Where is the Engine Control Module Located on the Great Wall Wingle 5?

1 Answers
AdelineRose
07/29/25 3:32pm
The engine control module (ECM) of the Great Wall Wingle 5 is located under the steering wheel on the driver's side. Below is some relevant information about the Great Wall Wingle 5: 1. Body dimensions: The Wingle 5 has a body length of 5395mm, width of 1800mm, height of 1730mm, and a wheelbase of 3350mm. The 'Big Double' version is 300mm longer than the 'Small Double' version. 2. Powertrain: The Wingle 5 is manufactured by Great Wall Motors, classified as a pickup truck. It is equipped with a 2.4L L4 engine featuring natural aspiration, delivering a maximum horsepower of 160ps and a peak torque of 230nm.
Was this review help?
8
0
Share
More Forum Discussions

How long is the NIO ES6 rear seat when folded down?

The NIO ES6 rear seat measures 1820mm when folded down. Here is some related information about folding down the rear seats in the NIO ES6: 1. The NIO ES6 rear seats can be folded down in a split ratio, with the release handle for folding the backrest designed on the outer shoulder of the seat. 2. When folded down, it provides an almost completely flat space. 3. There are two ways to fold down the rear seats: split-folding and full-folding. 4. Full-folding the rear seats means the backrest is a single unit. When more space is needed, the rear seat backrest can be folded down to provide additional room. However, when the rear seats are folded down, they cannot accommodate passengers.
19
2
Share

How to Check the Coolant Level?

Checking the coolant level mainly involves the following steps: 1. Park the car on a level surface, turn off the ignition key, engage the parking brake, and open the engine hood. 2. Carefully check whether the coolant in the overflow tank is between the minimum and maximum marks. 3. If the coolant level is below the minimum mark, inspect for any potential leaks. Additional Information: 1. Coolant, fully known as antifreeze coolant, is designed to prevent freezing. It prevents the coolant from freezing during cold seasons, which could otherwise crack the radiator or damage the engine cylinder block. 2. Antifreeze is not just for winter use; it should be used year-round. As part of regular vehicle maintenance, the engine coolant should be replaced annually.
5
1
Share

What Causes Trunk Water Leakage?

The reasons for trunk water leakage: 1. Worn or aged sealing strips or trunk deformation can cause trunk water leakage, which must be addressed promptly to avoid damaging components inside the trunk; 2. Sealing strips: The waterproofing of various parts of the vehicle body is ensured by sealing strips. These rubber-based sealing strips have certain strength and hardness but can deform under pressure and wear out due to frequent use, making them prone to damage. Solution: It is essential to clean the sealing rings multiple times during spring and autumn, using a damp cotton cloth for wiping. If the car is to be left unused for an extended period, remember to perform a thorough cleaning before storage to prevent natural aging during parking.
13
5
Share

Why Can't the Car Door Open?

Reasons why the car door cannot open: 1. The door lock cable is malfunctioning, and the door lock cable needs to be replaced; 2. The child lock is engaged. When closing the door, check if the child lock is disengaged. If the door still won't open, use a flathead screwdriver to turn the child lock to the off position; 3. The door hinge or lock post is deformed. After the door is subjected to external force, the hinge and lock post may become deformed. In this case, both the door and hinge need to be disassembled and replaced with new ones; 4. The door limiter is malfunctioning, requiring replacement with a new one.
15
2
Share

What to Do When the Oxygen Sensor Fails?

Solution for oxygen sensor failure: Simply replace it with a new one. The oxygen sensor is a crucial component in a car, installed near the catalytic converter. All vehicles are equipped with a catalytic converter, which is used to purify exhaust gases. There are oxygen sensors both before and after the catalytic converter. The oxygen sensor in front of the catalytic converter measures the oxygen content in the exhaust. This sensor sends data to the ECU, which can then adjust the air-fuel ratio based on this information. The oxygen sensor behind the catalytic converter checks whether the catalytic converter is functioning properly. If the data sent to the ECU by both the front and rear oxygen sensors are identical, it indicates that the catalytic converter has failed. In such cases, a warning light will illuminate on the car's dashboard to alert the driver.
20
3
Share

What type of car is Subaru?

Subaru is a car manufacturing company headquartered in Tokyo, Japan. The main models under Subaru include the Legacy, Tribeca, Trezia, Stella EV, Dex, Impreza, and Forester. Taking the Forester as an example, its body dimensions are 4560mm in length, 1780mm in width, and 1700mm in height, with a wheelbase of 2615mm. In terms of appearance, compared to the rugged and bold front ends of other SUVs, the Forester's wide and flat front end resembles that of a luxury sedan. The trapezoidal front grille design is conventional, and the nearly square headlight design is not particularly innovative, but it pairs well with the two deep metal lines on the engine hood, making it quite visually appealing.
20
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.