Open the hood, and you can see a black plastic square box on the left side of the engine, i.e., the driver's side; the other is located under the storage compartment on the left side of the steering wheel in the driver's cabin. 2. Function of car fuses. Car fuses are a type of current fuse. When the circuit current exceeds twice the rated current of the fuse, it will blow within seconds to protect the circuit. 3. Size of car fuse boxes. Car fuse boxes can be divided into small car fuse boxes, medium car fuse boxes, and large car fuse boxes based on the size of the fuses they accommodate. When selecting a car fuse box, factors such as the current rating of the car fuse and the size requirements of the fuse should be considered to choose the appropriate fuse box.
9
4
Share

Can You Drive in Thick or Medium Heels?

Driving in thick or medium heels is not recommended, as these types of shoes can directly affect the driver's ability to operate the vehicle, potentially leading to safety incidents. Here are some important considerations for safe driving: 1. Cold Engine Warm-up: Proper warm-up helps form an oil film between engine components, reducing wear and tear. 2. Timely Gear Shifting: When driving a manual transmission vehicle during the break-in period, shift gears promptly and appropriately. Avoid incorrect behaviors like high gear with low RPM or low gear with high RPM, and refrain from using a single gear for extended periods. 3. Regular Maintenance: Follow the manufacturer's recommendations in the vehicle manual. Perform timely inspections and maintenance, including oil and oil filter changes, as well as a comprehensive check of the chassis system after reaching certain mileage or time intervals. 4. Avoid Emergency Braking: Emergency braking not only shocks the braking system during the break-in period but also increases the impact load on the vehicle's chassis and engine.
15
4
Share

Can I Bring My Phone into the Car During the Driving Test (Subject 3)?

Yes. You can bring your phone during Subject 3 of the driving test, but it's recommended to turn it off to avoid distractions. Here are some related tips for Subject 3: 1. Starting details: Walk counterclockwise around the vehicle from the driver's door, return to the driver's door, enter the car, adjust the seat and fasten the seat belt, lightly press the accelerator to check if the dashboard is functioning normally. 2. Lightly pressing the accelerator: Turn on the left turn signal and observe the road conditions behind the vehicle; shift to 1st gear, slowly release the clutch to start the vehicle, lightly press the accelerator to increase speed, and shift gears up or down based on road conditions to ensure timely and unobstructed driving. 4. Using the brake: To control speed, remember to release the accelerator and lightly press the brake to solve the problem. First, it's about getting familiar with the vehicle and building confidence. Second, it's about knowledge and ability to handle road conditions calmly and effectively. 5. Smooth driving techniques: During gear shifting, to ensure smooth driving, after pressing the accelerator to increase speed, the right foot should only touch the accelerator, then press the clutch and shift gears sequentially without skipping gears.
17
1
Share

What causes the jerking sensation when driving the Qashqai?

The reasons for the jerking sensation when driving the Qashqai are as follows: 1. Severe wear: The friction plates inside the transmission are severely worn, with uneven surfaces, causing jerking during contact. 2. Worn plungers: The plungers inside the valve body are severely worn, leading to poor operation of the plungers within the valve body. 3. Uneven road surface: Generally, when driving on uneven roads, the vehicle will experience a jerking sensation. Relevant information about the Qashqai is as follows: 1. Qashqai: It is the first product developed by Nissan's European Design Center, positioned between a compact SUV and a hatchback. 2. Body dimensions: The length, width, and height are 4315/1783/1606mm respectively, with a wheelbase of 2630mm.
10
3
Share

Can I have my car inspected in another location? Do I need to go in person?

You can have your car inspected in another location, and it is not necessary for you to go in person for the annual inspection. Below is the relevant information about cross-regional vehicle inspection: 1. Required documents: Original ID card; Vehicle registration certificate; Copy of compulsory traffic insurance; Proof of vehicle and vessel tax; Authorization letter for cross-regional vehicle inspection. 2. Authorized annual inspection: You can personally bring the documents to apply and then return; Alternatively, you can authorize a local friend or relative to handle the authorization letter on your behalf. However, the vehicle owner needs to provide the authorized person with a power of attorney. The authorized person must bring their own ID card, the power of attorney, the owner's original ID card, vehicle registration certificate, copy of compulsory traffic insurance, and proof of vehicle and vessel tax to proceed with the inspection on your behalf. After the inspection is completed, these documents must be mailed back to the vehicle owner for the annual inspection.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.