Where is the drainage hole of the Kodiaq door located?

1 Answers
Christina
07/30/25 4:37am
The drainage hole of the Kodiaq door is located under the door panel. Here is a related introduction about the door drainage hole: Concept: The vehicle drainage hole is the outlet for draining accumulated water from the vehicle during rainy days. Generally, the drainage holes of a vehicle are located in the following areas: in front of the engine compartment at the windshield, in the four corners inside the sunroof, at the lower part of the front and rear doors, inside the fuel tank cap, at the bottom of the spare tire in the trunk, and in the gaps between the front and rear headlights and the body fenders. Precautions: There is usually a drainage hole under the fuel tank cap. If it gets clogged, water may accumulate in the fuel tank during car washing or rainy weather, potentially causing damage to the fuel tank. The spare tire in the trunk is generally located in a relatively low part of the vehicle. When the car passes through water, if the water level rises above the headlights, water may seep in and reach the interior of the car. The drainage holes in this area are rarely used.
Was this review help?
7
5
Share
More Forum Discussions

Can a Manual Transmission Car Start Without Depressing the Clutch?

A manual transmission car can indeed start without depressing the clutch. Here is some relevant knowledge about starting a manual transmission vehicle: Depressing Both Brake and Clutch: The advantage of depressing both the brake and clutch is that even if the gear is not in neutral, the car won't suddenly lurch forward after starting. Mandatory Clutch or Brake Depress: Some car models require the driver to depress the clutch or brake before starting the engine; otherwise, the car won't start normally. This design is for safety reasons, preventing accidents caused by starting the car while it's still in gear. Benefits of Depressing the Clutch When Starting: Depressing the clutch when starting the engine protects the car's transmission system from sudden excessive load. When the clutch is depressed, the transmission is disengaged, especially in winter when the gear oil in the transmission is very viscous. Depressing the clutch also reduces the engine's load, making it easier to start the car and prolonging the engine's lifespan.
16
2
Share

What maintenance is needed at 40,000 kilometers?

At 40,000 kilometers, the following maintenance is required: check and replace engine oil and oil filter, air filter, and cabin air filter. Additionally, inspect and replace transmission fluid, brake fluid, power steering fluid, coolant, fuel filter, spark plugs, and brake system components. Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of a vehicle, also known as vehicle servicing. Modern car maintenance mainly includes the engine system, transmission system, air conditioning system, cooling system, fuel system, and power steering system. The purpose of car maintenance is to keep the vehicle clean, maintain normal technical conditions, eliminate potential hazards, prevent failures, slow down the deterioration process, and extend the service life.
4
1
Share

What car is the R logo?

The R logo represents Rolls-Royce, a British luxury car brand founded in 1906. Rolls-Royce produces numerous luxury sedans as well as premium SUVs. Its sedan lineup includes models like the Ghost and Phantom; coupes feature the Wraith and Dawn; while the SUV category is represented by the Cullinan. Taking the Rolls-Royce Dawn as an example, this convertible sports car has a wheelbase of 3112 mm, with length, width, and height measurements of 5295 mm, 1947 mm, and 1506 mm respectively. The Dawn is equipped with a 6.6L twin-turbocharged V12 engine across all variants, delivering a maximum power output of 420 kW and peak torque of 820 Nm. The engine reaches its maximum power at 5000 rpm and achieves peak torque at 1600 rpm.
12
3
Share

Is it better to turn on or off the ECO mode?

Whether to turn on the air conditioning ECO mode depends on the occupants' requirements for the indoor temperature. The air conditioning ECO mode is an energy-saving mode, which is used in the cooling state to reduce the power of the compressor by lowering the frequency of the air conditioning start and stop without affecting the cooling effect. The compressor does not operate at the maximum cooling power. The ECO mode will automatically turn off under the following conditions: 1. When the vehicle speed exceeds 120 kilometers per hour, the ECO mode will automatically turn off. 2. When idling in park or in N/P gear as well as in manual mode, the ECO mode may also become ineffective. 3. When a large torque output is required, such as when climbing a slope or operating under heavy load, the engine computer will ensure sufficient vehicle power to drive the vehicle, and the ECO mode will not work either.
2
2
Share

What are the steps to replace the low beam headlight on a Baojun 730?

The steps to replace the low beam headlight on a Baojun 730 are: 1. Turn the light switch to the 0 position, move the turn signal lever to the middle, and wait for the bulb to cool; 2. Open the engine hood and remove the headlight cover for replacement. Taking the 2021 manual fashion model Baojun 730 as an example, its body dimensions are: length 4780mm, width 1780mm, height 1740mm, wheelbase 2750mm, and fuel tank capacity 52l. The 2021 manual fashion model Baojun 730 features a MacPherson independent front suspension and a torsion beam non-independent rear suspension. It is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 105ps, maximum power of 77kw, and maximum torque of 135nm.
17
0
Share

How to Maintain a Car Chassis?

Elevate the car and use a high-pressure water gun to rinse the chassis. First, apply an engine exterior cleaner or engine degreaser to remove any adhered oil sludge and sand from the chassis, or use specialized sandpaper to grind off the original rust-proof layer. Use an air gun to blow out water from the gaps and dry the surface with a towel. Apply a rust-proof treatment layer, using masking paper and tape to cover the areas around the tires and exhaust pipe. Spray the chassis rust-proof material onto the chassis in layers, applying at least three coats with a thickness of approximately 3 millimeters. Here is more information about the car chassis: 1. The chassis refers to the combination of the transmission system, running system, steering system, and braking system in a car. It supports and installs the car engine and its various components and assemblies, forming the overall shape of the car, bearing the engine's power, and ensuring normal operation. The role of the chassis is to support and install the car engine and its various components and assemblies, forming the overall shape of the car, receiving the engine's power, enabling the car to move, and ensuring normal operation.
9
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.