Where is the fuel tank cover pull cable for the 2014 Passat?

What causes the EECU failure in Dongfeng Tianlong trucks?

It is generally believed to be caused by issues with the accelerator pedal, accelerator pedal wiring, vehicle VECU failure, or communication line faults between the instrument cluster, VECU, and EECU. Below are the relevant details: 1. Fault analysis: First, supply 5V power to the accelerator pedal sensor 1 and 2 power lines while grounding the ground wire. Use a multimeter to measure whether the feedback signals from sensor 1 and 2 are 0.76 and 0.37, respectively. If the relationship between the two is correct, then the accelerator pedal is not the issue. 2. Purple connector: Disconnect the purple connector on the VECU and locate wires 0012 and 0013, which are yellow and green, respectively. Use a multimeter to measure whether the resistance between them is 120Ω. If the measurement shows 120 ohms, then the initial possible causes can be ruled out based on the above measurements.

16

0

Share

What causes abnormal noise when accelerating at low speeds in a Corolla?

Abnormal noise during low-speed acceleration in a Corolla is primarily caused by using inferior quality engine oil, prolonged intervals between oil changes, or insufficient oil levels. These conditions can increase friction between components such as valves and guides, as well as hydraulic lifters, resulting in amplified engine noises. Steps for changing engine oil: Lift the vehicle and remove the underbody protection panel. Place a container beneath the oil drain plug; loosen the drain plug and use an air gun to blow for two minutes at the oil filler port. After draining, tighten the drain plug and wipe it with a tissue to check for leaks; reinstall the protection panel and lower the vehicle. Finally, add new oil through the filler port. Consequences of driving with insufficient oil: Firstly, lubrication effectiveness significantly deteriorates. Secondly, lack of proper lubrication may lead to engine seizure. The severity of damage increases with lower oil levels.

9

0

Share

How many points are deducted for stalling during a right-angle turn?

Stalling during a right-angle turn results in a deduction of 100 points. Below are relevant details about point deductions for stalling during a right-angle turn: 1. In the right-angle turn test item: Stalling causes the vehicle to stop midway, directly deducting 100 points (a vehicle stopping for more than 2 seconds will be judged as stopping midway). 2. Additional information: The main trick to avoid point deductions for crossing the line during a right-angle turn: Before turning, try to drive as close to the outer side as possible. When the front of the car is about to reach the opposite sideline, look ahead while also observing the rearview mirror. When you feel the middle of the car is about to pass the vertex of the right angle, slowly adjust the steering wheel back, then gradually correct the car's direction. Based on the speed (preferably in first gear with half-clutch), be decisive and even when turning (or adjusting) the steering wheel, avoiding sudden or jerky movements.

5

Share

What should be noted when a car breaks down on the highway?

Here are the precautions to take when a car breaks down on the highway: 1. Turn on the lights and set up warning signs: If the vehicle cannot leave the driving lane due to a malfunction, the hazard warning flashers must be turned on immediately, and a warning sign should be placed 150 meters behind the vehicle. At night, the width marker lights and taillights should also be turned on simultaneously. 2. Pay attention to avoiding danger: The driver should remain vigilant. Once a dangerous situation is detected, emergency avoidance measures should be taken immediately by moving to the safe area on the shoulder outside the guardrail. 3. Return to the driving lane: After the car is repaired and needs to return to the driving lane, the speed should be increased on the emergency parking lane first, and the left turn signal should be turned on before entering the driving lane, ensuring that it does not hinder other normally moving vehicles.

9

4

Share

What to Do If You Can't Schedule the Driving Test on Driving Test 123?

Here are the relevant explanations for being unable to schedule the test on Driving Test 123: 1. Not registered: If you haven't registered an account on the Traffic Management Bureau's website, you need to register an account using your ID card before you can normally schedule the test, or you can ask your coach to help you schedule it directly. 2. Register and schedule at the Vehicle Management Office: The Vehicle Management Office publicly announces the test arrangement plans online. Candidates can independently register and schedule the test through the internet, phone, or the service window of the Vehicle Management Office, choosing the test date and session. The system will automatically and fairly calculate the candidate's ranking based on factors such as the candidate's last test time and the date of the scheduling application, ensuring the candidate's right to schedule the test and promoting the integrity and fairness of the driving test. The platform will also connect with motor vehicle inspection agencies to facilitate car owners in scheduling the time and location of vehicle inspections in advance.

12

4

Share

Where is the tire pressure reset button on the 2020 Highlander?

The tire pressure reset button on the 2020 Highlander is located on the left-hand control lever. Tire pressure reset method: To reset the Highlander's tire pressure warning light: Turn on the ignition, when the TPWS indicator light is on, press the TPWS SET button for 1-2 seconds, then release the SET button after the TPWS indicator light turns off. The tire pressure warning light will then be reset. Principle of the tire pressure monitoring system: The tire pressure monitoring system detects air pressure by measuring wheel circumference through ABS sensors. This means that after tire reset, the system requires driving at least 15-20 kilometers before it functions normally. If a tire loses air rapidly (e.g., complete deflation within less than 1 kilometer), the tire pressure monitoring may not issue an immediate warning - it would take about 20 kilometers of driving before the alarm activates. Therefore, this is not a direct warning system but rather an indirect alert mechanism. Regular manual inspection of tire conditions is still recommended.

10

2

Share

Where is the fuel tank cover pull cable for the 2014 Passat?

What causes the EECU failure in Dongfeng Tianlong trucks?

What causes abnormal noise when accelerating at low speeds in a Corolla?

How many points are deducted for stalling during a right-angle turn?

What should be noted when a car breaks down on the highway?

What to Do If You Can't Schedule the Driving Test on Driving Test 123?

Where is the tire pressure reset button on the 2020 Highlander?

What are the differences between the 2021 and 2022 T-Cross models?

Can the Toyota Vios be driven on highways for long distances?

What do the A and B buttons on the Nissan trip reset represent?

What is the tire specification model for the ninth-generation Honda Accord?