Where is the Honda 190 odometer sensor located?
2 Answers
Odometer sensor is commonly referred to as the vehicle speed sensor, which is typically installed near the output shaft of the transmission. Introduction to automobile odometer sensor: Most modern automobile odometer sensors are electronic components. The odometer sensor generally has three wires: red, black (or orange), and green (or other colors). The red wire is the power line, the black (or orange) wire is the ground line, and the other wire is the signal line, which is connected to the instrument panel. Odometer sensor testing method: Disconnect the vehicle speed sensor connector and use a multimeter in resistance mode to check the resistance value between the two leads of the sensor, which should meet the standard requirements.
As someone who has played around with quite a few Honda motorcycles, I have to say something about this issue. The Honda 190 series, like the CB190R, usually has its odometer sensor installed near the front wheel hub. You heard it right—it's that small box next to the wheel, connected with wires. I've tinkered with it on my own bike several times. Its main function is to monitor wheel speed and transmit the data to the dashboard to calculate mileage. If the sensor fails, the odometer will either jump erratically or stop displaying, which is really annoying when riding. Locating it isn't hard—just crouch down and look at the inner side of the front wheel. There's a silver or black metal cover; unscrew it, and you'll see the sensor. Remember not to expose it to too much water, as mud buildup can corrode the connectors. I once had a no-start issue on a rainy day because the sensor rusted out, costing me 50 bucks for a replacement. My advice is to regularly dry that area after washing the bike or buy waterproof spare parts to install. If you're not confident in your DIY skills, just take it to a repair shop to avoid damaging other components. In short, knowing the sensor's location can save you a lot on repair costs.
