···
Log in / Register

Where is the cigarette lighter fuse located in the Lavida?

4 Answers
DakotaRose
07/29/25 3:23pm

The cigarette lighter fuse in the Lavida is located in the fuse box. The Lavida's fuse box is situated behind the left-side cover panel in the driver's position. To locate the cigarette lighter fuse, you need to open the cover panel. The cigarette lighter is a standard component in all vehicles, designed to provide a flame source for smokers. Essentially, a cigarette lighter is a device used for lighting cigarettes, and the commonly referred-to cigarette lighter can also draw power from the vehicle's electrical system. Some manufacturers produce cigarette lighters not intended for lighting cigarettes but rather for drawing power from the car, which are also known as cigar lighters. The Lavida measures 4670mm in length, 1806mm in width, and 1474mm in height, with a wheelbase of 2688mm. It is a 4-door, 5-seater sedan.

Was this review help?
20
2
Share
JasonFitz
08/14/25 8:11am

I've been driving a Volkswagen Lavida for several years. Last time when the cigarette lighter wasn't working, I discovered that the fuse location is right below the steering wheel on the left side. When you sit in the driver's seat, just look down and you'll see a small plastic cover. Use your finger to pry it open, and inside is the fuse box. The fuse number for the cigarette lighter is usually F42 or F43, depending on your model year. For example, my 2019 model uses F42 position with a 15-amp mini fuse. Remember to turn off the car key when checking to avoid short circuits. The reason for a blown fuse might be related to plugging in too many charging devices or voltage fluctuations. After replacing with a new fuse, the function was restored, but don't mess with it yourself to avoid electric shock. It's best to check during regular maintenance to prevent problems.

Was this review help?
4
0
Share
Expand All
ElliotFitz
10/11/25 8:12am

Not long after buying the car, I encountered a sudden power loss in the cigarette lighter. After some troubleshooting, I finally figured out its location. The cigarette lighter fuse in the Volkswagen Lavida is hidden in a small compartment under the lower left side of the dashboard. To be more specific, bending down from the driver's seat allows you to reach the small door. Once you pry it open easily, you'll see a row of fuses with a numbered list attached to the cover. The cigarette lighter is usually labeled F15 or a similar code, using a small blue fuse rated around 10 amps. I've replaced it a few times myself—just remember to remove the key first for safety. The fuse tends to blow if you frequently plug in power banks or overload the device, so it's advisable to keep a spare fuse in the car for emergencies. The design of this location makes it easy to find, even for beginners to try their hand at it.

Was this review help?
17
2
Share
Expand All
ReeseMarie
11/25/25 2:30am

As a car enthusiast, I know the cigarette lighter fuse for the Lavida is located in the main fuse box. That box is positioned in front of the driver's knees, beneath the steering wheel, and becomes visible once you lift the plastic cover. Common fuse numbers for the cigarette lighter include F41 or F50, depending on the model, typically being a small 15A component. You can use a test light to check if it's blown, or simply look for discoloration or a broken connection. The location is intuitively designed, but ensure the vehicle is turned off before working to prevent accidental short circuits. Fuse blowouts often occur due to cigarette lighter socket overloads or aging wiring. Timely replacement solves the issue, preventing neglect from causing other faults.

Was this review help?
20
0
Share
Expand All
More Forum Discussions

Why does a motorcycle burning oil emit white smoke from the exhaust pipe?

Motorcycle burning oil and emitting white smoke from the exhaust pipe can be caused by the following reasons: Water in the oil: Directly affects the normal combustion of the air-fuel mixture, resulting in white smoke. In this case, the sediment in the oil should be drained, accumulated water should be removed, and the diesel should be replaced if necessary. Valve timing issue: Check whether the intake and exhaust valves are correctly installed and whether they are of the same model. Insufficient temperature: Due to insufficient engine temperature, part of the air-fuel mixture formed by the fuel injected into the cylinder and air cannot burn, causing white smoke from the exhaust pipe. Therefore, after starting the engine, pay attention to the temperature of the radiator, operate at medium throttle, and gradually increase the load only after the engine temperature reaches above 50 degrees.
19
3
Share

Where Should You Stop on a Hill Start?

Precise alignment with the side line is crucial for hill parking. Only when the side margin reaches 30cm and the vehicle is properly aligned can the requirements for precise parking be met. Introduction to Hill Start: Hill start is part of the field test in the second subject of the driver's license examination, which involves starting a vehicle parked on a steep slope. Hill Start Techniques: When learning manual transmission hill start techniques, students should first engage the handbrake, increase the throttle to at least 2000 RPM, then gradually release the clutch until the RPM drops to around 1000. Release the handbrake, slightly release the clutch while adding a bit more throttle, and the car will naturally ascend the slope. At the start of the test, shift into first gear, release the handbrake, and gently release the clutch. Once the vehicle is stable, proceed up the slope, staying within 30cm of the side line. Control the clutch to maintain the slowest possible speed. For precise parking, use reference points to align the front of the car with the markers, ensuring accurate positioning.
9
3
Share

Is the rear fender of a car a structural component?

The rear fender of a car is not a structural component; it is part of the vehicle's outer panels. The main outer panels of a vehicle include: The front and rear bumpers, engine hood, fenders, doors, trunk lid, etc. These outer panels act like the skin of the vehicle, primarily serving to protect the body. Characteristics of automotive structural components: The vehicle frame can be understood as the skeleton that supports the body and is the primary safeguard for safety. Since structural components are integrated, any damage to them necessitates cutting and welding for repairs, significantly reducing safety. Automotive structural components are critical as they directly impact driving safety.
20
0
Share

How many kilometers can a Yamaha Fuxi 100 run on a full tank of gas?

When the fuel gauge needle of a scooter reaches the red line, there is still about one-third of the fuel left in the tank, not completely empty. Based on the fuel consumption of the Fuxi, 20 yuan worth of gasoline can run about 100 kilometers when fully used. First, check whether the method of calculating fuel consumption is correct. Additionally, driving habits and vehicle condition also significantly affect fuel consumption. Vehicles in the break-in period tend to consume more fuel, and those driving at low speeds in urban areas will also have higher fuel consumption. Below is more related information: 1. Body structure: The structure is similar to models like Ghost Fire and Xun Ying, consisting of the front, footboard, and body. A cylindrical container is placed at the lower left of the front, and a storage compartment and fuel tank are located under the seat. 2. Emission standards: The Yamaha Fuxi scooter has three versions: Euro 1, Euro 2, and Euro 3, which are also emission standards. Among them, the Euro 3 Fuxi has relatively weaker power compared to the Euro 2 and Euro 1 versions. The Feiying Huajia is a scooter equipped with the Linhai RS100 (LY149QMG) engine, with the same appearance as the Euro 2 Fuxi, and its price is relatively cheaper than the Fuxi.
2
0
Share

Can a Motorcycle Fuel Tank Be Replaced?

Motorcycle fuel tanks can be replaced. Motorcycle fuel tank disassembly: For cross-type motorcycles, it is necessary to remove or open the seat cushion and the left and right side covers, then unscrew the bolts at the rear end of the fuel tank and pull it out to remove the fuel tank. Plastic guards and related bolts must be removed to take it off. Due to the variety of models, the parts and locations that need to be disassembled differ. Locate the fuel tank position, remove the bolts and plastic panels, and finally expose the fuel tank to take it off. Motorcycle fuel tank cleaning: Drain the gasoline, flush with compressed air, rinse with gasoline, shake the fuel tank vigorously for 2-3 minutes, then drain the gasoline again, repeating the first step.
11
1
Share

What does maximum power of 92kw mean?

Maximum power of 92kw refers to the engine's maximum power. What is maximum power: Maximum power refers to the maximum rate of energy transfer by a circuit component per unit time, which is a physical quantity with magnitude and direction. Here it specifically refers to maximum output power. The greater the maximum power, the more devices the power source can support. Maximum power conversion: Engine maximum output power: 1 kilowatt = 1.3596216173039 metric horsepower (PS), 1 metric horsepower (PS) = 0.73549875 kilowatts. The horsepower commonly referred to is metric horsepower, meaning 92 kilowatts equals 125 horsepower.
19
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.