Where is the car engine coolant located?

1 Answers
LeMatthew
07/30/25 12:59am
Coolant is located in a small pink liquid-filled reservoir on the left side of the engine compartment. Functions of the cooling system: To provide moderate cooling to the operating engine, allowing it to work within the most suitable temperature range. Engine cooling must be properly balanced. Insufficient cooling will reduce engine power, cause oil to degrade due to heat, and decrease the mechanical strength of components due to high temperatures. Excessive cooling leads to excessive heat loss, reducing engine performance and fuel efficiency, increasing oil viscosity, and intensifying friction and wear between moving parts. Precautions when using coolant: Prevent coolant leakage, as leakage not only results in coolant loss but severe leakage can dilute engine oil, causing lubrication system failures; avoid contact with skin; use coolant year-round consistently, paying attention to the continuity of coolant usage.
Was this review help?
8
2
Share
More Forum Discussions

Can a Car Be Started After Being Submerged in Water?

After a car has been submerged in water, it cannot be started. It must be repaired before it can be used again. Below are methods for identifying flood-damaged and accident-damaged vehicles: 1. Check the car locks: Look for signs of tampering, forced entry, or adhesive injection. Then use the key to open each door to see if the locks are from the same set and if each door lock can be turned easily. Note that if turning the key is very difficult or the key almost breaks before the door opens, it may be due to water damage causing the central locking motor to rust and malfunction. 2. Engine compartment: Inspect the mounting brackets for the lighting and signal light groups in the engine compartment for breakage or looseness. Check the wiring connectors and sockets; if there is a large amount of mud or rust spots inside, it may indicate a flood-damaged vehicle. 3. Engine compartment inspection: Examine the wiring and vacuum lines on the engine block, as well as the gaps between the high-voltage ignition coils and spark plugs for traces of mud. Assess whether the aging and cracking of the tubing and wiring match the vehicle's age, and check the condition of the fuel injector mounts. Rust on springs can also help determine the likelihood of the car being flood-damaged.
15
4
Share

Do I still need to buy a phone holder if I have CarPlay?

You don't need to buy a phone holder if you have CarPlay. Your phone can be mirrored to the car's display. Introduction to CarPlay: CarPlay is an in-car system released by Apple Inc. in the US, which seamlessly integrates users' iOS devices and iOS user experience with the dashboard system. Interfaces supported by CarPlay: CarPlay only supports iPhones with Lightning connectors. Although iPads also support this interface, Apple has not included iPads as hardware devices supported by CarPlay. On June 13, 2016, Apple announced at the WWDC developer conference that its smart car system CarPlay would be updated along with iOS 10, becoming the perfect partner for the new version of Apple Maps and Siri.
9
1
Share

What engine is equipped in the Shuailing e?

The Shuailing e is equipped with the 4DA1 series engine. Principle of turbocharging: A turbocharged engine relies on a turbocharger to increase the engine's air intake. The turbocharger is essentially an air compressor. It uses the exhaust gases from the engine as power to drive the turbine in the turbine chamber, which in turn drives the coaxial impeller. The impeller compresses fresh air delivered through the air filter pipe and sends it into the cylinder. As the engine speed increases, the exhaust gas discharge speed and turbine speed also increase synchronously, thereby enhancing the air compression level. This correspondingly increases the engine's air intake and output power. Function of turbocharging: The main function of turbocharging is to increase the engine's air intake, thereby improving the engine's power and torque, making the vehicle more powerful.
2
4
Share

What Engine Displacement is Needed for a Motorcycle Wheelie?

There is no specific requirement for engine displacement when performing a motorcycle wheelie. Here are the details: 1. Below 600cc: For motorcycles under 600cc, performing a wheelie requires popping the clutch while stationary. For 600cc sport bikes, the front wheel will lift off the ground by itself when giving full throttle in first or second gear while the bike is moving. 2. 1000cc+: For motorcycles with 1000cc or more, the front wheel will lift off the ground when giving full throttle in third or fourth gear. Below is additional information on motorcycle wheelie techniques: 1. Method one: Lift the front wheel after the bike starts moving, practice while stationary. First, keep both feet on the ground, engage first gear, rev the throttle with the right hand while popping the clutch with the left hand, and simultaneously pull the handlebars upward with both hands. At this point, push off the ground with both feet, adopting a posture that lifts the bike upward, and the front wheel will easily leave the ground. 2. Method two: After starting the bike, while moving slowly, pull the clutch, rev the throttle, and quickly release the clutch to utilize the strong torque of first or second gear to lift the front wheel.
3
3
Share

What is the fuel tank capacity of the Changan CS55 in liters?

The fuel tank capacity of the Changan CS55 2019 1.5T Manual Xuanse Type China VI is 58L. It is equipped with a 1.5L turbocharged engine and a 6-speed manual transmission (MT). The drivetrain is front-engine, front-wheel drive. The front suspension is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension. In the same vehicle class, the fuel tank capacity of the Fengxing T5 2022 Shengshi 1.6L Manual Zhumeng Edition (5-seater) is 45L, and the fuel tank capacity of the Trumpchi GS4 2022 270T Manual Comfort Edition is 55L. During actual refueling, the amount of fuel may exceed the nominal capacity. This is because the fuel tank capacity specified by the manufacturer is measured from the bottom of the tank to the safe fill level, and there is additional space from the safe fill level to the tank opening. This space ensures that the fuel can expand when temperatures rise without overflowing. If fuel is filled up to the tank opening during refueling, the actual refueling amount may exceed the nominal capacity. To check the remaining fuel level, the driver can observe the fuel gauge on the right side of the instrument panel, which is marked with 'E' and 'F'. When the needle is near 'E', it indicates low fuel, and when it is near 'F', it indicates a full tank.
18
0
Share

What is the displacement for a 50kw engine?

50kw is the power of the engine, equivalent to 68 horsepower. It is not related to displacement. Definition of displacement: Displacement (Swept-volume), a specialized term in hydraulic transmission, refers to the volume of fluid inhaled or exhausted per stroke or cycle. Generally, a larger displacement means the engine releases more energy (converting chemical energy of fuel into mechanical energy) per unit time, which translates to better "power performance". Common vehicle displacements: Most sedans have displacements of 1.4T, 1.6L, 1.8T, 2.0L, 2.4T, etc. Most mid-size SUVs start with at least a 2.0T engine or a naturally aspirated engine above 2.4L.
19
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.