···
Log in / Register

Where is the cruise control button on the BMW X1?

4 Answers
DeAlice
07/29/25 12:39pm

The cruise control button on the BMW X1 is located on the left side of the steering wheel. The operation steps to activate cruise control are as follows: 1. There are three buttons on the left side. Press the bottom button, then accelerate to over 30 km/h to activate the BMW X1's cruise control function. 2. Press the middle rocker button to set the speed. The top button is labeled LIM, which is a speed limit reminder. Below is an introduction to cruise control: Cruise control devices are now available in many cars, abbreviated as CCS. The main function is that after the driver activates the cruise control function, the car can automatically maintain the set speed for uniform driving without the driver needing to press the accelerator pedal. Using this function allows drivers to avoid pressing the accelerator pedal during long-distance highway driving, thereby reducing fatigue and unnecessary speed changes, which can lower fuel consumption. When the driver uses cruise control, stepping on the brake pedal will cancel the function if needed.

Was this review help?
6
1
Share
LaBarrett
08/14/25 12:34am

I worked at a BMW 4S dealership for many years. The cruise control button for the BMW X1 is usually located on the left control stalk of the steering wheel, near the turn signal lever, marked with SET or LIM. In newer models, it might be integrated into the steering wheel button area. Remember to press and hold the SET button to set the speed, and ensure the vehicle speed is stable above 30km/h when operating. Avoid using it too frequently in rainy weather. I've driven many test vehicles and found the steering wheel button design quite intuitive, especially convenient for long-distance driving. Pressing the stalk up or down adjusts the speed for automatic cruising. It's advisable to check the owner's manual for any year-specific differences to reduce safety risks from misoperation.

Was this review help?
10
4
Share
Expand All
AmirLynn
10/09/25 5:05am

I often take road trips in my BMW X1, and its cruise control button is located on a small lever on the left side of the steering wheel, resembling a tiny control stick. It's very easy to operate—just press the SET button to activate cruise mode, then manually adjust the speed using the up and down buttons. I've tried setting it to 110km/h on the highway for long drives, which is very effortless. However, I must remind everyone to stay safe and avoid using it in urban areas or congested roads to prevent accidents due to brake failure. Additionally, BMW's design is more user-friendly compared to other models, with the button positioned close to the driver's line of sight to minimize distraction. If any issues arise, remember to have the circuits or button wear checked by a professional shop.

Was this review help?
8
4
Share
Expand All
StElena
11/22/25 6:20am

As a mom who often drives with kids, I found the cruise control button on the left side of the BMW X1 steering wheel. It's a lever or button with a SET mark. After activation, just press SET to set the speed, which is very convenient and practical for daily child pickups on the highway.

Was this review help?
3
0
Share
Expand All
More Forum Discussions

Can I Get My License Plate on the Same Day I Pick Up My New Car?

As long as all the required documents are prepared, it is possible to get the license plate on the same day you pick up your new car. Documents required for license plate registration: ID card, vehicle certificate of conformity, vehicle parameter sheet, second and fourth copies of the car invoice, vehicle purchase tax, car insurance policy, purchase invoice, vehicle certificate of conformity, ID card or organization code certificate and its copy for invoice issuance, compulsory traffic insurance policy, tax payment certificate, and temporary residence permit for non-local residents. License plate registration process: After preparing the materials, go to the vehicle management office to submit the documents, sign as the owner, undergo an external inspection and confirmation by the traffic police, choose the license plate number, receive the receipt, install and photograph the fixed license plate, and collect the vehicle license and registration certificate.
17
3
Share

What is the starting current of a motorcycle?

Motorcycle starter motors generally have a power range of 200-500W. Introduction to motorcycle motors: The starter on a motorcycle engine is essentially an electric motor, with motorcycle starters typically operating at over 2000 RPM. Motorcycle starter motors generally have a power range of 200-500W. Under rated load, the operating current can be as low as 40-50A for smaller models, while larger ones may exceed 100A. The braking current of the motor can reach as high as 100-250A. Function of motorcycle motors: A motorcycle engine converts the thermal energy generated by igniting the fuel-air mixture in the cylinders into mechanical energy. This power is then transmitted through the crankshaft and drivetrain to the rear wheel, providing the driving force for the vehicle.
16
5
Share

Should the Engine Be Turned Off When Refueling?

When refueling a car, the engine should be turned off. The concentration of the fuel-air mixture around the vehicle's fuel tank increases, and if it encounters a spark, the gasoline molecules in the air can ignite, leading to a fire. Below are the hazards of refueling without turning off the engine and precautions to take when refueling: Hazards of Refueling Without Turning Off the Engine: When refueling at a gas station, if the vehicle's engine is not turned off, even though the car is stationary, the engine continues to run at high speed. A running engine inevitably involves electrical current flow, and if a short circuit or leakage occurs in the circuit at this time, it can be extremely dangerous. Precautions When Refueling: Before refueling, the vehicle must enter the gas station at a slow speed and exit slowly after refueling. During refueling, the vehicle must be turned off before fueling begins. Additionally, if the gas station attendant has not turned off the fuel nozzle, the car must absolutely not be started during the refueling process.
5
5
Share

Does an occasional sudden brake affect the car?

An occasional sudden brake does not harm the vehicle. Introduction to sudden braking: When you brake suddenly, the ABS braking assistance system and EPS electronic stability system will activate to maintain the normal operation of the vehicle. An occasional sudden brake, apart from causing relatively greater wear on the brake friction pads and tires, and consuming a bit more fuel when restarting, has minimal other damages that can be practically ignored. Hazards of frequent sudden braking: Frequent sudden braking can cause significant damage to the vehicle, mainly manifested in tire wear, brake pad wear, impact deformation of the suspension system, and impact damage to the transmission system.
8
4
Share

Where is the USB port of the Audi Q3?

Audi Q3 USB port is located inside the center armrest. Owners can connect a USB drive using the provided data cable. The base model does not have a USB port, but music can be played via Bluetooth connection with a smartphone. Alternatively, owners can download their favorite music onto an SD card and insert it into the car's SD card slot to play the downloaded music. The Audi Q3 is an SUV based on the same PQ35 platform as the Volkswagen Tiguan. Positioned below the Q7 and Q5 in Audi's model lineup, the Q3 has been tuned to deliver a more dynamic driving performance and features a luxurious, distinctive exterior design. It comes equipped with adaptive dampers, similar to those used in the TT model, to differentiate it from Volkswagen vehicles.
8
4
Share

What brand of tire is green?

green is an environmentally friendly tire model from Michelin. Tire introduction: Tires are circular elastic rubber products mounted on various vehicles or machinery, installed on metal rims to support the vehicle body, cushion external impacts, achieve contact with the road surface, and ensure the vehicle's driving performance. Tires are used under complex and demanding conditions, enduring various deformations, loads, and high and low temperatures during operation, possessing high load-bearing, traction, and cushioning properties. Tire functions: Tires transmit driving force, braking force, and steering force to enable vehicle operation; support vehicle loads; reduce and absorb vibrations and impacts during driving, preventing severe vibrations from damaging vehicle components. Tires are circular elastic rubber products mounted on various vehicles or machinery, installed on metal rims to support the vehicle body, cushion external impacts, achieve contact with the road surface, and ensure the vehicle's driving performance.
16
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.