Where is the fog light switch on the Haval H6?

2 Answers
OEliana
08/27/25 3:32am
Haval H6's fog light switch is located on the light control knob to the left of the steering wheel. After turning on the position lights, the fog lights can be activated. Functions of fog lights: 1. Front fog lights are used to improve illumination when road conditions ahead are unclear and can alert oncoming drivers; 2. Rear fog lights help vehicles behind to spot your car in low visibility conditions. Taking the 2021 Haval H6 as an example, its body dimensions are: length 4615mm, width 1860mm, height 1720mm, wheelbase 2680mm, minimum ground clearance 182mm, and curb weight 1675kg.
Was this review help?
10
3
Share
VonDawson
09/09/25 2:41am
My experience finding the fog light switch on the Haval H6 left a deep impression. During my daily driving, I discovered it's conveniently located on the combination control lever below the left side of the steering wheel - just rotate it to the fog light icon position. The placement is thoughtfully designed, allowing easy access without distracting from driving. I mostly use it during rainy or foggy conditions to improve forward visibility, but it's crucial to remember never to turn them on during clear nights as they can dazzle other drivers and cause trouble. If the lights don't illuminate when activated, it might indicate a blown fuse or aging bulb that needs prompt attention - safety comes first. During routine maintenance, I make it a habit to test the fog lights to avoid unexpected failures on the road.
Was this review help?
6
0
Share
Expand All
More Forum Discussions

Is It Normal to Hear a Whistling Sound When Accelerating?

No, it is not normal. The unusual noise when accelerating is usually caused by the fuel pump or related components, and it could also be due to a damaged clutch release bearing. Below is some relevant information about the throttle: 1. Definition: In the internal construction of an engine, the device used to control the fuel supply in an internal combustion engine is called the throttle. 2. Function: The throttle can adjust the opening of the throttle valve inside the engine, thereby controlling the amount of combustible mixture, which in turn changes the engine's speed and power, allowing the car to accelerate or decelerate according to driving needs. 3. Electronic Throttle: The electronic throttle uses position sensors to transmit the degree of pedal depression, enabling electronic control of the throttle. Electronic throttles are highly precise and do not suffer from mechanical wear issues.
9
4
Share

Is the Car Thermostat Located on the Upper or Lower Hose?

The location of the car thermostat varies depending on the vehicle model. In some cars, such as the Volkswagen Lavida, the thermostat is located on the upper hose. In others, like the Jetta, Nissan Sylphy, and Corolla, it is positioned on the lower hose. The thermostat is a valve that controls the flow path of the coolant, functioning as an automatic temperature-regulating device. It typically contains a temperature-sensing component that opens or closes the flow of air, gas, or liquid through thermal expansion or contraction. Here are methods to determine whether the thermostat is functioning properly: Check after starting the engine: Open the filler cap of the coolant reservoir and observe if there is any water flow inside. If there is no flow, it indicates that the thermostat is damaged or debris is stuck between the main valve's opening and closing mechanism. Assess by feeling the temperature of the upper and lower hoses: Start the engine and after 3 minutes, touch the upper and lower hoses. If the thermostat is working correctly, the temperatures of the upper and lower hoses should differ—typically, the upper hose is hot while the lower one is cool. When the engine coolant reaches 90°C, both hoses should feel hot, confirming that the thermostat is intact. If the temperatures of both hoses remain the same after starting the engine, it indicates a faulty thermostat.
6
2
Share

Does Lexus Not Have Automatic Window Roll-Up Function?

Lexus does have an automatic window roll-up function. By long-pressing the lock button, the automatic window roll-up can be successfully set. Below are specific details about the automatic window roll-up function: 1. Function: The window roll-up device automatically closes the windows when the owner forgets to do so upon exiting the vehicle, also known as an automatic window roll-up device, to prevent forgetful owners from leaving their car windows open and risking theft. The window roll-up device is also referred to as a window closer, car automatic window closer, car window roll-up device, car automatic window roll-up device, etc. 2. Categories: The automatic window closer only activates after the car key is turned off and the engine is stopped, and the window closing function is effective only once. There are three modes for the automatic window closer: first, the windows automatically start closing immediately after the car key is turned off and removed; second, the windows automatically start closing after the car key is turned off and removed, and the driver's door is closed; third, the windows automatically start closing after the car key is turned off, the car door is closed, and the remote control is pressed.
13
0
Share

What does a single yellow light flashing continuously indicate?

A single yellow light flashing continuously indicates that vehicles that have already crossed the stop line may proceed. Below is relevant information about traffic signals: 1. Basic Introduction: Traffic signals are lights that direct traffic flow, typically consisting of red, green, and yellow lights. They are categorized into motor vehicle signals, non-motor vehicle signals, pedestrian crossing signals, directional indicator lights, lane signals, flashing warning signals, and railway crossing signals. 2. Control Methods: These can be divided into timed control, inductive control, and adaptive control. Timed control refers to traffic signal controllers at intersections operating according to preset timing schemes, also known as fixed-cycle control. Inductive control involves installing vehicle detectors at intersection approaches, where the traffic signal timing scheme is calculated by a computer or intelligent signal controller and can change in real-time based on traffic flow information detected by the sensors. Adaptive control treats the traffic system as an uncertain system, capable of continuously measuring its state.
7
0
Share

Can the Annual Inspection of the Vehicle License Be Handled Online?

Annual inspection of the vehicle license can be handled online: Step 1: Log in to the local "Online Vehicle Management Office" and click on "Online Services." Step 2: Directly select "Exemption from Inspection Vehicle Legal Inspection Mark (Six-Year Exemption)." Step 3: After opening, you will find "Data Registration." Click on it and accept the terms. Step 4: Click "Register" and complete the registration as required. After submission, the Vehicle Management Office will review the materials. If everything goes smoothly, the review will be approved in about a week. Vehicle License Annual Inspection Process: Required Documents: Original and duplicate of the vehicle license, proof of vehicle and vessel tax, original insurance card, original ID card. Check online for any traffic violation records and ensure they have been handled. Self-Service Procedure: Obtain the annual inspection form from the driving association and get it stamped. Take the form to the local traffic police team for another stamp. Then, proceed to the vehicle inspection line entrance, sign in, and enter the inspection line. Inspection items include front and rear brakes, parking brake, exhaust emissions, lights, and horn sound. After completing the inspection, proceed to the engine model number check. Collect the inspection results form in the office and pay fees for any failed items, re-inspection, and model number check. Finally, take the annual inspection form, inspection results form, and vehicle license to obtain the vehicle inspection certificate and update the validity period on the license. Submit the annual inspection form and inspection results form to the local Vehicle Management Office for archiving and renew the road and bridge IC card.
3
5
Share

What are the possible reasons for diesel engine starting difficulties?

Diesel engine starting difficulties are related to component failures. Below are detailed causes and solutions: 1. Air or water in the fuel system: Loose fuel pipe connections or worn fuel inlet pipes can allow air into the fuel system. Additionally, diesel fuel contains some water content. When there's excessive air or water, it affects normal engine starting. Solution: Inspect all pipelines for loose connections. Tighten any leaking parts and promptly purge air from the fuel lines. 2. Abnormal fuel supply: Empty fuel tank, closed fuel inlet valve, or clogged fuel tank vent due to dust/dirt. Solution: Refill sufficient diesel and open the fuel tank valve. 3. Clogged fuel pipes or diesel filter: Bent fuel pipes or long-uncleaned filter screens at pipe connections can cause fuel blockage. Solution: Remove obstructions from fuel pipes and clean the diesel filter after removal.
4
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.