···
Log in / Register

Where is the fuel tank cap switch of the Elysion located?

4 Answers
VonLyla
08/29/25 4:53am

The fuel tank cap switch of the Elysion is located on the left side of the driver's compartment, with a fuel tank opening symbol on the switch. The method to open the Elysion's fuel tank cap is: 1. Pull the fuel filler release handle outward; 2. Turn the fuel filler cap to remove and take off the cap. The Elysion is an MPV launched by Dongfeng Honda, with body dimensions of: length 4940 mm, width 1645 mm, height 1710 mm, wheelbase of 2900 mm, and a fuel tank capacity of 55 liters. The Elysion is equipped with a 2.4L inline 4-cylinder naturally aspirated engine, with a maximum power of 137 kW, maximum power speed of 6400 rpm, and maximum torque speed of 3900 rpm.

Was this review help?
12
2
Share
LawsonRose
09/11/25 2:41am

I recently drove an Elysion, and the fuel tank cap switch was quite easy to find. It's located on the floor near the left side of the driver's seat, not far from the door edge, where there's a small handle or plastic lever. A slight pull will pop open the fuel tank cap. The first time I drove it, I was a bit confused and searched for a while, only to find it in that corner. That's how older car models are designed—mechanical, unlike newer cars that use button controls. If it doesn't pull easily, the cable might be stuck; try gently shaking it or applying some lubricant. Always remember to turn off the engine before refueling to avoid danger. The location is simple and intuitive—next time, just look down near your feet and don’t waste time searching around the dashboard. Make sure to close the cap properly to prevent fuel odors from leaking or debris from entering.

Was this review help?
13
1
Share
Expand All
SanAngelina
10/25/25 3:30am

As someone who frequently works on cars, the location of the Elysian fuel tank cap switch is quite standard. It's usually found near the driver's left foot, on a plastic lever by the door frame. Pulling it activates a cable connected to the fuel tank cap, allowing for easy opening. Common issues include rust or deformation of the cable causing it to jam—don't force it in such cases; instead, apply lubricant or replace the cable. If it completely fails, check if the cable is broken or if the locking mechanism is faulty. Always ensure the car is stationary and the engine is off when refueling, prioritizing safety. The location isn't hard to find; just refer to the diagram in the manual. Avoid exposing metal components to damp environments to prevent corrosion, and regular maintenance will extend the switch's lifespan.

Was this review help?
9
0
Share
Expand All
OMarcus
12/08/25 3:53am

My family also uses the Elysion, and the fuel tank cap switch is very easy to operate. When you're in the driver's seat, look down near the floor by your left leg, and you'll see a small handle—just pull it to open. Don't use too much force, as it might damage the mechanism. If it gets stuck, don’t panic; ask a family member or friend to help check it. Always turn off the engine and park safely before refueling—safety first. After opening the cap, remember to close it tightly to avoid fuel odors or dust entering. Over time, the switch might loosen, so check if it’s securely fixed. Before and after refueling, inspect the fuel tank opening to ensure it’s free of dirt, keeping it clean to prolong its lifespan. Older cars are simple and reliable, so there’s no need to worry too much.

Was this review help?
1
5
Share
Expand All
More Forum Discussions

How to Take Out the Mechanical Key of BYD Song Pro?

Flip the cover to remove the key back cover. The mechanical key is hidden on the back of the cover and can be taken out. Here is some related information: 1. BYD: BYD is a Chinese automotive brand established in 1995, primarily producing commercial and family cars as well as batteries. Starting with a team of just over 20 people, BYD grew to become the world's second-largest rechargeable battery manufacturer by 2003. In the same year, BYD Auto was established. Following a development path of independent R&D, production, and branding, BYD Auto is committed to creating truly affordable and high-quality vehicles for the people. 2. Mechanical Key: Most cars are equipped with both smart keys and mechanical keys. The mechanical key serves as a backup unlocking tool designed for situations when the smart key runs out of power.
17
5
Share

What is the general speed of a car?

Car speed should be adjusted according to the speed limit signs on the road, as detailed below: 1. Domestic highways: The speed limit is mostly 120 km/h. 2. National roads: The speed limit is generally 80-60 km/h. 3. Urban streets: Usually 40-30 km/h. Highway speed regulations: 1. Speed limits: The maximum speed for small passenger vehicles must not exceed 120 km/h, other motor vehicles must not exceed 100 km/h, and motorcycles must not exceed 80 km/h. The minimum speed must not be less than 60 km/h. 2. Number of lanes in the same direction: If there are 2 lanes in the same direction, the minimum speed for the left lane is 100 km/h; if there are 3 or more lanes in the same direction, the minimum speed for the leftmost lane is 110 km/h. The minimum speed for the middle lane is 90 km/h. Vehicles traveling at speeds above 60 km/h but below 90 km/h should drive in the rightmost lane. 3. Speed limit signs: When the speed indicated by road speed limit signs is inconsistent with the above lane speed regulations, drivers should follow the speed indicated by the road speed limit signs.
13
5
Share

Where to Handle High-Speed Traffic Violations in Jiangxi?

After committing a high-speed traffic violation in Jiangxi, you must present the "Traffic Violation Penalty Decision Notice" (and the "Traffic Management Temporary Seizure Receipt" if any documents are temporarily withheld) to the designated bank to pay the fine. Below are the relevant details for handling high-speed violations: 1. Detailed handling procedure: Bring the "Traffic Violation Fine Receipt," "Traffic Violation Penalty Decision Notice" (and the "Traffic Management Temporary Seizure Receipt" if any documents are temporarily withheld), along with the driver's license and vehicle registration certificate to the traffic police brigade that issued the penalty decision for processing. If the violation requires suspension of the driver's license, follow the regulations for suspension. After the suspension period ends, retrieve the driver's license with the "Driver's License Suspension Execution Receipt." 2. Important notes: When handling traffic violations at the service window, the driver must bring their original driver's license, ID card, and vehicle registration certificate. If the vehicle owner cannot personally handle the violation at the window, they may authorize someone else to do so by providing their identity proof, copies of the owner's driver's license, ID card, vehicle registration certificate, and a handwritten authorization letter.
12
1
Share

How High Does Water Need to Submerge a Car to Cause Damage?

Generally, water reaching half the height of the wheels can already affect the car. Relevant details are as follows: 1. Water submerging the exhaust pipe: If water only submerges the exhaust pipe, promptly moving the car away is sufficient. Submerging the exhaust pipe does not cause water to be sucked back into the engine, and engine stalling is primarily due to water entering the engine's intake system, unrelated to the exhaust pipe being submerged. 2. Water reaching half the wheel height: If water reaches exactly half the wheel height, the car usually won't leak. However, if submerged for an extended period and the sealing strips have aged, leakage may occur. In such cases, drive the car to a 4S shop, dismantle the interior, clean, and dry it. 3. Water exceeding half the wheel height: If water surpasses half the wheel height, the engine may take in water, and the interior could leak. Never start the engine in this situation to avoid damage to the engine or electronic components. Additionally, insurance companies will not cover damages caused by attempting to start a water-submerged car.
19
3
Share

How to Repair Tire Cracks?

Remove the problematic tire from the vehicle. Soak the tire in soapy water to locate the damaged area. Roughen the damaged spot using a grinding wheel. Apply the tire repair patch to the damaged area. Set the dryer to 110 degrees and heat the patch for 3 to 6 minutes.
19
3
Share

Can Replaced Car Parts Be Detected?

Replaced car parts can indeed be detected through the following methods: 1. Check screws: Inspect for any displacement marks on component fasteners. 2. Marking: Apply identification marks or record serial numbers on critical parts. 3. Supervision: At authorized dealerships (4S shops), maintenance workshops are usually visible for real-time monitoring. Car maintenance precautions include: 1. Tool usage: Proper tools must be used for specific repairs (e.g., bearings/gears) to prevent part damage. 2. Parking position: Never service vehicles on slopes without engaging parking brakes, as this may cause serious accidents.
14
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.