Where is the computer interface of Peugeot 408 located?

Where to Look When Straightening the Steering Wheel at the Exit of an S-Turn?

The angle between the A-pillar on the driver's side and the lower edge of the windshield aligns with the left boundary line of the S-curve, indicating that the vehicle is centered in the S-curve. Therefore, when using this technique to follow the line, upon reaching the exit and when the vehicle body is nearly parallel to the lane exit, you can straighten the steering wheel to exit the test area. During this process, lightly press the brake or clutch to control the speed, as steering too slowly may cause the vehicle to cross the solid line of the curve. Below are relevant details about the S-curve in Subject 2: 1. Practical Operation Method: Before entering the left curve, drive the vehicle close to the right side, keeping the right side of the car aligned with the right boundary line. When preparing to transition to the right curve, turn the steering wheel to the right, aligning the left front corner of the car with the left boundary line until the vehicle safely exits the curve, then straighten the steering wheel. 2. New Requirements: Driving over the edge line of the road results in failure; stopping midway results in failure; driving without shifting to second gear or above results in a 5-point deduction.

16

3

Share

Can I turn left if the left turn signal is off?

If the left turn signal is not working, turning left is not considered a traffic violation and will not result in penalties or demerit points. Even if it is mistakenly judged as running a red light, you can apply for administrative reconsideration at the traffic police department to have the violation revoked. Since the violation was caused by a malfunctioning traffic signal, the traffic police department will review the case and, if confirmed, will not impose any penalties. Below is relevant information: 1. Solution: When traffic is light, you can stop and observe the pattern of the traffic lights, waiting until the left turn signal turns green before proceeding. If the pattern of the left turn signal cannot be determined, you should first use a dashcam or phone to record the malfunctioning left turn signal and proceed to turn left when it is safe. 2. Turn Signal: The turn signal is an important indicator light that is activated when a vehicle is turning to alert surrounding vehicles and pedestrians. The turn signal bulb uses a xenon tube, controlled by a microcontroller circuit, and operates with an alternating left-right flash pattern continuously.

1

5

Share

What does a band brake mean?

It utilizes friction to reduce rotational speed, achieving the purpose of deceleration and stopping. More extended information is as follows:1. Band Brake: The principle of a band brake is basically the same as that of an expanding brake, but structurally, the brake lining is on the outside while the hub is on the inside. When the brake pedal is pressed, the brake lining clamps inward to embrace the hub.2. Expanding Brake: Mainly composed of brake linings and a brake hub, the brake hub is a circular, hollow metal disc, resembling the shape of a cooking pot lid, with its center point connected to the wheel or axle; inside the hub, there are two semi-circular brake linings that meet. Since the brake linings are semi-circular, the two pointed ends of each lining correspond to each other. One end of the meeting point is a cylindrical shaft, and the other end is an oval shaft. When the brake is pressed, the oval shaft rotates, causing the semi-circular brake linings to separate outward, and the outer side of the linings rubs against the hub, creating resistance to reduce speed.

13

5

Share

What is the wheelbase of the Nissan Qashqai?

The Nissan Qashqai is a compact SUV launched by Dongfeng Nissan in September 2021, with a wheelbase of 2646mm, complying with the China VI emission standard. In terms of body dimensions, the vehicle has a length of 4401mm, a width of 1837mm, and a height of 1611mm. In terms of power, it is equipped with an MR20 transversely mounted naturally aspirated engine, paired with a 7-speed continuously variable transmission (CVT), delivering a maximum horsepower of 151Ps, a maximum power of 111kW, and a maximum torque of 194N·m. Dongfeng Nissan Passenger Vehicle Company consists of the Huadu Plant, Xiangfan Plant, Engine Division, and R&D Center. After the completion of the new plant, Dongfeng Nissan Passenger Vehicle Company has two plants in Huadu and Xiangfan, with an annual production capacity of 250,000 vehicles. Established on June 16, 2003, Dongfeng Nissan Passenger Vehicle Company is an important passenger vehicle division under Dongfeng Motor Co., Ltd., engaged in the R&D, procurement, manufacturing, sales, and service of NISSAN brand passenger vehicles, making it one of the domestic automotive enterprises with a complete value chain.

2

4

Share

How to Align the Timing for Citroen C-Quatre?

The method to align the timing for Citroen C-Quatre is: 1. Remove the timing cover and rotate the crankshaft, observe the holes on the camshaft, slowly rotate to align with the corresponding holes on the cylinder head, then insert a special tool to fix the camshaft; 2. The crankshaft positioning hole is located at the rear of the engine, find the upper part near the transmission end of the right-side half shaft, and insert a special tool to fix the crankshaft; 3. Adjust the pointer to the middle position, use a hex key to fine-tune and select the middle position, then fix and tighten the screw. Taking the 2016 Citroen C-Quatre Classic 1.6L Automatic Tech Edition as an example: it is a compact 4-door 5-seater sedan with dimensions of 4588mm in length, 1773mm in width, and 1486mm in height, a wheelbase of 2610mm, equipped with a 4-speed manual transmission, and a top speed of 186 km/h.

11

5

Share

How Long Does It Take for an Automatic Transmission to Fail After Water Intrusion?

Transmission failure symptoms do not appear immediately after water intrusion but gradually manifest within two weeks. Water entering the transmission can cause internal components to rust and degrade the transmission fluid. If the friction plates absorb water, they cannot be repaired and must be replaced along with other sealing components, increasing repair costs. Symptoms of water in the transmission include: 1. Minor water intrusion: Some screws inside the transmission may rust. It is advisable to replace gaskets, oil seals, and other components to extend service life, along with replacing the transmission fluid and differential oil. 2. Moderate water intrusion: White deposits appear in the oil pan. When oil mixes with water, it forms a white emulsion that adheres to the oil pan. The presence of such deposits indicates moderate water intrusion. Gaskets, oil seals, transmission fluid, and differential oil must be completely replaced. 3. Severe water intrusion: The color and viscosity of the transmission fluid can indicate severe water damage. Water in an automatic transmission can corrode steel screws inside the transmission, necessitating prompt inspection and repair. Similar to moderate intrusion, severe cases may also require replacing the sprocket.

16

3

Share

Where is the computer interface of Peugeot 408 located?

Where to Look When Straightening the Steering Wheel at the Exit of an S-Turn?

Can I turn left if the left turn signal is off?

What does a band brake mean?

What is the wheelbase of the Nissan Qashqai?

How to Align the Timing for Citroen C-Quatre?

How Long Does It Take for an Automatic Transmission to Fail After Water Intrusion?

Should Mercedes-Benz Change Brake Fluid Every Two Years?

What Lights to Turn on When Driving in Foggy Weather?

Can the Trumpchi Shadow Leopard be equipped with a rear wing?

What is the fuel consumption per kilometer for Honda cars?