Where is the engine of the Jiangling Ford Territory produced?

1 Answers
GageFitz
07/30/25 7:05am
The engine of the Jiangling Ford Territory is produced in China. This model is equipped with a 1.5-liter turbocharged engine across the entire lineup, with the engine code JX4G15C6L, delivering a maximum power of 103 kW and a maximum torque of 225 Nm. The Jiangling Ford Territory is a compact SUV featuring a 1.5T L4 engine with turbocharged intake, paired with a 6-speed manual transmission. The vehicle's dimensions are 4580 mm in length, 1936 mm in width, and 1674 mm in height, with a wheelbase of 2716 mm. It is a 5-door, 5-seater SUV with front-wheel drive and electric power steering.
Was this review help?
11
1
Share
More Forum Discussions

How many kilometers should the brake fluid be replaced for the Volkswagen Passat?

Volkswagen Passat brake fluid replacement cycle is 50,000 kilometers, using the original FAW-Volkswagen brand, model BCN000750Z3. The following is an introduction to brake fluid: 1. When replacing, it must be replaced with brake fluid of the same level as the original vehicle, and the brake fluid level is marked on the brake fluid cap. For the selection of brake fluid, the same level must be used, and brake fluids of different brands cannot be mixed. 2. Automotive brake fluid is the liquid used in hydraulic brake systems. It does not cause chemical reactions, is not affected by high temperatures, and will not corrode, soften, or expand metal and rubber. The volume of brake fluid changes with temperature, so the brake fluid reservoir is equipped with a vent hole. The air sucked in from this hole contains moisture or impurities, and the moisture will be absorbed or dissolved by the brake fluid. Therefore, brake fluid containing moisture will have a lower boiling point.
10
0
Share

Can You Drive an Automatic Transmission Car with Both Feet?

It is not recommended to drive an automatic transmission car with both feet. Modern automatic transmission vehicles do not have a clutch pedal, eliminating the need to worry about coordinating the accelerator and clutch, making them a favorite in the new era. Some people prefer driving with both feet—using the left foot for braking and the right foot for acceleration—but this practice is actually unsafe. When performing complex operations, the brain's reflex efficiency slows down. In such situations, using both feet to operate the brake and accelerator can easily lead to mistakenly pressing the accelerator instead of the brake. Road accidents caused by this are quite common and often result in severe consequences. In automatic transmission cars, the left foot is typically not used, and interior designers even provide space for the left foot to rest. There is only one scenario where using both feet is acceptable: starting on a steep slope. In this case, the left foot can press the brake while the right foot applies the accelerator to assist in hill starts. In all other conditions, only the right foot should be used for operation! It is essential to correct the habit of driving an automatic transmission car with both feet.
10
5
Share

What are the dimensions of the new Volkswagen Magotan?

The length, width, and height of this car are 4866 mm, 1832 mm, and 1464 mm respectively, with a wheelbase of 2871 mm. Below are some details about the Magotan: 1. The Magotan is a mid-size sedan under the Volkswagen brand. Its body dimensions are typical for a mid-size sedan, and the car offers ample interior space. 2. The new Magotan is equipped with three engine options: a 1.4-liter turbocharged engine, a low-power 2.0-liter turbocharged engine, and a high-power 2.0-liter turbocharged engine. All three engines are paired with a 7-speed dual-clutch transmission. 3. The Magotan features a MacPherson independent front suspension and a multi-link independent rear suspension. Its exterior design is mature and understated, and the interior follows a similar design philosophy. 4. The car also delivers solid performance, with the 2.0T engine being highly efficient and offering excellent fuel economy.
9
3
Share

Where is the air filter located in the BMW X3?

BMW X3's air filter is located in a special position, inside the grid cover under the wipers. Below are the steps to remove the BMW X3 air filter: 1. Open the engine compartment cover. First, remove the two sealing strips to prevent them from hindering the removal process later. Then prepare to open the first layer of the cover by pulling the clip at the bottom left corner, and the first layer of the cover can be removed. 2. Next, disconnect the wiring harness. Hold the wire and the clip, and pull them out from the round hole on the right side. Pay special attention here: when pulling out the wiring harness, make sure to pull out both the clip and the wiring harness together, and never pull out only the wiring harness. 3. After completing steps 1 and 2, what remains is the grid-shaped plastic cover. Gently pull the clip upwards, then lift the entire plastic cover upwards to remove the grid cover. 4. When removing the air filter, hold the four clips to take out the filter and the plastic box together, and then you can remove the second layer of the filter.
12
1
Share

What is the tire pressure warning symbol for Volkswagen new cars?

Volkswagen new car tire pressure warning symbol is a yellow sign, an irregular circle with no seal on top, four small spikes at the bottom, and an exclamation mark inside. The tire pressure monitoring indicator light indicates abnormal tire pressure. Abnormal tire pressure generally has the following 3 reasons: Abnormal tire pressure: Generally, it will alarm when the pressure is below 1.8bar or above 3.0bar. At this time, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, the tire pressure was not reset in time, resulting in the tire pressure monitoring system still recording the original data, and the tire pressure monitoring indicator light will remain on. At this time, just perform a tire pressure reset. Damaged tire pressure sensor: The tire pressure sensor is used to monitor tire pressure, directly installed inside the tire and connected to the tire inflation port. If the tire pressure sensor is damaged during driving, it will also cause the tire pressure warning light to turn on. For sensor damage issues, only a brand new replacement can be installed.
15
3
Share

How to Turn Off the Auto Start-Stop Function in the Teramont?

To disable the auto start-stop feature in the Teramont, simply press the auto start-stop button (usually a circular arrow with the letter 'A'). The dashboard will display a notification indicating the system is turned off. To reactivate this function, press the button again. Below is some relevant information about the auto start-stop system: 1. The auto start-stop function automatically shuts off the engine when the vehicle comes to a temporary stop (e.g., at a red light) and restarts it when it's time to move again. Its English name is STOPSTART, abbreviated as STT. The STT intelligent fuel-saving system is a setup that controls engine start and stop operations. 2. The start-stop system works by detecting when the vehicle stops due to traffic congestion or at an intersection. When the driver presses the brake pedal and shifts to neutral, the Start/Stop system checks three conditions: the engine is idling and in neutral, the wheel speed sensors of the anti-lock braking system show zero rotation, and the electronic battery sensor confirms sufficient energy for the next start. If all conditions are met, the engine automatically stops. When the traffic light turns green, pressing the clutch pedal activates the start-stop system, quickly restarting the engine.
11
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.