Where is the engine serial number located on the Hongqi H5?

Which Fuse Causes Complete Power Loss When Blown in a Car?

When the main fuse of a car blows, it results in a complete loss of electrical power. Fuses are typically consolidated in a single location, known as the fuse box. Generally, vehicles are equipped with two fuse boxes: one located inside the engine compartment and another situated either on the left side of the steering wheel or inside the glove compartment. Below is relevant information about automotive fuses: 1. Function: Automotive fuses are a type of current fuse. When the circuit current exceeds twice the rated current of the fuse, it will blow within seconds, thereby protecting the circuit. They are commonly used for overcurrent protection in automotive circuits and also in industrial equipment. 2. Classification: Automotive fuses can be divided into three types: blade-type fuses, bolt-type fuses, and glass tube fuses.

20

5

Share

Is a Tire Pressure of 1.9 Normal?

A tire pressure of 1.9 is not normal, and it is recommended to inflate the tires promptly. To determine the appropriate tire pressure range for your car, you can check the fuel tank cap. Low tire pressure causes significant deformation of the tire sidewall during driving, accelerating the aging of internal steel wires and fabric layers, greatly reducing tire lifespan, and increasing the risk of a blowout. If you pay close attention, you may also notice an increase in fuel consumption. The recommended tire pressure varies depending on the vehicle model, and the specific tire pressure should follow the manufacturer's recommendations. The manufacturer's recommended values can usually be found in the following locations: 1. Vehicle user manual; 2. Label on the driver's side door; 3. Drawer next to the driver's seat; 4. Fuel tank cap door.

19

2

Share

How to Replace the Battery in an Audi Q5 Key Fob?

Audi Q5 key fob consists of two parts: the electronic key and the mechanical key. The specific steps to replace the battery in an Audi Q5 key fob are as follows: 1. Press the button on the back of the key fob to remove the mechanical key. 2. Remove the mechanical key to access the battery compartment. 3. Use force to pry open the battery compartment to reveal the coin cell battery. 4. Remove the old battery and replace it with a new coin cell battery. During installation, the coin cell battery should be inserted in reverse, with the positive side facing downward. 5. After installing the new battery, reassemble the key fob in its original position. 6. Insert the key fob into the car and hold down both the lock and unlock buttons simultaneously to reprogram it, indicating a successful replacement.

17

0

Share

How to Use Hazard Lights?

Hazard lights can only be used under certain special circumstances. There is a red triangular button in the car, and pressing this button will turn on the hazard lights. Hazard lights are essentially the left and right turn signals on the vehicle. When the hazard light switch is pressed, both the left and right turn signals will flash simultaneously. Turn signals are an important lighting system in a car. When changing lanes or making a turn, it is necessary to activate the turn signals in advance. Only in this way can drivers behind understand your intentions. Another important lighting system in a car is the brake lights. When the driver presses the brake pedal, the brake lights will illuminate, alerting drivers behind to maintain a safe distance and prevent rear-end collisions.

16

4

Share

Where is the daytime running light switch for the Bora?

The Bora does not have an independent switch for the daytime running lights. They turn on when the ignition key is turned and turn off when the key is removed. Daytime running lights are lamps installed at the front of the vehicle to make it more easily recognizable during daytime driving. These lights are not for illumination to help the driver see the road but rather to signal the presence of the vehicle to others, falling under the category of signal lights. The Bora has a body length of 4523 mm, width of 1775 mm, height of 1467 mm, and a wheelbase of 2610 mm. The Bora 1.4TSI Sport Edition is equipped with a 1.4TSI turbocharged engine from the EA111 series, produced by FAW-Volkswagen's Dalian engine plant.

3

0

Share

How to Install Software on the 10th Generation Civic?

The method for installing software on the 10th Generation Civic: Connect your phone to the car's Bluetooth and WiFi, then use your phone to find the website where the software is available for download. Simply click to download directly. Alternatively, you can seek professional installation services from online merchants or offline modification shops. The body dimensions of the 10th Generation Civic are 4649mm in length, 1800mm in width, and 1416mm in height, with a wheelbase of 2700mm. In terms of power, the domestically produced new Civic is equipped with either a 1.0T or a 1.5T turbocharged engine. The 1.5T engine delivers a maximum power of 177 horsepower and a peak torque of 220 Nm, paired with either a 6-speed manual or CVT transmission.

19

3

Share

Where is the engine serial number located on the Hongqi H5?

Which Fuse Causes Complete Power Loss When Blown in a Car?

Is a Tire Pressure of 1.9 Normal?

How to Replace the Battery in an Audi Q5 Key Fob?

How to Use Hazard Lights?

Where is the daytime running light switch for the Bora?

How to Install Software on the 10th Generation Civic?

What is the warning light for low coolant level in a car?

How to Determine if a Car is a Stock Vehicle?

What is the wheelbase of the BAIC Senova X35?

What is the engine model of the Chevrolet Equinox?