Where is the headlight height adjustment for the Lynk & Co 03?

[StKevin]

The headlight height adjustment button for the Lynk & Co 03 is located in the main driver's control area. On the far left near the door, there is a black plastic button that can be rolled up and down, accompanied by indicator lines that transition from thick to thin. Rolling the button up or down adjusts the height. A higher numerical value results in a higher light beam, which is more likely to cause glare for oncoming drivers. Below are the headlight height adjustment standards: 1. Level 0: Suitable when the front seats are occupied and the trunk is empty. 2. Level 1: Suitable when the vehicle is fully occupied and the trunk is empty. 3. Level 2: Suitable when the vehicle is fully occupied and the trunk is fully loaded. 4. Level 3: Suitable when the vehicle is fully occupied and the trunk is fully loaded.

[JaceMarie]

When I first got my Lynk & Co 03, I couldn't find the headlight height adjustment either. Later I discovered it's not near the steering wheel. You need to tap the 'Settings' icon in the lower left corner of the main screen, then find the 'Vehicle' category, and enter the 'Lighting' submenu. The numbered slider marked 0 to 5 is the adjuster - slide up to raise the beams and down to lower them. I always set it to level 2 when the car is fully loaded and the rear sags, so I don't blind oncoming drivers. Actually, the 03's automatic height adjustment works well, but manual fine-tuning offers more flexibility, especially on mountain roads with undulating surfaces. Remember to check the cutoff line against a wall after adjusting, making sure the light pattern doesn't exceed the position of the rearview mirrors on cars ahead.

[DeNoah]

The headlight height adjustment on the Lynk & Co 03 has been fully digitized, replacing the mechanical knob found in older vehicles. The operation path is: central control screen - vehicle settings - exterior lighting - headlight height, where you can adjust it using a touch slider. I usually set the default position to level 3, which illuminates about 30 meters when the car is unloaded. Before setting off with a full load of family members, I adjust it to level 5 to prevent the light from pointing too high. This design is more precise than traditional knobs and can also memorize the preference settings of different drivers. Here's an interesting tidbit: the headlight height is linked to the suspension sensor, and the lights will slightly dip during hard braking to prevent glare—a thoughtful detail in the design.

[McMaci]

Adjusting the headlight height on the Lynk & Co 03: 1. Start the vehicle and enter the main menu. 2. Tap 'Settings' to access 'Basic Vehicle Settings'. 3. Select the 'Lights' menu. 4. Locate the headlight height adjustment slider. I prefer adjusting at night by aiming at the garage roll-up door, setting the low-beam cutoff line at license plate height for optimal positioning. Note that new vehicles may be preset to the highest level - reduce by two notches during rainy conditions with reflective road surfaces. Owners with modified suspensions must recalibrate to avoid automatic leveling system errors. While all 03 models feature ALS (Automatic Leveling System), manual adjustment provides more direct control for load variations.