Where is the fuse box located in the Sylphy?

2 Answers
LeRuby
07/25/25 3:38pm
The fuse box in the Sylphy is located on the lower right side of the engine compartment, at the front of the battery. Below is some related information about the Sylphy: 1. Introduction: The Nissan Sylphy is a new strategic model launched globally by Nissan, featuring innovative design and advanced technology. 2. Product Highlights: The series is equipped with an automatic positive and negative ion air conditioning system and Bluetooth hands-free system, enhancing the comfort inside the car. The "Sylphy" boasts a stylish and elegant design with S-shaped dynamic curves visible throughout the vehicle. The smooth driving experience and low fuel consumption are achieved by the perfect combination of the MR20DE engine and Nissan's third-generation XTRONIC CVT transmission, offering exceptional comfort and convenience.
Was this review help?
7
5
Share
LeKatherine
08/11/25 9:31pm
As a long-time daily driver of a Nissan Sylphy, I often handle minor issues myself, such as locating the fuse box. The Sylphy typically has two fuse box locations: the main fuse box is located at the front left of the engine compartment, near the windshield side, with a plastic cover labeled 'Fuse Box'—opening it reveals rows of fuses. Another is inside the cabin, slightly to the left under the steering wheel; crouch down and you can feel a small panel, which opens with a gentle pry. This one mainly controls interior circuits like the dashboard and horn. Remember, always turn off the engine before working, and ideally disconnect the battery’s negative terminal to prevent short circuits—safety is paramount. It’s recommended to check fuse conditions every six months, especially in summer when high temperatures can cause blowouts (e.g., headlight failure might stem from here). Replacing fuses is super simple: use small pliers to pull out the faulty one and insert an identical color/amp-rated fuse—never swap types recklessly to avoid hazards. Note that fuse box positions vary slightly across Sylphy model years; consult the manual for precise details—don’t skip this step.
Was this review help?
17
4
Share
Expand All
More Forum Discussions

What Causes the Mazda3's Engine Warning Light to Stay On?

There are two scenarios when the engine warning light illuminates: the vehicle has an engine system fault such as sensor issues, maintenance problems, fuel quality issues, poor combustion of the air-fuel mixture, engine intake problems, turbocharging issues, exhaust problems, or a malfunctioning anti-theft system. During vehicle startup, the engine performs a self-check, but in this case, the light will turn off after the self-check is completed. If the engine warning light remains on for an extended period, promptly visit a repair station for troubleshooting. Sensor problems: Sensors include coolant temperature, crankshaft position, air flow, intake temperature, oxygen sensors, etc. When these sensors are damaged, have poor connections, or experience signal interruptions, the vehicle's ECU cannot accurately obtain engine data, which will trigger the engine warning light. If such issues occur, seek professional inspection at a repair center immediately to eliminate potential safety hazards. Maintenance issues: Poor engine maintenance is the most common cause of the engine warning light. Vehicles have specific maintenance cycles, and failure to adhere to them, combined with poor driving habits, will increase the engine's operational burden, eventually causing the engine warning light to illuminate as a reminder of a fault. Fuel quality issues: This refers to both fuel and engine oil. The fuel used in cars typically has a specific octane rating, and engine oil comes in semi-synthetic and fully synthetic varieties. Manufacturers usually recommend which fuel grade and oil type to use. If the owner fails to follow these recommendations, prolonged use can lead to engine wear, triggering the warning light. Always use the recommended fuel grade and suitable engine oil. Poor combustion of the air-fuel mixture: Faulty spark plugs, ignition coils, fuel pumps, or clogged fuel lines can cause poor combustion of the air-fuel mixture. This leads to engine carbon buildup or knocking, which the oxygen sensor detects and reports to the ECU, prompting the warning light to illuminate as a warning. Intake problems: The engine requires air for combustion, and the air filter plays a crucial role. If the air filter is dirty or not cleaned regularly, it can affect the engine's air intake, potentially leading to blockages. In severe cases, this can cause the engine warning light to come on. Turbocharging issues: Problems with the intake boost piping or turbocharger can also trigger the engine warning light. The most common issue is a damaged turbocharger, accompanied by symptoms such as oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Exhaust problems: Faults in the rear oxygen sensor, catalytic converter, exhaust camshaft, or bearings can cause the engine warning light to illuminate. The most common issue is a faulty catalytic converter, which can result from using leaded gasoline, lead- or silicon-containing oil additives, physical damage to the converter, or fuel system malfunctions. Anti-theft system: If the car's electronic anti-theft system malfunctions or the anti-theft controller is incompatible with the engine control unit, the anti-theft system can prevent the engine from operating normally, while also triggering the engine warning light. Solutions for an illuminated engine warning light: If the engine warning light is on and the car cannot start, this may be due to a faulty fuel pump or ignition components. It is advisable to call for assistance immediately. If the engine warning light is on but the vehicle is drivable, yet experiences severe shaking or loss of acceleration, pull over and call for roadside assistance.
14
1
Share

Lexus 570: Should I Use 92 or 95 Octane Gasoline?

92 octane is sufficient. Below is a comparison between 92 and 95 octane gasoline: 1. Different compositions: 92 octane gasoline consists of 92% isooctane and 8% n-heptane, while 95 octane consists of 95% isooctane and 5% n-heptane. 2. Price difference: 95 octane gasoline is slightly more expensive per tank than 92 octane. 3. Power difference: 95 octane gasoline with higher octane rating is suitable for engines with higher compression ratios. This is because as the engine speed increases, the ignition timing in the cylinder advances. When the speed reaches a critical point, premature combustion of the air-fuel mixture may occur before ignition, known as knocking. Increasing the octane rating of gasoline can effectively improve anti-knock performance.
7
3
Share

Is Sehol a Joint Venture Car?

Sehol is a newly launched joint venture home car brand. The relevant details are as follows: 1. Introduction to Sehol: The brand's Spanish name "SOL" means "sun." Originally, it was the new energy brand of JAC Volkswagen. However, with the advancement of the JAC Volkswagen joint venture cooperation, it has now become the fifth joint venture sub-brand of Volkswagen in China and the first brand under the JAC Volkswagen joint venture cooperation. The brand's product lineup includes both fuel-powered vehicles and pure electric vehicles. 2. Brand Value: As a highly anticipated brand, Sehol will uphold "German quality with mass appeal" as its core brand philosophy, with "trust, quality, innovation, and diversity" as its brand values, and "intelligence, interaction, pleasure, and freedom" as its brand characteristics, aiming to provide the ultimate quality and intelligent experience for the new generation of users who value quality and follow trends.
15
2
Share

What does the AC symbol on a car air conditioner mean?

The AC button in a car's air conditioning system is the cooling switch, which serves as the power switch for the air conditioning compressor. Here are the details: 1. When the AC button is pressed, the car's air conditioning compressor activates, allowing the blower to produce cold air. Pressing the AC switch engages the compressor's electromagnetic clutch, starting the compressor's operation and enabling the car's air conditioning to enter cooling mode. 2. The outer knob labeled MAX stands for maximum, while MIN stands for minimum. If the car is equipped with automatic air conditioning, simply press the AC button followed by the AUTO button. The automatic system will adjust the interior temperature based on the difference between the inside and outside temperatures. When using the heater in winter, be sure not to press the AC button, as it not only consumes more fuel but may also produce cold air. This is because the car's heating system does not require the compressor to operate; instead, it utilizes heat from the engine's coolant.
6
4
Share

What does ASL mean in cars?

ASL is the abbreviation for the English term 'automatic-shift-lock,' which represents the gear shift lock device in cars, typically found in automatic transmission vehicles. Below is an introduction to ASL: 1. Its function is to prevent sudden vehicle acceleration. The main feature is that when the car is in normal operation, the driver must press the brake pedal to shift the gear from P (Park) or N (Neutral) to R (Reverse) or D (Drive). This prevents accidentally shifting into forward or reverse gear without pressing the brake, which could lead to accidents. 2. The ASL can control the vehicle speed. When pressed, it sets the current speed as the maximum limit, preventing the vehicle from accelerating further regardless of throttle input. In emergency situations, pressing the throttle fully will trigger a 'click' sound, releasing the speed limit and allowing the vehicle to accelerate rapidly. The ASL is integrated into the entire gear shift system.
10
1
Share

How to Deal with Windshield Scratches?

Methods for repairing car glass scratches are as follows: 1. Polishing Removal: Small and shallow scratches can be removed by polishing. However, it's best if the scratches are not within the driver's line of sight, as polishing causes some glass loss. Large areas may affect visibility, so for safety reasons, it is recommended to replace the glass directly. 2. Glass Scratch Repair Agent: Slowly apply the gel along the glass crack, being patient to avoid unevenness, which is especially noticeable under sunlight. Note that glass repair agents are only suitable for minor scratches. For more severe cases, it's advisable to visit a professional auto beauty shop or 4S store for repair. 3. Professional Repair Shop: For deeper glass scratches, it is recommended to choose a reliable and reputable professional repair shop for restoration. 4. Toothpaste for Scratch Removal: Apply a small amount of toothpaste to the scratched area, rub gently with a soft cloth, and then rinse with water. Toothpaste can help repair fine scratches and also prevent rusting.
1
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.