Where is the ETC installed in a car?
1 Answers
The installation position of ETC for small cars is generally in the upper middle part of the front windshield, while for large vehicles such as trucks and buses, it is installed in the middle to lower part. The appropriate installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with anti-explosion film or those that have it installed later, which may affect the signal transmission of the microwave communication link, the ETC should be installed in the microwave skylight strip. ETC is the abbreviation for Electronic-Toll-Collection, meaning electronic toll collection system. To apply for ETC, the vehicle owner needs to provide original and photocopies of their valid ID card and vehicle registration certificate. If the application is not made by the owner themselves, the agent's valid ID card is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also required, and the vehicle must be registered under an individual aged between 18 and 60. Here are some precautions for installing ETC: Do not obstruct the view; it is best to install it behind the rearview mirror: Many car models have windshields with a large rearward tilt angle, which can reduce the driver's field of vision. If this is not considered during ETC installation, it can increase the driver's blind spots. Installing it behind the rearview mirror on the right side can avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, during installation, avoid the black areas on the windshield and positions that may block the solar panel. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After the electronic tag is installed, the windshield will press the anti-removal lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to go to an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing area is 8 meters. To prevent the ETC device of the vehicle in front from malfunctioning, maintain a distance of more than 10 meters from the vehicle ahead to avoid automatic toll payment for the front vehicle. The ETC lane recognition speed is 20 kilometers per hour. If the speed is too fast, the vehicle device information cannot be read, leading to toll deduction failure. When using a debit card bound to ETC, insufficient balance will also cause toll deduction failure.
