Where is the cigarette lighter fuse located in a car?

1 Answers
CalvinFitz
07/30/25 6:38am
One fuse for the car cigarette lighter is placed inside the vehicle, and another fuse is located under the engine hood. The first fuse inside the car: some are in the vehicle's electrical fuse box, some are in the small drawer below the driver's seat on the left side, or you can follow other fuse wires to locate the cigarette lighter fuse. The second fuse, placed under the car engine hood: open the engine hood, and you will see the fuse box. Then, open the fuse box, and on the back of the fuse box cover, there is a fuse circuit diagram. Follow the diagram to find the cigarette lighter fuse. Inside the box, there is also a small white clip, which is specifically used for replacing fuses. It is recommended to learn more about car basics, such as turning on the cigarette lighter first and then inserting the key, so the cigarette lighter won't get damaged, and you won't need to replace the fuse. How to replace a fuse: Open the fuse box or the car's dedicated fuse storage container; Then, according to the corresponding table, find the cigarette lighter fuse among the many fuses; Next, remove the cigarette lighter fuse, being careful not to touch other circuit devices during the process; After removing the cigarette lighter fuse, you will notice that the fuse has blown. Measure the fuse size, purchase a new fuse according to the size, and reinstall it.
Was this review help?
16
0
Share
More Forum Discussions

Why did the warning light suddenly come on?

The reasons why the warning light suddenly comes on are: 1. When the water temperature, crankshaft position, air flow, intake temperature, or oxygen sensor is damaged, has poor contact, or signal interruption; 2. Irregular maintenance and poor driving habits can increase the burden on engine operation; 3. Failure to add the required grade of gasoline can cause engine wear; 4. Poor combustion of the air-fuel mixture; 5. Impact during driving, tampering with a certain engine connector, or temporary signal interruption in the ECU. Warning lights include: 1. Engine fault warning light; 2. Low oil pressure warning light; 3. Water temperature warning light; 4. Brake system fault light; 5. ABS system fault light; 6. Seat belt indicator light; 7. Airbag fault light; 8. Power steering warning light; 9. Tire pressure warning light.
7
1
Share

How long can the payment of motorcycle insurance be delayed after expiration?

Vehicle compulsory insurance can be delayed for up to 3 months for payment. The payment can be delayed, as long as the original auto insurance company can still accept renewal within 3 months. However, according to regulations, vehicles without compulsory insurance are not allowed on the road. Below is relevant information about compulsory insurance: Introduction: The full name of compulsory insurance is "Motor Vehicle Traffic Accident Liability Compulsory Insurance," which is China's first compulsory insurance system implemented by national law. Its premium is subject to a nationwide unified charging standard, stipulated by the state, but the price of compulsory insurance varies for different car models, with the main influencing factor being the "number of car seats." Claims: The compulsory liability insurance referred to in these regulations means that the insurance company compensates for personal injury, death, or property loss of victims other than the vehicle's personnel and the insured within the liability limits in the event of a road traffic accident caused by the insured motor vehicle.
15
4
Share

What does motorcycle ECU mean?

Motorcycle ECU (Electronic-Control-Unit) is the electronic control unit, also known as "on-board computer" or "vehicle computer", which is generally used in fuel-injected motorcycles to control the ignition program. The following is the relevant introduction of ECU: 1. The working voltage range of ECU is generally 6.5 to 16V (with voltage stabilizing device in key internal parts), the working current is 0.015 to 0.1A, and the working temperature is -40℃ to 80℃. It can withstand vibration below 1000Hz, so the probability of ECU damage is very small. 2. In the ECU, the CPU is the core part, which has the function of operation and control. When the engine is running, it collects the signals of each sensor, performs operations, and converts the operation results into control signals to control the work of the controlled object.
11
2
Share

What system does the highway ETC represent?

Highway ETC (Electronic Toll Collection) translates to electronic toll collection, which is a non-stop toll collection system. On highways, there will be one or more ETC lanes. ETC charging method: Through the dedicated short-range microwave communication between the on-board RFID tag installed on the vehicle's windshield and the microwave antenna on the ETC lane of the toll station, the application of software networking technology is used to conduct back-end settlement processing with the bank, thereby achieving the purpose of vehicles passing through bridge and road toll stations without stopping to pay tolls. Banks install this type of ETC express card with the principle of 'pass first, pay later'. ETC application conditions are as follows: Provide the original and photocopy of the vehicle owner's valid ID card and vehicle registration certificate. The photocopy of the driving license should include the page with the most recent annual inspection stamp; Postal credit card application form. This credit card is used to bind the ETC card. After obtaining the credit card, swipe it twice and present the POS slip to the designated postal outlet to receive and install the ETC on-board device for free, with no charges during the process; Be between 18 and 60 years old; Own a vehicle under personal name. Below are precautions for installing ETC: Do not block the view. It is best to install it behind the rearview mirror: Many car models have a large rearward angle of the windshield, which reduces the driver's field of vision. If this is not considered during ETC installation, it will increase the driver's blind spot. Install it on the right side behind the rearview mirror to avoid blocking the view. Do not affect charging: The ETC electronic tag consumes power, but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, during installation, avoid the blackened areas on the windshield and do not place it where the solar panel can be easily blocked. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After the electronic tag is installed, the windshield will press the anti-removal lever in. If it is removed arbitrarily, the anti-removal lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to go to an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device. Notes for using ETC: The ETC transaction sensing range is 8 meters. To prevent the ETC device of the vehicle in front from malfunctioning, maintain a distance of more than 10 meters from the vehicle in front to avoid automatic sensing and paying for the vehicle in front. The ETC lane recognition speed is 20 kilometers per hour. If the speed is too fast, the vehicle device information cannot be read, leading to failed deductions. When using a debit card to bind ETC, insufficient balance will also cause deduction failures.
20
2
Share

Where is the battery located on a motorcycle?

Some are installed under the footboard, which can be seen by lifting the footboard mat, while others are located under the seat, which can be accessed by opening the seat cushion. Below is relevant information about motorcycle batteries: Types: Motorcycle batteries are all lead-acid batteries with a voltage of 12V, but their ampere-hour (A/H) ratings vary. Light motorcycles with engine displacements below 110CC use 5A/H, while those above 125CC often use 7A/H and 9A/H. Principle: The negative electrode is made of a lead plate filled with sponge-like lead, the positive electrode is made of a lead plate filled with lead dioxide, and 22–28% dilute sulfuric acid is used as the electrolyte. During charging, electrical energy is converted into chemical energy, and during discharging, chemical energy is converted back into electrical energy.
13
3
Share

Which country produces Daehan motorcycles?

Daehan motorcycles are produced by Jinan Qingqi Daehan Motorcycle Co., Ltd. in China. Here are the details: Company Profile: Jinan Qingqi Daehan Motorcycle Co., Ltd. was established on August 1, 2016, as a limited liability company (Sino-foreign joint venture) jointly invested by Jinan Qingqi Motorcycle Co., Ltd. and Korea KR-Motors Co., Ltd. Scale: Annual production capacity of 300,000 motorcycles (with engine displacements ranging from 50cc to 850cc, covering underbone, scooter, street bikes, and CKD production for various models), and 400,000 motorcycle engines. Additionally, the company processes 50,000 sets of marine outboard engine cylinder head assemblies and automotive engine shell components annually.
6
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.