Where is the child lock on the Volkswagen Passat?

2 Answers
VanArabella
07/24/25 12:07pm
The child lock on the Volkswagen Passat is located on the rear door locks. Its function is to prevent children from opening the door during driving, thereby avoiding danger. Here are some related details: 1. The Volkswagen Passat is a mid-sized 4-door 5-seater sedan with a body size of 4933mm in length, 1836mm in width, and 1469mm in height, and a wheelbase of 2871mm. 2. The Volkswagen Passat is equipped with a 1.4T turbocharged engine and a 7-speed dual-clutch transmission, with a maximum power of 100 kW and a maximum torque of 250 Nm. It features front-wheel drive, with a MacPherson independent front suspension and a multi-link independent rear suspension.
Was this review help?
12
3
Share
VonWalker
08/11/25 6:16am
As a Passat owner, I find the child lock very practical—it's located right by the rear door. When you open the door, there's a small slot near the car body where you can turn your car key to lock it. This prevents children from opening the door from the inside, which is especially safe. I used it often when my child was young. Remember to test it by pulling the inner handle after locking to ensure it works—don’t be careless. The Passat’s design is thoughtful, but some owners might overlook setting it. I recommend checking it every time you take your child out. Safety comes first, especially with the high risk of accidents on highways—locking the door can save a lot of worry. Don’t wait for an incident to regret it; develop the habit early.
Was this review help?
2
4
Share
Expand All
More Forum Discussions

What is the body length of the FJ Cruiser?

The body length of the FJ Cruiser is 4670mm, with a body width of 1905mm, height of 1830mm, wheelbase of 2690mm, minimum ground clearance of 245mm, body weight of 2015kg, and fuel tank capacity of 62.5 liters. The FJ Cruiser is equipped with a 4.0L six-cylinder naturally aspirated engine, delivering a maximum horsepower of 272PS, maximum power of 200kW at 5600rpm, maximum torque of 379Nm at 4400rpm, and is paired with a 5-speed automatic transmission.
20
2
Share

How often are traffic violations for driving restricted vehicles monitored in Baoding?

Traffic violations for driving restricted vehicles in Baoding are monitored every 4 hours. Within this 4-hour period, drivers can move their vehicles out of the restricted area, drive to the nearest parking lot, or return to their starting point without worrying about being penalized again. Traffic Violations for Restricted Vehicles: Driving a restricted vehicle in the restricted area on the designated day constitutes a violation of the no-entry sign, punishable by point deductions and fines. However, specific regulations may vary slightly depending on the region. The odd-even license plate restriction system is a traffic measure introduced to alleviate urban traffic congestion. Methods for Confirming Violations: The fastest and most effective way to check if you have committed a traffic violation is to visit the vehicle management office or traffic police station to inquire about violations. You will need to bring important documents such as your driver's license, vehicle registration, and ID card—all three are essential. It's also advisable to carry some cash, so if any violation records are found, you can immediately proceed with the necessary formalities.
14
5
Share

How to Activate the Automatic Wiper Function?

The wipers will enter automatic wiping mode, and the wiping frequency can be adjusted via the control knob. Push the control lever upward to the MIST position to activate a single wipe cycle, or move it to the OFF position to turn off the wipers.
15
3
Share

How to Troubleshoot When the Windshield Wiper Won't Stop?

If the windshield wiper keeps running non-stop, it is likely due to a fault in the wiper motor circuit. When the demand signal is transmitted to the BCM, the BCM sends a start signal to the wiper motor, which then controls the wiper arm to perform the corresponding action.
15
0
Share

How to adjust the rearview mirror of Audi Q3?

The method to adjust the rearview mirror of Audi Q3 is: rotate the button in the middle of the inner handle of the driver's door to adjust the rearview mirror. Its body dimensions are: length 4495mm, width 1848mm, height 1616mm, wheelbase 2680mm, minimum ground clearance 152mm, body weight 1735kg, fuel tank capacity 62l. The Audi Q3 is equipped with a 2.0l four-cylinder turbocharged engine, with a maximum horsepower of 220ps, maximum power of 162kw, maximum power speed of 4500 to 6200rpm, maximum torque of 350nm, maximum torque speed of 1500 to 4400rpm, and is paired with a 7-speed dual-clutch transmission.
16
0
Share

How to Adjust Wiper Blade End Jitter?

If the wiper blade is causing jitter, the simplest and most effective solution is to directly replace it with a new wiper strip. If the wiper arm is bent and causing jitter, perform fine adjustments until it fits snugly against the windshield. If the wiper tension is causing jitter, use a flathead screwdriver to gently pry the spring a few times to loosen it.
3
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.