Where is the cigarette lighter fuse of Chery A3?

What are the deceleration markings on the highway?

Deceleration markings on the highway can be divided into horizontal deceleration markings and longitudinal deceleration markings. Introduction to deceleration markings on the highway: These are white dashed lines set up in toll plaza areas, exit ramps, or other sections where vehicle deceleration is required. They come in forms such as single dashed lines, double dashed lines, and triple dashed lines, perpendicular to the direction of travel. Horizontal deceleration markings consist of a set of parallel white dashed lines, while longitudinal deceleration markings consist of a set of diamond-shaped dashed lines parallel to the lane dividing lines. When encountering deceleration markings, it is essential to slow down to avoid rear-end collisions, especially in sections with longitudinal deceleration markings, where drivers may visually perceive the lane as gradually narrowing. Additional information on deceleration markings on the highway: The driving speed on the highway should not be lower than 80 km/h or exceed 120 km/h. Due to the high speeds, traffic accidents are more likely to occur. Pay attention to speed limit signs and drive within the prescribed speed range. Do not exceed the maximum speed limit and ensure you are driving in the appropriate lane. Additionally, speed limits on highways are segmented, requiring drivers to be particularly attentive to speed limit signs.

4

1

Share

What does the yellow triangle exclamation mark on the Passat mean?

If a yellow triangle exclamation mark appears on the dashboard, it may indicate a fault in the braking system. When this light comes on, first check if the handbrake is fully released; if the light remains on after releasing the handbrake, you need to check whether the brake fluid level is normal or if the brake pads are too thin. Here is more information about the dashboard exclamation mark: 1. A triangle with an exclamation mark in the middle: This is a general fault indicator light. It may illuminate under the following conditions: overheating of the dry dual-clutch transmission clutch; fuel cutoff system intervention or failure; parking sensor fault; external light fault; engine oil pressure sensor fault; traction control system warning or fault. 2. A circle with parentheses and an exclamation mark in the middle: This is the brake system warning light. It may illuminate under the following conditions: some vehicles may light up for a few seconds after turning on the ignition and turn off after starting the engine; it lights up when the handbrake is pulled up and turns off when released; low brake fluid level, lighting up during driving; brake system failure.

8

3

Share

Will Traffic Police Check Black Roof Film?

Generally, traffic police do not check black roof film. Here is some relevant information about car film: 1. Introduction: Car film refers to a thin layer of material applied to the front and rear windshields, side windows, and sunroof of a vehicle. This material is also known as solar film or explosion-proof heat insulation film. 2. Functions: It mainly blocks ultraviolet rays, reduces heat, prevents injuries caused by sudden glass breakage, and reduces glare. Additionally, due to the one-way transparency of solar film, it helps protect personal privacy. Furthermore, it can minimize damage to items and passengers inside the car caused by UV exposure. Through physical reflection, it lowers the interior temperature, reduces the use of car air conditioning, thereby decreasing fuel consumption and saving some expenses.

11

4

Share

How to deal with a scratched car rearview mirror?

If the car rearview mirror is scratched, you can purchase a touch-up paint pen. Start spraying the paint from a certain distance from the scratch, and the sprayed paint can make the car body's paint more even to solve the problem. Additional information: 1. The function and regulations of rearview mirrors: Rearview mirrors are tools that allow the driver to directly obtain external information about the rear, sides, and lower parts of the car while sitting in the driver's seat. For the convenience of the driver's operation, to prevent traffic safety accidents, and to ensure personal safety, all countries require that cars must be equipped with rearview mirrors, and all rearview mirrors must be adjustable in direction. Rearview mirrors have a field of view issue, which refers to the range that the mirror surface can reflect. 2. Three elements of the field of view: The industry has proposed three elements of the field of view, namely the distance between the driver's eyes and the rearview mirror; the size of the rearview mirror and the radius of curvature of the rearview mirror. There is a certain relationship between these three elements. When the distance and size of the rearview mirror are the same, the smaller the radius of curvature of the mirror surface, the larger the field of view reflected by the mirror surface. When the radius of curvature of the mirror surface is the same, the larger the size of the mirror surface, the larger the field of view reflected by the mirror surface.

1

4

Share

What Causes Vehicle Vibration Between 70 and 80 km/h?

Vehicle vibration between 70 and 80 km/h may be caused by aging or damage to the engine or transmission mounts. Common causes of vehicle vibration: Throttle body issues. The main reason for a dirty throttle body is carbon buildup at the junction between the throttle valve shaft and throttle body, resulting in imprecise throttle opening and causing idle vibration. You can clean the throttle body; if vibration persists after cleaning, the throttle body may be damaged and require replacement. Fuel quality problems. Poor gasoline quality can lead to inadequate atomization by the fuel injectors, causing incomplete combustion of the air-fuel mixture in the cylinders and resulting in idle vibration. It's recommended to use higher-grade gasoline after consuming the current tank and perform a fuel system cleaning. Definition of transmission: A transmission is a gearbox that changes the transmission ratio and direction of motion. Located between the clutch and central drive, its main functions are to alter the vehicle's driving force and speed (gear shifting) while maintaining constant engine speed and torque, enable reverse driving (direction change), and allow the engine to idle when stopped (neutral gear). Based on transmission types, gear transmissions can be categorized into three types: dual-shaft, triple-shaft, and compound configurations.

20

0

Share

Can Vehicle Annual Inspection Be Processed in Another Location?

Motor vehicles can undergo annual inspection in another location, but the regulations vary by region, and the specific procedures are also different. Vehicle annual inspection refers to the annual examination of vehicles that have already obtained official license plates and registration certificates, conducted according to the technical conditions for the safe operation of motor vehicles. The purpose is to check the main technical conditions of the vehicle, encourage enhanced maintenance, ensure the vehicle is always in good condition, and guarantee driving safety. New regulations for cross-regional annual inspection: Cross-provincial annual inspection for small cars, trucks, and medium-sized buses has been fully implemented. However, it is important to note that large passenger vehicles and school buses cannot be inspected in another location and must return to the vehicle's registered location for inspection. Process for cross-regional annual inspection: Obtain a vehicle inspection authorization letter: A notice of authorization for inspection needs to be issued by the vehicle management office in the original registration location. The owner can have a friend handle this on their behalf in the original registration location. Materials required for the authorization letter: Owner's ID card, vehicle registration certificate, vehicle insurance documents, original and copy of the vehicle and vessel tax, and an application for cross-regional annual inspection. Once the materials are prepared, the owner can go to the local vehicle management office to query the relevant vehicle information. After confirming the vehicle's authorization for cross-regional annual inspection, the normal cross-regional annual inspection can be processed.

18

5

Share

Where is the cigarette lighter fuse of Chery A3?

What are the deceleration markings on the highway?

What does the yellow triangle exclamation mark on the Passat mean?

Will Traffic Police Check Black Roof Film?

How to deal with a scratched car rearview mirror?

What Causes Vehicle Vibration Between 70 and 80 km/h?

Can Vehicle Annual Inspection Be Processed in Another Location?

How to Check If a Vehicle Has Been Transferred to Someone Else?

What Are the Reasons for Abnormal Noises in Car Brakes?

What are the differences between the Ford Kuga and the Kodiaq?

What to Do If the New Car's Paint Gets Scratched?