···
Log in / Register

Where is the fog light switch on the Trumpchi GS8?

5 Answers
DeJulia
07/28/25 11:28pm

The fog light switch on the Trumpchi GS8 is located on the lever behind the left side of the steering wheel. The car's fog lights are installed at the front and rear, used for illuminating the road and providing safety warnings during rainy or foggy weather conditions, which can improve visibility for both the driver and surrounding traffic participants. The Trumpchi GS8 is a mid-size SUV under GAC Motor, with dimensions of 4835mm in length, 1910mm in width, and 1785mm in height, and a wheelbase of 2800mm. In terms of power, the Trumpchi GS8 is equipped with a turbocharged engine that delivers a maximum horsepower of 252 PS, a maximum torque of 390 Nm, and a maximum power output of 185 kW.

Was this review help?
14
2
Share
Gatsby
08/12/25 2:46am

I found that the fog light switch of the Trumpchi GS8 is located on the control lever to the left of the steering wheel, which is quite handy to operate. Just turn the knob to the position for the front fog lights, and for the rear fog lights, you might need to press a button after turning past a certain point. Having driven this car for two or three years myself, I often use the fog lights in rainy or foggy weather, and the effect is remarkable—it illuminates a large area in front of the car, significantly improving driving safety. The design positions it close to the steering wheel, so you don’t need to divert your attention to find it while driving, reducing the risk of accidents. I recommend that beginners practice operating it more—practice makes perfect. Improper use of fog lights can drain the battery or disturb others, so never leave them on in clear weather. It’s important to regularly check the switch’s responsiveness; sometimes, a stuck knob can prevent the lights from turning on, and a simple wipe to remove dust usually fixes it. If you encounter any issues, don’t panic—the owner’s manual always has detailed diagrams to help.

Was this review help?
9
5
Share
Expand All
JoelLynn
10/01/25 5:46am

For family users driving the Trumpchi GS8, safety comes first! The fog light switch is located on the stalk to the left of the steering wheel—just turn the knob to activate. After turning on the front fog lights, remember to check the rear fog light settings to avoid only one side illuminating. The placement is ergonomic, allowing operation without taking your eyes off the road—ideal for rainy or foggy emergencies. Fog lights aren’t decorative; turning them on in poor visibility helps spot obstacles ahead, especially during sudden highway fog. Familiarizing yourself with the switch beforehand can be lifesaving. Don’t forget to maintain the plug contacts—oxidation may cause flickering or failure. New drivers should spend a minute locating the switch to avoid hassle. Routine maintenance includes checking bulb brightness to prevent dim fog lights from compromising safety. The intuitive design is so simple even a child can understand it.

Was this review help?
8
0
Share
Expand All
McLily
11/14/25 7:34am

The control lever on the left side of the steering wheel is where the fog light switch is located. Simply turn the knob to activate it, which is a standard feature of the GAC GS8. The position is similar to other SUV designs, making it easy for users to transition. The knob is clearly marked, with distinct indicators for the front and rear fog lights, ensuring stable current during use. From an engineering perspective, integrated controls save space and improve efficiency. Quick operation is key to avoiding fumbling in bad weather. If the switch malfunctions, it might be a fuse issue—just open the handle and check the wiring.

Was this review help?
19
4
Share
Expand All
DiTessa
01/05/26 2:24am

When I first drove the GAC GS8, it took me a while to figure out the fog light switch, which I eventually found on the left-hand stalk of the steering wheel. Turning that small knob with clear position markings easily activated the front fog lights. The rear fog lights required an additional button adjustment, but became very handy once familiar. The intuitive position settings instantly boosted my sense of security when driving in rain. I recommend first-time users practice switching them a few times while parked to memorize the rotation direction. Keep the knob clean during daily use, as dust buildup can cause malfunctions. Remember, fog lights aren't meant for continuous use—activate them only in low visibility conditions to conserve battery.

Was this review help?
9
1
Share
Expand All
More Forum Discussions

What are semi-trailers and full trailers?

Trailers are divided into two types: full trailers and semi-trailers. A full trailer bears its total weight entirely by itself, while a semi-trailer shares part of its total weight with the towing vehicle. The differences between full trailers and semi-trailers are as follows: 1. The connection method with the towing vehicle differs. A full trailer connects its front end to the rear of the towing vehicle, which only provides pulling force without bearing weight. A semi-trailer rests the front half of its body on the fifth wheel coupling of the towing vehicle, with the rear axle of the towing vehicle bearing part of the trailer's weight. 2. Full trailers can increase cargo capacity, reduce fuel consumption, and thereby lower transportation costs. Semi-trailers must not exceed 17 meters in length, except for car carrier semi-trailers.
6
2
Share

Does the term 'vehicle passenger' refer to the front-seat passenger?

Passengers refer to individuals other than the driver. Below is more information about vehicle passengers: 1. In a 5-seat vehicle, there are 4 passengers. When purchasing insurance, there is a separate passenger insurance policy, and the number of policies required corresponds to the number of seats. For example, in a 5-seat vehicle, you need to purchase passenger insurance for 4 people. 2. If a traffic violation is captured by electronic monitoring, it generally refers to the passenger in the front seat. When the vehicle is in motion, the front-seat passenger should also wear a seatbelt. Most violations occur because the front-seat passenger is not wearing a seatbelt, and such violations typically result in a fine of 50 yuan without deducting points.
19
1
Share

Which gear is best for an automatic car when waiting at a red light?

When waiting at a red light with an automatic transmission, the following gear options are available: 1. D gear, hold the brake: Quick start, brake light stays on, prolonged braking can cause foot fatigue, consumes more fuel, and may cause car vibration. Recommended for short stops (a few seconds). 2. Shift to P gear, engage the handbrake: Slower start, safest option. Shifting from D to P usually passes through R gear, causing the reverse light to flash briefly. Recommended for slightly longer stops (around a minute). 3. N gear, hold the brake: Moderate start, safe, brake light stays on, slightly better for the car compared to D gear with braking. Can be adopted.
20
4
Share

Why can't a C1 license holder drive a motorcycle?

According to regulations, a C1 license holder cannot drive a motorcycle because it does not match the permitted vehicle types. To drive a motorcycle, one must hold an E, D, or F license. Permitted vehicle types for a C1 driver's license: The permitted scope of a C1 driver's license includes small and mini passenger vehicles, light and mini cargo vehicles; light, small, and mini special-purpose vehicles; and small passenger vehicles with seating capacity of 9 or fewer people. Vehicles that a C1 license holder cannot drive: large buses, tractors, city buses, medium-sized buses, large trucks, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, light motorcycles, wheeled self-propelled machinery, trolleybuses, and trams. Additionally, a C1 license holder cannot drive vehicles with more than 9 seats or trucks with a total length exceeding 6 meters. What is a C1 driver's license: A C1 driver's license is one of the codes for motor vehicle driver's licenses. The permitted scope of a C1 driver's license includes small and mini passenger vehicles, light and mini cargo vehicles; light, small, and mini special-purpose vehicles; and small passenger vehicles with seating capacity of 9 or fewer people. Age requirements: The minimum age to apply for a C1 driver's license is 18 years old, with no upper age limit. However, applicants aged 70 or older must pass tests on memory, judgment, and reaction abilities.
3
5
Share

Where are the position lights on a car?

The position lights of a car are located at the edges of the car's roof. Here is an introduction to car position lights: 1. Position lights are also called width lights, commonly known as small lights. 2. The function of position lights: Position lights are warning lights used to alert other vehicles. Literally, 'position' means warning, and 'light' refers to the outline, so position lights are warning lights used to alert other vehicles. 3. Position lights are generally installed at the edges of the car's roof, which can indicate both the height and width of the car. 4. There are two types of position light switches: rotary knob type and lever type. As shown in the figure above, the owner can find the gear to turn on the position lights according to the markings on the car. The lights that light up front and rear are the position lights.
4
1
Share

Why is there often a gear grinding sound when shifting into reverse?

Gear grinding sound when shifting gears, also known as gear clash during shifting, mainly occurs due to three reasons: 1. Clutch failure, which prevents proper disengagement, leading to gear clash during engagement. Not fully depressing the clutch pedal when shifting can cause gear damage. 2. Improper clutch usage, where gears are engaged before the clutch is fully disengaged. This results in a rattling sound and failure to engage the gear. Gear clash during shifting can cause lifespan damage to the transmission. 3. Shifting the gear lever back and forth when in neutral. This can lead to unnecessary wear of components and affect the timing of gear shifts. Skipping gears when upshifting. Upshifting should be done step by step to prevent loss of power continuity, while downshifting can skip gears.
2
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.