Where is the cigarette lighter fuse in the Envision?
3 Answers
The cigarette lighter fuse in the Envision is located inside the fuse box under the dashboard cover. The cigarette lighter itself is positioned below the center console. The cigarette lighter fuse is rated at 20A, and if it blows, the cigarette lighter will lose power. When you press the cigarette lighter, it automatically heats up and pops out after 5 to 8 seconds of heating, ready for lighting cigarettes. The installation and removal method for the cigarette lighter is as follows: 1. Unscrew the housing: Some car cigarette lighter sockets have a threaded rear housing that can be unscrewed counterclockwise and reinstalled by turning clockwise. 2. Remove screws: Some cigarette lighter sockets are secured with screws; simply use a wrench to remove them for disassembly and reinstall by tightening the screws. 3. Remove the panel: The gearshift lever panel is attached with plastic clips and can be pried open by hand or with a flathead screwdriver to fully detach it. 4. Remove panel screws: After removing the gearshift lever panel, the cigarette lighter panel door will open automatically, revealing two black screws that can be removed with an M4 hex wrench. 5. Remove the panel box: Pull the cigarette lighter's plastic panel box out by hand. When it's extended about 10 cm, disconnect the wiring before fully removing the entire box. 6. Operate the inner and outer rings: The cigarette lighter consists of inner and outer rings. Press the inner ring to activate heating; once it reaches the desired temperature, the inner ring will pop back to its original position, allowing you to pull out the lighter by holding the outer ring.
As a seasoned driver, I've been driving the Buick Envision for many years, and a blown cigarette lighter fuse is quite common. It's located in the fuse box, usually inside the cabin. You can try opening the glove compartment and pulling out the inner lining—there's a fuse panel inside. The diagram will indicate "Cigarette Lighter" or "CIG," typically using a 15-amp blue mini fuse. I've replaced it once myself—that time my kid short-circuited a power bank—so I first turned off the engine and disconnected the negative battery terminal to avoid electric shock, then used small tweezers to remove the blown fuse and installed a new one of the same type. I always keep spare fuses in the car for emergencies. If you're unsure about the location, refer to the owner's manual or online diagrams for your model—the Envision's design is fairly straightforward and not too troublesome. Remember to test the cigarette lighter after replacement to ensure it works properly. If the fuse keeps blowing, check for electrical overloads. Keeping basic tools in your toolbox makes things much easier.
I have some experience in car repairs, so let me share the location of the Envision's cigarette lighter fuse. You can find it in the car's fuse box, usually located on the left side of the dashboard or behind the glove compartment. The fuse is typically marked with a light color, rated at 15A or 20A, and can be identified by referring to the icons on the fuse box cover. Safety is crucial when replacing it: first, disconnect the car battery terminal, then carefully remove the old fuse with plastic tweezers and insert a new fuse of the same specification. Avoid touching it directly with your hands to prevent electrostatic damage. The location isn't difficult, but don't force it—doing it wrong can cause circuit issues. Related topic: The cigarette lighter fuse often blows due to device short circuits or voltage instability. Using original chargers can reduce risks. Keep the fuse box clean and regularly check continuity with a multimeter for early prevention.
