Where is the coolant location in the Magotan?

[LaRyan]

The coolant in the Magotan is located in a small pink liquid reservoir on the left side of the engine compartment. The filling position is in the middle of the reservoir, marked by two horizontal lines. If the fluid level is below the "MIN" mark, coolant should be added immediately. Coolant replacement method: Before completely replacing the coolant, conduct a thorough inspection to check for any signs of leaks or cracks in the pipes, with a special focus on the five-way hose. The five-way hose gets its name from having five connection interfaces to various parts. The coolant flows through the five-way hose and is then distributed to different parts of the car to function. If there are any signs of coolant leakage in this section, replace the hose or re-secure the interface as needed. Drain the old coolant, then flush the liquid channels with clean water. Add clean water to the coolant reservoir, then continue filling the reservoir with water so that it continuously flows through the engine cooling system. Start the engine and let it idle for 3 to 5 minutes to circulate the water. Initially, the water flowing out of the reservoir will have a faint pink tint. Continue adding clean water until clear water flows out. Note: Remember to disconnect the heater hose to drain all water from the heater core. Approximately one hour after draining, add the new coolant through the radiator hose, which allows the coolant to flow quickly into the radiator. Then, add another container of coolant to the reservoir until it is nearly full. Start the engine and let it run for about 10 minutes. During this time, the coolant level will drop slightly as air is purged from the cooling system. Top up the coolant to the "MAX" mark on the reservoir.