Where is the drainage hole of the Toyota C-HR door?
2 Answers
The drainage holes of the door are generally located at the lower edge of the door, usually with two drainage holes. New cars may have rubber plugs sealing them, which need to be removed after purchase. More relevant information is as follows: 1. Introduction: The Toyota C-HR is a compact SUV under the Toyota brand. The dimensions of this car are 4405mm in length, 1795mm in width, and 1565mm in height, with a wheelbase of 2640mm. This car is equipped with a 2.0-liter naturally aspirated four-cylinder engine across all models, with the engine code M20C. 2. Configuration: The Toyota C-HR uses a MacPherson independent suspension for the front and an E-type multi-link independent suspension for the rear. The multi-link suspension can improve the car's handling and ride comfort. The multi-link suspension is a structurally complex independent suspension, which is an improvement based on the double-wishbone suspension, replacing the two wishbones of the double-wishbone suspension with separate links.
I've been driving my Toyota C-HR for almost two years now, and I regularly check the door drain holes to prevent water accumulation and rusting inside the door panels. Finding these holes is actually quite simple—they're located at the very bottom edge of the door, usually near the door lock and hinge corners. If you crouch down or squat and look closely, you'll spot a few small round holes or narrow slots. These are designed to allow rainwater to drain naturally, preventing internal door damage. I recommend cleaning them periodically because if they get clogged, water can back up into the cabin, soaking the carpets and leading to mold. After washing your car, just use your fingers to clear any leaves or mud from these holes, and you're good to go. Though small, these drains are crucial—proper maintenance can even extend your car's lifespan.
