Where is the Chevrolet Epica's Cabin Air Filter Located?

1 Answers
IsabelleMarie
07/30/25 6:30am
Chevrolet Epica's cabin air filter is located in front of the right windshield: open the engine hood and remove the rubber seal to access it. More information about cabin air filters is as follows: 1. The cabin air filter is an important component of the car's air conditioning system, which can prevent external impurities from entering the system and affecting its normal operation. 2. The cabin air filter can purify the air to some extent, maintaining a relatively comfortable environment inside the car. Generally, it should be replaced every 5,000-8,000 kilometers. 3. If the cabin air filter is not cleaned and replaced in time, blockages by foreign objects can affect the normal operation of the air conditioning system, causing unnecessary trouble. Note: Some models' cabin air filters cannot be cleaned and must be replaced.
Was this review help?
6
1
Share
More Forum Discussions

Will Electric Vehicles Explode?

Electric vehicles can explode. The following are the scenarios where explosions may occur: Collision-induced explosion: While driving, if a collision accident occurs, the electric vehicle is highly likely to explode due to battery runaway. Whether the battery is ternary lithium or lithium iron phosphate, electric vehicle batteries store electrical energy through the gain and loss of electrons by lithium ions. As the most reactive element known, lithium ions will react with oxygen upon contact with air, leading to combustion and explosion. Charging-induced explosion: The main cause of explosions during charging is battery overcharging, meaning the battery is charged beyond its capacity. Overcharging leads to excessive lithium metal deposition at the positive electrode, continuously embedding into the negative electrode, increasing the battery's internal resistance and causing temperature rise. The rise in temperature then triggers micro-short circuits inside the battery, further escalating the temperature, making an explosion more likely.
19
3
Share

Where is the USB port of the Trumpchi GM8?

The USB port of the Trumpchi GM8 is located inside the center armrest. The port can be used for inserting a USB drive to play music, as a USB car cigarette lighter port, or as an interface for an electronic dog and dashcam. The dimensions of the Trumpchi GM8 are 5089mm in length, 1884mm in width, and 1822mm in height, with a wheelbase of 3000mm. It has a fuel tank capacity of 65 liters and a trunk capacity of 85 liters, with a curb weight of 2020kg. The Trumpchi GM8 features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 2.0T turbocharged engine, delivering a maximum horsepower of 252PS, a maximum power of 185kW, and a maximum torque of 390Nm, paired with an 8-speed automatic transmission.
19
1
Share

What are the reasons for the ABS light to come on?

There are several reasons for the ABS light to come on: 1. When the vehicle is first started and the ignition switch is turned on, the vehicle undergoes a self-check procedure, during which the ABS light will illuminate. After the check is completed, the ABS indicator light will automatically turn off. 2. If the ABS indicator light comes on while driving, it indicates a malfunction in the ABS anti-lock braking system, which could be due to a faulty sensor or wiring issue that prevents signal transmission. 3. During an annual vehicle inspection, the ABS indicator light may come on after the exhaust test. This happens because during the test, the front wheels rotate for an extended period while the rear wheels remain stationary. Under normal driving conditions, the rotation speeds of the front and rear wheels do not differ significantly. The system may interpret this as an ABS fault, causing the indicator light to illuminate. Simply turning off the engine and waiting for a few seconds before restarting will usually make the ABS light turn off on its own.
14
2
Share

Where can I make a U-turn with my shoulder aligned during Subject 3 test?

When needing to turn or make a U-turn at general intersections with zebra crossings, you can execute the maneuver when your shoulder aligns with the zebra crossing. Below are relevant details: Definition: Subject 3 refers to the road driving skills test and safety/civilized driving knowledge examination, which constitutes part of the motor vehicle driver's license assessment. It is the abbreviated term for the road driving skills and safety awareness test in driver's license examinations. Precautions: After completing a 360-degree safety check around the vehicle according to standard procedures, enter the vehicle ensuring all doors are fully closed. If detecting vehicle body damage, unsafe surroundings, or abnormalities under the car, resolve potential safety hazards before entering.
5
0
Share

How to Turn Car Headlights On and Off?

The high beam and low beam switches are located on the lighting control assembly to the left of the steering wheel. Rotate the knob to turn the low beams on or off; flip the lever to turn the high beams on or off. The headlight switch also controls the front and rear fog lights, width lights, and low beams. Here are the classifications of car lights: 1. Headlights: Combined headlights are located at the front of the car, primarily serving for illumination and signaling. The light emitted by headlights illuminates the road ahead, enabling safe driving at night. 2. Tail lights: Combined tail lights are located at the rear of the car, mainly serving for illumination and signaling. 3. Turn signals: Used to indicate left or right turns to other road users. Regulations require them to be amber in color. 4. License plate lights: These primarily illuminate the license plate, allowing people to identify the vehicle's license plate at night.
9
1
Share

What is the normal oil pressure for EA888?

EA888 oil pressure standard is 6 to 40 bar. The method for changing engine oil is as follows: 1. Lift the vehicle, remove the undercover, and place a container under the oil drain plug; 2. Loosen the oil drain plug, use an air gun to blow for two minutes at the oil filler port, tighten the drain plug after draining, and wipe with a tissue to check for leaks; 3. Reinstall the undercover, lower the vehicle, and add oil through the filler port. Precautions for changing engine oil: 1. Perform the operation with the engine warm to ensure thorough drainage of old oil; 2. Add oil and ensure the proper amount is used; 3. After adding oil, start the engine and check all components for leaks. Run the engine for 3 minutes to confirm the oil level reaches the normal mark.
5
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.