Where is the ignition device located in the Classic Sylphy?

2 Answers
LeGarrett
09/06/25 6:32am
Classic Sylphy ignition device is located on the engine cylinder head. The ignition device refers to a device that can instantly provide sufficient energy to ignite pulverized coal, oil (gas) fuel and stabilize the flame. The automotive ignition device is a system for starting the vehicle's engine. The ignition device mainly consists of power supply, ignition coil, distributor, ignition switch, spark plug, additional resistance and its short-circuit device, high and low voltage wires, etc. Additional information: The causes of ignition device failure are as follows: 1. The car experiences sudden engine shutdown when using the ignition device, without obvious regularity, and the fault is eliminated after replacing the platinum. This is generally caused by poor contact in the ignition device circuit, broken wires grounding, etc.; 2. The car experiences unstable engine shutdown and other phenomena after driving for a long time, and returns to normal after cooling for a while. This does not occur with platinum, generally indicating that the ignition device chip has a high-speed misfire phenomenon, and the ignition device needs to be replaced; 3. The car operates normally before the ignition device is installed, but after installation and debugging, the idle speed is unstable during startup, the engine shakes severely when accelerating, and sometimes is accompanied by phenomena such as exhaust pipe backfire. If there is no improvement after adjusting the ignition angle, it is generally caused by the sensor's red and black wires being connected in reverse; 4. The car is difficult to start when using the ignition device in cold weather, which is generally caused by excessive sensor gap. If the gap is normal, observe whether the starter motor can rotate normally during startup. If the speed is too slow, it may be due to motor sweeping, battery depletion, or poor grounding of the ground wire.
Was this review help?
18
2
Share
OCarson
09/18/25 6:13am
I usually commute in a classic Nissan Sylphy, and the cigarette lighter socket is in a particularly easy-to-find position. It's located at the bottom of the center console, right in front of the gear lever on the driver's right side—a square socket with a spring-loaded cover. You can operate it blindly with your right hand while driving without any issues, and plugging a charging cable here won't obstruct your view. I remember the two front cup holders are right next to it, so placing a cup of coffee there doesn’t interfere with operation. Last time, my friend spent ages looking for it in my car, but the design is actually quite user-friendly—it's about ten centimeters from the gear lever, and a quick glance downward will spot it immediately.
Was this review help?
2
3
Share
Expand All
More Forum Discussions

How Long Can a Tesla Drive After Running Out of Battery?

Tesla can still cruise at 99km/h on the highway for about 16 kilometers after running out of battery, and then crawl forward at a low speed of 40km/h for another 6 kilometers. Additional information about Tesla is as follows: 1. Electric Vehicles: Tesla is committed to accelerating the world's transition to sustainable energy through electric vehicles, solar products, and integrated renewable energy solutions for homes and businesses. 2. Advantages: For daily driving, simply charge at home overnight for a full battery the next day. For long-distance driving, you can recharge at public charging stations or the Tesla charging network. With over 25,000 Superchargers globally, an average of 6 new stations are built each week.
3
5
Share

How to adjust the timing on an older Mercedes-Benz E350?

Disconnect the battery ground cable, remove the ignition coils, and remove the spark plugs. Pull in the new engine timing chain and rivet it, then rotate the crankshaft in the engine running direction to 55° before the top dead center of cylinder 1 ignition. Rotate the crankshaft 95° in the engine running direction to position it at 40° after the top dead center of cylinder 1 ignition. With the front cover already installed on the cylinder head, check the basic position of the camshaft at 55° before the top dead center of ignition. Install the spark plugs, install the ignition coils, perform an engine test run, and check for any engine leaks.
6
1
Share

How to Use Car Glass Anti-Fog Spray?

Usage method of car glass anti-fog spray: 1. Clean the glass that needs anti-fog treatment thoroughly, ensuring the surface is completely dry; 2. Shake the anti-fog spray well, then spray an appropriate amount onto a dry dedicated car cleaning cloth. Alternatively, you can spray directly onto the glass and wipe with the cleaning cloth. The car glass anti-fog spray utilizes next-generation dispersing anti-drip materials and nano organic active agents, which effectively prevent fogging when applied to glass. In addition to its anti-fog function, it can also effectively remove dirt from the car windshield, improving glass clarity and significantly enhancing driving safety.
17
5
Share

How to Determine if the Brake Load Sensing Proportioning Valve is Faulty?

Methods to determine if the brake load sensing proportioning valve is faulty: decreased braking effectiveness, longer braking distance, and during emergency braking, the rear wheels lock up first, causing the rear of the vehicle to become unstable or even leading to a rollover. The brake load sensing proportioning valve only affects the rear wheels. In contrast, the ABS system can precisely prevent any wheel from locking up, allowing the vehicle to maintain directional control. Higher-end vehicles are also equipped with an ESP system, which can maintain vehicle stability by controlling components such as the ABS and steering gear. The brake load sensing proportioning valve is a hydraulic mechanical device designed to maintain the appropriate load proportion between the front and rear wheels during driving and to ensure that the rear wheels do not lock up during emergency braking.
17
4
Share

How to Check if a Vehicle Has Commercial Insurance?

Follow the prompts to scan the relevant QR code and subscribe to the corresponding official account to check for commercial insurance. Contact the insurance agent who handled the car insurance purchase for the owner. They can assist in inquiring about the details of the commercial insurance and provide help when needed or not needed by the owner. Call the customer service hotline of the relevant insurance company to inquire about the car insurance. If you forget which company the insurance is with, you can contact the car insurance agent to check if the insurance has lapsed. Search online for relevant information to learn and educate yourself about the insurance status or whether the new owner needs to renew or check the insurance details.
15
4
Share

How to Make the BMW X1 Interior Look Better Through Modifications?

Search online for interior decoration content related to the owner's vehicle and do detailed homework. Visit a professional car beauty center, communicate the owner's requirements with the staff, and have them create a suitable plan. According to the owner's preferences, raise the car's floor and arrange the battery pack underneath it, which has minimal impact on rear passenger space and trunk storage. The entire interior is decorated with genuine leather, with the lower part of the dashboard covered in blue leather, making the entire console appear more spacious.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.