Where is the fuel pump located in the Volkswagen Santana Vista?

1 Answers
VonHarrison
07/29/25 8:12pm
Under the trunk, remove the original trunk mat, and you will find a black cover secured with three small screws. Use a Torx screwdriver to open it, and the fuel pump will be visible. Introduction to the fuel pump: The four wires of the automotive fuel pump include two for the fuel level sensor (commonly known as the float), one for power supply, and one leading to the fuel gauge. The other two wires are for the fuel pump itself, with one for power supply and the other as the ground wire. Function of the fuel pump: The fuel pump's role is to draw gasoline from the fuel tank and deliver it through the pipelines and fuel filter to the float chamber of the carburetor. Thanks to the fuel pump, the fuel tank can be placed at the rear of the vehicle, away from the engine, and positioned lower than the engine.
Was this review help?
2
2
Share
More Forum Discussions

How to Open the Charging Port of BYD Yuan?

The charging port of this car is located at the front, and there are two methods to open it: manual and automatic. The electric switch is located on the driver's side door, with a charging port opening button below. Press the charging port cover switch to open the charging port cover on the front grille. Simultaneously press the opening switches on both sides of the front grille to release the charging port cover, then slide the cover upwards by hand to open it.
14
3
Share

BYD Charging Pile Installation Process?

Ask the property management to issue a construction permit and stamp it. Bring the permit, ID card, property ownership certificate, and parking space ownership certificate to the power supply bureau to apply for charging pile installation. After approval, the power supply bureau will send someone to install a separate electricity meter. Hire an electrician to run the cable from the meter to the charging pile installation location in the parking space. Contact the after-sales service to connect the charging pile.
8
5
Share

How to release the P gear on BYD Qin?

Intermittently press the brake pedal, release the brake pedal and try to shift gears. Turn the vehicle steering wheel, press the brake pedal to shift gears. After restarting the vehicle, press the brake pedal to shift gears. Disconnect the negative terminal of the battery and reinstall it, then try to shift gears.
18
5
Share

How to Solve Gasoline Engine Overspeeding?

For gasoline engines equipped with power output clutch devices, disengage the clutch to prevent damage to attached equipment. For models using point ignition, ground the stop wire by contacting it with the engine body. Quickly remove the spark plug protector to cut off the gasoline engine's circuit. Cover the air filter housing with a cloth to block the gasoline engine's intake passage until the engine shuts down.
8
2
Share

What to Do When the Car Rearview Mirror Becomes Loose?

Peel off the plastic cover of the interior rearview mirror, and you will see the floating nut inside. Hold the rearview mirror rod with one hand. Then use the other hand to tighten the nut with a wrench. Generally, the rearview mirror uses a reverse thread, so when tightening with a wrench, apply force from the bottom upwards in the opposite direction to tighten it.
13
5
Share

What to Do When the Front Car Radar Keeps Beeping Without Obstacles?

It may be due to weather conditions causing continuous beeping, such as in the winter in northern regions. Warming it up with your hands or a hot towel can help. There might be an issue with the sensor installation. If the sensor is too tight, it may falsely detect obstacles around it. It is recommended to remove the sensor and slightly widen the mounting hole with a file.
13
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.