Where is the diagnostic port located on the C4L?

1 Answers
Avery
07/30/25 9:18am
The OBD port of the Citroën C4L is located in front of the gear shift lever, near the USB port and cigarette lighter. You can find the OBD port by prying open the cover with your finger in the small hole. Below is some relevant information about OBD: 1. Introduction: OBD stands for On-Board Diagnostic, which is an in-vehicle automatic diagnostic system. This port can be connected to a diagnostic computer to read the car's fault codes, making it an important interface in the vehicle. 2. Function: The on-board diagnostic system continuously monitors the engine's operating conditions and the working status of the exhaust after-treatment system. If it detects any situation that might cause excessive emissions, it will immediately issue a warning. The OBD system stores fault information in memory, and this information can be read in the form of fault codes through standard diagnostic tools and interfaces. Based on the fault code prompts, maintenance personnel can quickly and accurately determine the nature and location of the fault.
Was this review help?
16
3
Share
More Forum Discussions

What is the phenomenon of body movement?

When a car travels in a straight line on the road, the movement of the car body is a translational phenomenon, while the rotation of the steering wheel is a rotational phenomenon. The car steering wheel is a control component that belongs to the steering system of the entire vehicle. The principle of the entire steering mechanism is to convert circular motion into linear motion through a rack and pinion, thereby pushing the wheels to rotate. Relevant information about the car steering wheel is as follows: 1. Function: Its function is to convert the force applied by the driver to the edge of the steering wheel into torque and then transmit it to the steering shaft. 2. Correct grip: If the steering wheel is regarded as a clock face, the correct hand position is to place the left hand between the 9 and 10 o'clock positions and the right hand between the 3 and 4 o'clock positions. In the event of a collision, this posture is more conducive to supporting the body.
14
3
Share

What are the reasons why the BYD G5 won't start?

The reasons why the BYD G5 won't start are as follows: 1. The battery is dead or the fuel tank is empty; 2. The gear is not in the correct position or the steering wheel is locked, preventing startup; 3. Automotive circuit or electronic failure, such as damaged spark plugs, blown fuses, or fuel pump malfunction. 4. Fuel quality issues, where poor-quality fuel causes the engine to malfunction. Additional information: 1. Human operational reasons: dead battery, empty fuel tank, incorrect gear position; 2. Vehicle usage reasons: improper fuel, lack of antifreeze, excessive carbon buildup. A dead battery may result from leaving the headlights on for an extended period or the battery reaching the end of its lifespan. Installing xenon headlights, high-power audio systems, or DVD players can also cause vehicle circuit failures.
3
4
Share

Where is the air conditioning relay located in the Buick Encore?

Buick Encore's air conditioning relay is located in the fuse box: 1. The function of the relay is to control the start and stop of the air conditioning. When the interior temperature reaches the target temperature, the sensor will instruct the relay to stop the air conditioning's cooling operation; 2. When the interior temperature rises above the set temperature, the sensor will instruct the relay to start the air conditioning's cooling operation; 3. In a circuit, a relay is a device commonly used as a switch. Based on the type of control voltage required for its coil, relays can be divided into AC relays and DC relays; 4. The specifications of a relay are indicated by the coil control voltage and contact current. Generally, when the load current is less than 10A, the relay's contacts can be used directly to connect or disconnect the circuit.
7
2
Share

What are the basic requirements for driving specialized motor vehicles within the factory premises?

There are several basic requirements for driving specialized motor vehicles within the factory premises: 1. Introduction: Operators of factory motor vehicles are classified as special operation personnel, and their qualification assessment and certification are organized by safety administrative departments at the municipal level or above. 2. Physical requirements: Drivers must be in good health, pass training and examinations, and hold a valid license to drive. 3. No lending of credentials: Driving licenses should not be lent to others, and drivers should not operate vehicles that do not match the specifications of their license. 4. Driving requirements: Drivers must comply with traffic rules and operational procedures, inspect the vehicle's condition before driving, and promptly address any potential hazards; otherwise, the vehicle should not be driven. Drivers must strictly adhere to safety protocols, maintain equipment in good condition, and ensure safe driving.
1
3
Share

Is It Necessary to Use a Car Cover?

It is necessary to buy a car cover for your vehicle. In summer, it can provide sun protection, preventing direct sunlight from damaging the car paint and interior, thereby delaying the aging of both. Below are specific details about car covers: 1. Function: The primary purpose of a car cover is to protect the car paint and windows from direct sunlight exposure. It can also shield the car from rain, snow, and falling leaves, while serving a cleaning function. 2. Usage Notes: When using a car cover, it is best to apply it after the car has been parked, cooled down, and washed. The cover should be the right size for your car to be effective. It is important to note that if the car cover gets dirty, it must be washed before the next use; otherwise, it may have the opposite effect, allowing dirt to stick to the car continuously.
7
3
Share

Where is the trunk switch located on the all-new Bora?

The trunk switch of the all-new Bora is located below the driver's door armrest, above the door storage compartment, with a trunk capacity of 490L and 506L. Method to open the trunk: gently lift the trunk button to open it. If the button fails, you can also use the key to unlock it directly. Some models have a trunk unlock switch on the key, which can be pressed directly to open. The all-new Bora is built on Volkswagen's MQB A1 platform and is the first China-exclusive model on this platform. It adopts Volkswagen's new family-style design, featuring an integrated front face design and raised waistline. The wheelbase of the all-new Bora has been increased by 74 mm, reaching 2688 mm, and the body dimensions are 4663 mm in length, 1815 mm in width, and 1462 mm in height.
12
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.