Where is the fuse for the car navigation system located?

1 Answers
SanTyler
07/29/25 1:39pm
The fuse for the car navigation system is typically located on the side of the center console near the door or under the steering wheel. You can refer to the fuse diagram inside the fuse box cover to locate the specific fuse. The functions of the navigation system include: 1. Searching and processing map data; 2. Map matching; 3. Route planning; 4. Human-machine interface; 5. Wireless communication. The navigation system features GPS (Global Positioning System) functionality, allowing drivers to input their destination, after which the system automatically calculates the optimal route based on electronic maps and provides turn-by-turn guidance during the journey.
Was this review help?
15
2
Share
More Forum Discussions

How many kilometers can the Orlando travel on a full tank of fuel?

Chevrolet Orlando's comprehensive fuel consumption per 100 kilometers is 6.7L, and the total fuel tank capacity is 45L. Based on this data, a full tank of fuel can travel approximately 670 kilometers. However, in reality, fuel consumption is also affected by various factors such as road conditions, personal driving habits, and mechanical wear, so it cannot be generalized. Below is an introduction to the Chevrolet Orlando: 1. Exterior: The Chevrolet Orlando features a personalized appearance and practical performance. It has the size of a compact sedan, a sporty SUV-like appearance, and 7 seats similar to an MPV. 2. Power: The Chevrolet Orlando is equipped with a new-generation Ecotec dual-injection turbocharged engine, paired with a 6-speed manual intelligent start-stop transmission, delivering a maximum power of 120kW and a maximum torque of 230N·m, with performance comparable to a 2.0L naturally aspirated engine.
14
0
Share

How to Check How Much Engine Oil is Left in the Car?

Methods to check how much engine oil is left in the car: 1. Park the car on a level surface, wait for the engine to cool down, then open the front hood to inspect the engine oil; 2. Locate the oil dipstick, pull it out, and wipe it clean the first time; 3. Reinsert and pull out the oil dipstick again, observe the oil level on the dipstick. The oil level should be between the upper and lower marks on the dipstick. If it's too high, drain some oil; if it's too low, add some oil. Engine oil is a substance enhanced with additives in base oil, mainly containing anti-wear additives, detergents, dispersants, and multi-grade oil viscosity index improvers. Engine oil is used for lubricating internal combustion engines, and its main functions are to reduce friction and wear of moving parts and to remove sludge and varnish from the engine.
17
4
Share

Where to Check the Tire Pressure of the Classic Sylphy?

For vehicles equipped with a tire pressure monitoring system, the specific values of all four tires can be directly viewed on the instrument display. The recommended tire pressure for the Nissan Sylphy is between 2.3-2.5 bar. The driving wheels can have a slightly higher pressure than the driven wheels, and the tire pressure in winter can be slightly higher than in summer. It is recommended not to exceed 2.8 bar, while the tire pressure for new cars is 3.0 bar. There are two principles for the automotive tire pressure monitoring system: 1. Direct tire pressure monitoring: A gas pressure sensor is installed inside the tire, and a wireless transmitter sends the signal to the central receiving module, which then processes and displays the specific values on the instrument panel. 2. Indirect tire pressure monitoring: It uses the difference in wheel rotation speed to determine tire leakage. When a tire leaks, the vehicle's weight causes the rolling radius of that wheel to become smaller, resulting in a faster rotation speed compared to other wheels. By comparing the differences in rotation speed between the tires, it determines tire pressure loss to achieve monitoring effects.
17
2
Share

Must the water pump be replaced if it leaks?

Water pump leakage must be replaced. The following are specific explanations about water pump leakage: Causes of water pump leakage: The radiator is not firmly fixed, causing the radiator to shake when the car bumps, resulting in local cracking, seepage, or leakage of the radiator; The water pump fan blades sweep against the radiator, causing leakage; The clamps of the upper and lower hoses of the radiator are loose, causing leakage; The water seal of the water pump is worn, causing leakage; The drain switches of the radiator and engine block are not tightly closed, causing leakage; There is a leakage in the water circulation system. The following is extended information: The use of coolant: It should be known that the coolant itself is to prevent the engine from "boiling" when the car is driving at high speed. If this happens, it will not just be a matter of repairing the water pump. Everyone must understand the seriousness of coolant leakage, so when water pump leakage is found, it is necessary to go to the auto repair shop for inspection and repair as soon as possible.
5
1
Share

How many color options are available for the Beijing BJ40?

The Beijing BJ40 offers 7 color options: Polar Night Black, Jungle Green, Flame Red, Snowfield White, Desert Gold, Danxia Red, and Beret Green. Below is a relevant introduction about the BJ40: The BJ40 is a compact SUV launched by Beijing Automotive. As a compact SUV, this vehicle features a highly distinctive exterior design. To cater to the diverse needs of different consumers, it provides multiple body color options for selection. 1. In terms of exterior design, the front fascia adopts a family-style design, with a five-slot chrome grille paired with integrated high/low beam headlights on both sides. The front grille is also decorated with chrome trim, giving the vehicle a more imposing appearance. 2. From the side profile, the vehicle boasts a very boxy design, which aligns perfectly with its model positioning. The externally mounted spare tire at the rear further emphasizes its identity as a rugged SUV. 3. In terms of powertrain configuration, the vehicle is available in two versions: a gasoline model and a diesel model. The gasoline version is equipped with a 2.0T and a 2.3T turbocharged engine, paired with either a 5-speed manual transmission or a 6-speed automatic transmission.
17
1
Share

Which region in Yunnan does the license plate 'Yun B' belong to?

Currently, there is no 'Yun B' license plate in Yunnan Province. The license plates in Yunnan Province are as follows: Yun A for Kunming, Yun C for Zhaotong, Yun D for Qujing, Yun E for Chuxiong Yi Autonomous Prefecture, Yun F for Yuxi, Yun G for Honghe Hani and Yi Autonomous Prefecture, Yun H for Wenshan Zhuang and Miao Autonomous Prefecture, Yun J for Pu'er, Yun K for Xishuangbanna Dai Autonomous Prefecture, Yun L for Dali Bai Autonomous Prefecture, Yun M for Baoshan, Yun N for Dehong Dai and Jingpo Autonomous Prefecture, Yun P for Lijiang, Yun Q for Nujiang Lisu Autonomous Prefecture, Yun R for Diqing Tibetan Autonomous Prefecture, Yun S for Lincang. License plates are identification numbers for vehicles, and their significance to vehicles is akin to ID numbers to individuals. Apart from the current customizable personalized license plates, the currently used '92-style' motor vehicle license plates consist of a Chinese and English letter issuing authority code followed by a five-digit number.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.