Where is the front USB port of the 2021 Tharu?

2 Answers
SanElliana
07/24/25 12:56pm
The front USB ports of the 2021 Tharu are located in the middle of the center console screen or at the lower right corner, usually marked with USB data symbols. The functions of the USB ports in the car include: 1. Listening to music: Insert a USB drive to play songs; 2. Charging: Charge mobile phones; 3. Cigarette lighter: Connect a USB car cigarette lighter. More relevant information is as follows: 1. Introduction: The Tharu 2021 280TSI is a compact 5-door, 5-seat SUV under SAIC Volkswagen, with a length, width, and height of 4453mm, 1841mm, and 1632mm respectively, and a wheelbase of 2680mm. 2. Configuration: Equipped with a 7-speed dual-clutch transmission, the maximum speed reaches 200 kilometers per hour.
Was this review help?
7
4
Share
SanSavannah
08/11/25 7:03am
The front USB port of the Volkswagen Tharu 2021 model is typically located in the central area of the center console, right below the front edge of the center armrest. Every time I get in the car, I habitually reach my hand toward the storage compartment, and I can easily feel the USB-A port there. The placement is quite thoughtful—it doesn’t obstruct the view and allows for easy device charging. For example, I plug in my phone cable while driving to listen to music and navigate, which is very practical. Some car owners mention that the port cover might slide open or shut, so you may need to gently lift it before plugging in. In case your car is a specific trim version, like the Premium model, there might be an additional port near the glove box on the passenger side, but the standard location is most likely here. It’s recommended to regularly clean the port to avoid dust buildup and poor connectivity, ensuring a longer lifespan. If you can’t find it, check the owner’s manual for diagrams—safety first, avoid distracted operation.
Was this review help?
14
4
Share
Expand All
More Forum Discussions

How to adjust the date on a Mondeo?

Method to adjust the date on a Mondeo: After turning on, the CLK button displays and sets the time. Press and hold CLK for about 5 seconds until the time display flashes on the screen. Use the adjustment buttons—turn left to decrease and right to increase—first adjust the hour, then the minute. After selecting the time, press CLK to confirm. The Mondeo is a mid-size sedan under Ford, with dimensions of 4873mm in length, 1852mm in width, and 1470mm in height. The new Mondeo Intelligent Hybrid version features a 2.0-liter Atkinson cycle engine and an ECVT electronically controlled continuously variable transmission, achieving a balance between power and fuel economy.
4
0
Share

What is the tire model of the 2014 Nissan X-Trail?

2014 Nissan X-Trail has two tire size models: 225/60R18 and 225/65R17. The first number 225 represents the tire width of 225MM, 60 indicates the aspect ratio of the tire section is 60%, meaning the section height is 60% of the width. The letter R stands for radial tire, and 18 represents the rim diameter of 18 inches. The 2014 Nissan X-Trail accelerates from 0 to 100 km/h in 11.7 seconds and has a fuel consumption of 7.1L per 100 km. In addition to the model, the tire also has the following common data marked on it: Tire cord material: Represented by Chinese pinyin, such as M-cotton cord, R-rayon cord, N-nylon cord, G-steel cord, ZG-steel radial cord tire. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under specified conditions. Letters A to Z represent the certified speed ratings of the tire from 4.8 km/h to 300 km/h. Commonly used speed ratings are: Q: 160 km/h; H: 210 km/h; V: 240 km/h; W: 270 km/h; Y: 300 km/h; Rim specification: Indicates the rim specification compatible with the tire for practical use, such as "Standard rim 5.00F".
6
4
Share

What does comprehensive fuel consumption mean?

Comprehensive fuel consumption is the average value of fuel consumption under several different road conditions in specific situations. Generally, comprehensive fuel consumption is calculated based on fuel consumption in both urban and suburban conditions. Average fuel consumption is defined as the amount of fuel used by a vehicle per unit distance traveled, commonly measured in liters per 100 kilometers. The method to calculate a car's fuel consumption per 100 kilometers: 1. Fill up the fuel tank and reset the small odometer in the trip meter, then drive on the road; 2. When the small odometer reaches approximately 100 kilometers, find a gas station to refuel to the same level as before and record the amount of fuel added in liters; 3. Divide the recorded fuel amount by the mileage on the small odometer and multiply by 100 to get the fuel consumption per 100 kilometers.
17
1
Share

What Causes Frost to Form on the Inside of a Car Windshield?

Reasons for frost forming on the inside of a car windshield: When the temperature inside the car gradually drops to match the outside temperature, melted snow on the glass begins to freeze. Once frozen, falling snow no longer melts, and the moisture in the car glass solidifies into ice beads, which then form frost adhering to the glass. Solutions for frost on car windows: 1. Use a bank card or a hard plastic card to scrape the ice. Be careful not to apply too much force and maintain a consistent scraping direction to prevent scratching the glass. 2. After using the car the previous day, do not leave immediately. Instead, find a way to dissipate the warm air inside the car.
20
5
Share

What is the cause of car pressure loss?

Car pressure loss indicates insufficient tire pressure, which is a warning given by the tire pressure monitoring system. After receiving this alert, it is essential to identify which tire has low pressure and then inflate and adjust it accordingly. Tires are a crucial component of a car, as they directly affect the vehicle's driving stability and safety. Tire pressure is of great importance to the tires themselves. The tire pressure should neither be too high nor too low. If the pressure is too low, the tires may experience wave-like deformation during high-speed driving, increasing the risk of a blowout and reducing the tire's lifespan. If the pressure is too high, the contact area between the tire and the ground decreases, leading to reduced tire grip, which can negatively impact the car's handling and driving stability.
1
2
Share

What is the Function of the Four-Wheel Drive Multi-Plate Clutch?

Function of the four-wheel drive multi-plate clutch: It can reduce gear shift delay in vehicles and significantly improve acceleration performance. The multi-plate clutch is a wet-type multi-plate slip-ring electromagnetic clutch that requires lubrication to operate. It features minimal friction plate wear, long service life, small radial dimensions, and high torque, making it widely applicable in mechanical transmission systems of equipment such as machine tools, steel rolling, metallurgical mining, metal rolling, material handling, and marine fisheries. Four-wheel drive refers to a vehicle maintaining a four-wheel drive configuration throughout the entire driving process, with the engine's output torque distributed to the front and rear wheels at a fixed ratio. This drive mode ensures excellent off-road and handling performance at all times.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.