Where is the fog light switch?

Does the vv6 have a new energy model?

vv6 does not have a new energy model, this car only has a pure gasoline version. Here is more information about this car: 1. vv6 is a compact SUV under the wey brand, this car is equipped with a 2.0-liter turbocharged engine across the entire lineup. The dimensions of the vv6 are 4625mm in length, 1860mm in width, and 1720mm in height, with a wheelbase of 2680mm. 2. The 2.0-liter turbocharged engine of the vv6 has a maximum power of 167kw and a maximum torque of 387 Nm, the maximum torque speed of this engine is 1800 to 3600 rpm, and the maximum power speed is 5500 rpm.

12

3

Share

How to Replace the Fuel Filter on Wuling Rongguang New Truck?

Drive the vehicle onto the maintenance platform and lift it approximately 30 cm off the ground. Shake the car to ensure it is secure and stable. Before replacing the fuel filter, release the pressure in the fuel line to prevent gasoline splashing. Remove the fuel pump relay from the fuse box and then start the vehicle. Lift the vehicle, use a spanner to remove the clamps at both ends of the fuel filter, then disconnect the fuel lines. Use a wrench to remove the clamps securing the fuel filter. After comparing the old and new fuel filters to confirm they match, install the new fuel filter, ensuring the correct orientation. Lower the vehicle, reinsert the fuel pump relay, start the vehicle, and check for any fuel leaks. If there are no leaks, the vehicle is safe to drive.

12

2

Share

How to Change BMW Maintenance Mileage?

BMW maintenance mileage change method: 1. Turn the ignition to the second position, then press and hold the protruding button on the lower left corner of the dashboard for about 8 seconds. 2. The oil or symbol will be displayed on the dashboard. 3. Release the button and then adjust to the oil symbol. 4. Hold the button without releasing to reset. Methods to avoid exceeding the maintenance mileage: 1. When the vehicle is approaching the maintenance mileage, the vehicle's information display system will usually prompt, so the owner should try not to continue driving. Although exceeding 500-1000km does not have a significant impact on the vehicle, it is still necessary to perform maintenance as required. 2. Before long-distance driving, it is best to check the technical condition of the vehicle and properly supplement the tire pressure to avoid accidents during driving. 3. For vehicles that have already exceeded the maintenance mileage, they should be sent to the repair shop for maintenance in time, otherwise the vehicle problems will become more serious.

14

3

Share

What is the method for matching the throttle on a Toyota Reiz?

Here is the specific method for matching the throttle on a Toyota Reiz: 1. Turn off the ignition switch and wait for at least 10 seconds. Fully release the accelerator pedal, then turn the ignition switch to the ON position and wait for 3 seconds. 2. Within 5 seconds, quickly repeat the following operation 5 times: fully depress the accelerator pedal and then fully release it. 3. Wait for 7 seconds, then fully depress the accelerator pedal and hold it in this position for about 20 seconds, until the MIL stops flashing and starts to stay lit. 4. Within 3 seconds after the MIL light stays on, fully release the accelerator pedal. 5. Start the engine and let it idle for a while. Allow it to idle for more than 20 seconds, then rev the engine two or three times to confirm that both the idle speed and ignition timing meet the specified requirements.

19

0

Share

What are the simplest ways to lower a car's body?

Here are the methods to lower a car's body: 1. Reduce the height of the shock absorber assembly. 2. Appropriately decrease the size of the rims and tires, which will lower the car's chassis. 3. Switch to wider and flatter tires. 4. SPR uses a dual-mode suspension, and you also need to replace the brackets that adjust the tire angle. Here is additional information: 1. After lowering the body, the suspension geometry carefully set by the original engineers is disrupted, and the stress on suspension components changes, potentially making them more prone to damage and causing issues like unwanted noises. 2. Lowering the body reduces the center of gravity and decreases the vehicle's body roll. However, reduced body roll does not necessarily mean better handling. Good handling means that during cornering, the tires maintain a larger contact area with the ground and stronger grip, which defines superior handling.

6

1

Share

What type of engine oil is used for the Peugeot 3008?

The Peugeot 3008 uses 5W30 engine oil. The functions of engine oil are: 1. To alleviate friction and high temperatures; 2. To cool and reduce temperature; 3. To clean and remove impurities; 4. To dampen vibrations and absorb shocks; 5. To prevent rust and corrosion. The Peugeot 3008 is a 5-door, 5-seat compact SUV with body dimensions of 4435 mm in length, 1840 mm in width, and 1652 mm in height, with a wheelbase of 2613 mm. The Peugeot 3008 is equipped with a 1.6L turbocharged engine, delivering a maximum horsepower of 167 PS and a maximum power output of 123 kW. It is paired with a 6-speed automatic transmission and features front-wheel drive. The front suspension uses a MacPherson strut independent suspension, while the rear suspension employs a torsion beam non-independent suspension.

18

2

Share

Where is the fog light switch?

Does the vv6 have a new energy model?

How to Replace the Fuel Filter on Wuling Rongguang New Truck?

How to Change BMW Maintenance Mileage?

What is the method for matching the throttle on a Toyota Reiz?

What are the simplest ways to lower a car's body?

What type of engine oil is used for the Peugeot 3008?

Is the Accord's Pedestrian Protection Covered by Insurance Claims?

What is the timing alignment method for the Citroen C-Quatre?

Why is water dripping under the car?

What causes the sunroof rattle in the Roewe erx5?