Where is the cabin air filter located in the Volkswagen Lamando?

1 Answers
LiamDella
07/29/25 11:23am
The cabin air filter in the Volkswagen Lamando is located behind the glove compartment on the passenger side. You can access it by removing the glove compartment. The cabin air filter is a crucial component of the car's air conditioning system and requires regular replacement. Generally, it is recommended to replace the cabin air filter every 10,000 kilometers. The filter helps purify the outside air, ensuring clean air inside the vehicle. The Volkswagen Lamando is a sporty compact car launched by SAIC Volkswagen, marketed as the 'first wide-body coupe.' Its dimensions are 4598mm in length, 1826mm in width, and 1425mm in height, with a wheelbase of 2656mm.
Was this review help?
4
2
Share
More Forum Discussions

How Long Can a Car Key Last When the Battery Is Low?

When the car key indicates a low battery, the remaining usage time depends on the frequency of use. Below are detailed introductions to the functions of car remote keys: Closing Windows After Turning Off the Engine: Press and hold the lock button on the remote key to close the windows. Some regular family cars may also have this feature. Finding the Car in a Parking Lot: Some car keys have a dedicated car-finding button. For certain vehicles, pressing the lock button twice in succession will trigger the car to emit a beep, indicating its location, making it easier to find the car quickly in crowded parking areas. Automatically Opening the Trunk: Many car models have a trunk-opening button on the remote key. Press and hold the trunk unlock button to automatically open the trunk. Keyless Entry: You need to carry the car key. When the key is near the car, it automatically pairs with the car's decoder. Press the unlock button on the car door handle to unlock the car.
3
1
Share

How to Check Tire Wear Condition?

Tire wear condition inspection method introduction: Mainly check the wear indicators in the tread grooves of the tire. Direct observation can reveal the degree of tire wear. When the wear reaches the upper limit, various performance aspects of the tire, such as grip and braking distance, will decrease. Below is relevant information about car tires: 1. Replacement time: When the surface of the car tire wears to the position of the triangular symbol, it should be replaced promptly to prevent safety hazards. 2. After replacing or repairing a tire: It is necessary to perform a four-wheel alignment and dynamic balance promptly to prevent abnormal vibrations when the car is driving at high speeds. Avoid driving at high speeds over potholed sections to prevent tire blowouts.
12
3
Share

Does Winter Increase Fuel Consumption?

Winter does increase fuel consumption. Reasons for higher fuel consumption in winter: 1. Low temperature effects: Due to cold weather, the engine maintains higher RPM after cold starts. On short trips, the engine may not reach optimal operating temperature before reaching the destination, and repeated high-RPM operation increases fuel consumption. 2. Improper operation: Leaving the heater on when shutting down the vehicle the previous day causes the heater to activate with the engine next morning, wasting engine heat. Sometimes activating the AC (compressor) simultaneously creates additional engine load. Prolonged idling to warm up not only increases fuel consumption but also leads to more engine carbon deposits.
16
3
Share

What Are the Reasons for a Battery Not Charging?

Introduction to the reasons why a battery cannot be charged: 1. The battery is fully charged: A battery in a fully charged state will naturally not accept further charging. 2. Sulfation of the battery's negative plates: This occurs because standard constant-voltage chargers, due to their design settings, may not fully charge the battery. Even if the battery can be charged or discharged during use, insufficient charging will gradually reduce its capacity and shorten its lifespan. 3. Lack of electrolyte: If the electrolyte has dried up, first add distilled water. After adding enough, do not immediately replace the battery's filler cap. Connect a 220V/200W ordinary incandescent bulb in series with the battery (regardless of polarity) to a 220V AC power source at home and observe whether the bulb lights up normally. If it does, continue supplying power for about 1 minute before disconnecting. Wait a few minutes and then reconnect for another minute, repeating this process 3-5 times. Afterward, connect the battery to a charger for a normal 15-hour charging cycle.
17
2
Share

How many seconds does the CBR500R take to reach 100 km/h?

According to official data, the CBR500R's 0-100 km/h acceleration time is 6.3 seconds. Factors affecting a motorcycle's 0-100 km/h acceleration time are as follows: Torque: Torque, in simple terms, represents how much force is available. The greater the torque, the more force is available to propel the vehicle, naturally resulting in faster acceleration. The CBR650R has a maximum torque of 570 Nm and accelerates from 0-100 km/h in 3.1 seconds. The Honda CBR500R is equipped with a 500cc twin-cylinder liquid-cooled engine, with an actual displacement of 471cc. It features a PGM-FI fuel injection system paired with a DOHC 8-valve setup, delivering a maximum power of 37 kW and a maximum torque of 44 Nm, achieving a 0-100 km/h acceleration time of 6.3 seconds. Transmission efficiency: The transmission acts as the medium for power delivery, inevitably involving power loss. The higher the transmission efficiency, the better the acceleration performance. Generally, transmission efficiency ranks as follows: manual transmission > dry dual-clutch transmission > wet dual-clutch transmission > AT transmission > CVT transmission. The CBR500R is equipped with a six-speed sequential transmission.
10
0
Share

Is It Normal for the Car Key to Be Hot When Pulled Out?

It is normal for the car key to be hot when pulled out. Here are the specific reasons why a car key may become hot: 1. Sun Exposure: The heat of the car key is directly proportional to sun exposure. The car ignition lock is made of metal, and the hotter the sun, the more heat it absorbs. The temperature inside a closed car under direct sunlight can exceed 80 degrees Celsius. The thin car key inserted into the ignition lock can quickly heat up, causing the key to become hot. 2. Excessive Current Passing Through the Ignition Switch: If the current exceeds the maximum safe current of the static and moving contacts, the entire ignition switch will heat up, warming the car key. Over time, as the contacts wear, the temperature may continue to rise.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.