Where is the fuel pump module located in the Audi A4L?

2 Answers
McKarter
07/29/25 3:26pm
The fuel pump module in the Audi A4L is located under the rear seat on the right side. Open the cover above the fuel pump under the seat. Introduction to the fuel pump: The fuel pump is a lightweight and compact pump, which can be categorized into inline, distributor, and unit types. The fuel pump requires a power source to operate, and its lower camshaft is driven by the engine crankshaft gear. Steps to replace the automotive fuel pump: First, pry off the fuel pump cover; disconnect the wiring harness plug; remove the two fuel lines; take off the sealing ring; remove the fuel pump assembly; detach the fuel float rod; remove the fuel pump chamber cover; detach the two lines of the fuel pump chamber cover; remove the fuel level sensor PCB board; detach the fuel float rod linkage arm; pull out the fuel pump core; remove and clean the fuel filter screen; check if the sensor contacts are functioning properly; install the new fuel pump and reassemble all the removed parts in order; start the engine and check the fuel gauge's working condition.
Was this review help?
11
5
Share
SanMason
08/14/25 8:21am
The fuel pump module of the Audi A4L is quite well hidden, located beneath the trunk floor. Specifically, you need to lift the bottom cover of the trunk, and on the right side near the fuel tank, you'll find a component covered by a black plastic box—that's the fuel pump control module. It's positioned close to the fuel tank to directly manage fuel supply, ensuring shorter wiring and higher efficiency. Last time I helped a friend inspect it, I noticed that some models secure the module with clips, while others use screws. Be careful not to break the clips during removal—it's best to have some spare clips on hand. Also, remember to disconnect the negative terminal of the battery first to prevent short circuits and potential damage to the circuitry. If you're unsure about the location, checking the parts diagram in the latter half of the owner's manual will give you a clearer visual reference.
Was this review help?
9
1
Share
Expand All
More Forum Discussions

How many years can a new car be exempt from inspection?

Six-year exemption policy for new cars The motor vehicle must be a non-operational vehicle; The approved number of vehicles is 6 or fewer. The vehicle type indicated on the driving license The registration date must be after September 1, 2010; Vehicles that meet the above conditions and have not been involved in any traffic accidents causing casualties during the exemption period can enjoy the six-year exemption policy. However, the correct term for exemption here should be that the on-site inspection is exempted, but we still need to obtain the annual inspection sticker, which is unavoidable. Every two years, we must apply to the DMV or online to obtain the annual inspection sticker.
20
2
Share

Does removing the car's center console have any impact on the vehicle?

Removing the center console generally has no impact on the vehicle. In most cases, when purchasing a mid-range car without a built-in navigation system or screen, owners often choose to install aftermarket options, which requires removing the center console. The dashboard primarily serves to secure electrical instruments, protect the safety of passengers, and provide sound insulation and noise reduction. It is generally advisable to avoid disassembling the dashboard unless necessary. The center console refers to the front workspace in the driver's cabin, located in front of both the driver and front passenger. It serves as the mounting platform for the instrument panel, air conditioning and audio controls, storage compartments, airbags, and other devices. Positioned to the right of the steering wheel and in the middle front section of the cockpit, the center console consolidates most of the vehicle's control buttons, excluding those related to driving. If disassembly is unavoidable, it is recommended to only remove specific sections of the dashboard. Vehicles with disassembled dashboards are more prone to issues such as abnormal noises, poor sealing, and increased noise due to improper reassembly. However, disassembling the dashboard has minimal impact on the vehicle's handling and overall performance.
15
2
Share

How to Clean the Throttle Body?

Methods for cleaning the throttle body: 1. Open the engine hood and remove the upper black decorative panel of the engine; 2. Loosen or remove the intake hose; 3. Remove the throttle body and use a cloth to cover the metal intake port; 4. Clean the throttle body with a cleaning agent or carburetor cleaner; 5. After cleaning, dry the throttle body with a cloth and apply a small amount of engine oil near the throttle shaft for lubrication. Reasons for cleaning the throttle body: Each time the cylinder operates, it first injects fuel and then ignites. When the engine is turned off, the ignition is immediately cut off, and the fuel injected during the working cycle cannot be recovered. It adheres to the intake valve and combustion chamber walls. The wax and gum residues in the fuel harden after repeated heating, forming carbon deposits.
13
2
Share

How to Identify Car Tire Models?

Tire specification numbers indicate the model of the tire. The tire model refers to the international standard tire code, usually located on the sidewall of the tire, and includes the width of the tire cross-section in millimeters; the aspect ratio (percentage of section height to section width) in millimeters; the diameter of the wheel rim in inches; and the load index. These are the meanings represented by the tire specification numbers. For example, 185/60R1491V is a tire specification, where the numbers mean: the wider the tire, the larger the contact area with the ground. When driving, this will increase the friction between the tire and the road, which is not favorable for the car's fuel consumption. Of course, there are two sides to everything. By increasing friction, not only does it enhance wet road grip performance, but it also improves the tire's drainage capability, thereby increasing driving safety in rainy conditions. The number 60 represents the aspect ratio, which is the percentage of the tire's cross-section height divided by its width. A higher value means a thicker tire, resulting in lower maneuverability but increased comfort.
1
1
Share

How to Adjust the Front and Rear Position of Power Seats?

Methods for adjusting the front and rear position of power seats: 1. Pull up and hold the seat slide adjustment lever, then slide the seat to the desired position; 2. Release the adjustment lever and ensure the seat is locked in the desired position; 3. Push the control switch forward or backward to move the seat to the desired position; 4. Once the seat reaches the desired position, release the switch. Power seats are driven by motors and will stop immediately after adjustment. Excessive operation may damage electrical components. Power seats consume significant electricity during operation. To avoid unnecessary discharge of the charging system, do not adjust power seats for longer than necessary when the engine is not running. Do not operate more than two power seat control buttons simultaneously, as this may cause malfunctions in the power seat motors or electronic components.
9
5
Share

What is the Difference Between Automatic and Manual Air Conditioning in Cars?

The differences between automatic and manual air conditioning in cars are: 1. Different functions: Automatic air conditioning can adjust the temperature to the set value based on the driver's input; manual air conditioning can only regulate cold or warm air but cannot precisely control the temperature. 2. Different operations: Automatic air conditioning only requires setting the desired temperature, and it will automatically maintain the stable temperature inside the car; manual air conditioning requires manual adjustment of the fan speed. 3. Different fuel consumption: Automatic air conditioning can automatically adjust the temperature. When the temperature reaches the set value, the compressor can pause or reduce its output power, and it will restart when the temperature rises to maintain the set temperature; the compressor of manual air conditioning operates at a constant power, which consumes more engine fuel.
8
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.