Where is the cabin air filter located in the Skoda Rapid?

1 Answers
OCorey
07/29/25 11:48pm
The cabin air filter in the Skoda Rapid is located beneath the glove compartment on the passenger side, precisely above where the passenger's feet would be positioned. The function of the cabin air filter is to purify the air drawn in by the blower before it is circulated into the vehicle interior. Therefore, if you notice that the air blown out when the fan is turned on abruptly is not fresh or carries a dusty sensation, it indicates that the filter is dirty and requires cleaning or replacement. The Skoda Rapid is an A-segment entry-level sedan launched by SAIC Volkswagen Skoda. In terms of body dimensions, the Skoda Rapid measures 4512mm in length, 1706mm in width, and 1469mm in height, with a wheelbase of 2603mm.
Was this review help?
9
2
Share
More Forum Discussions

What is the steering wheel technique for beginners when reversing?

Steering wheel technique for beginners when reversing: 1. Drive the car forward until it is roughly level with the car in front of the parking space, with a lateral distance of about one meter between the two vehicles. Then adjust the right rearview mirror angle downward as much as possible until you can see the right wheel, and then turn the steering wheel fully to the right to start reversing; 2. After the vehicle starts moving, immediately shift your gaze from the right rearview mirror to the left rearview mirror, paying attention to oncoming traffic and obstacles on the left side; 3. Shift your gaze to the right rearview mirror to observe the distance between the right rear wheel and the curb through the right rearview mirror. When you feel it's appropriate, turn the steering wheel fully to the left and try to get the car as close to the curb as possible while maintaining enough distance to straighten the car body; 4. When most of the car body has entered the parking space, the driver should judge the distance to the car behind by turning their head or using the reversing assist system.
20
4
Share

How to Remove the Front Wheel of a Haval H2?

The method for removing the front wheel of a Haval H2 is as follows: 1. Secure the tire by using wheel chocks in a diagonal pattern - chock the rear wheels when lifting the front and vice versa; 2. Use the wheel bolt decorative cap removal tool included with the vehicle to take out the decorative caps; 3. Loosen the nuts slightly by turning the wheel nut wrench counterclockwise (about one turn); 4. Raise the vehicle using the jack by turning it clockwise until the tire slightly leaves the ground; 5. Remove all fixing nuts and take off the tire. The Haval H2 is a compact SUV launched by the Haval brand under Great Wall Motors, with body dimensions of 4335mm in length, 1814mm in width, 1695mm in height, and a wheelbase of 2560mm.
8
4
Share

How to reset the tire pressure light on a Civic?

Civic tire pressure light reset method: 1. Enter settings and find the vehicle menu; 2. Locate tire pressure and click reset tire pressure. The Civic uses MacPherson strut front suspension and multi-link rear suspension. The multi-link independent suspension improves wheel contact with the ground, enhancing traction. Better traction leads to improved handling and ride comfort. The new Civic comes with two engine options: a 1.0-liter turbocharged three-cylinder engine and a 1.5-liter turbocharged four-cylinder engine. The 1.0L turbocharged three-cylinder produces 92 kW maximum power and 173 N·m peak torque, with maximum power at 5500 rpm and peak torque between 2000-4500 rpm. The 1.5L turbocharged four-cylinder delivers 130 kW maximum power and 226 N·m peak torque, achieving maximum power at 5500 rpm and peak torque between 1800-5500 rpm.
7
4
Share

Which car models share wheel hubs with the BYD F3?

The wheel hubs of the BYD F3 are compatible with the Honda Fit, Mazda 2, Nissan Livina, and Suzuki Swift. The tire size of the BYD F3 is 195/60R15, where 195 indicates the tire width of 195mm, 60 represents the aspect ratio of 60% (the ratio of tire height to width), R denotes radial tire construction, and 15 signifies a 15-inch rim diameter. In terms of powertrain, the BYD F3 is equipped with a 1.5L inline 4-cylinder naturally aspirated engine across all variants, paired with either a 5-speed manual or 6-speed dual-clutch transmission. It delivers a maximum power output of 80kW (109PS) and peak torque of 145Nm. The vehicle features front-wheel drive exclusively, with a MacPherson strut front suspension and a trailing arm semi-independent rear suspension.
1
4
Share

What engine is used in the BMW F35?

The BMW F35 is equipped with three types of engines: a 1.5-liter turbocharged three-cylinder engine, a low-power version of the 2.0-liter turbocharged engine, and a high-power version of the 2.0-liter turbocharged engine. All three engines are paired with an 8-speed automatic transmission from ZF. The 1.5-liter turbocharged three-cylinder engine, codenamed B38, delivers a maximum power of 100 kW and a maximum torque of 220 Nm. Its maximum power output is achieved between 4,400 and 6,000 rpm, while the maximum torque is available from 1,250 to 4,300 rpm. This engine features direct fuel injection technology and utilizes an aluminum alloy cylinder head and block. The BMW F35 is the long-wheelbase version of the BMW 3 Series, belonging to the sixth generation of the model. The extended wheelbase provides more rear-seat space and enhances overall ride comfort.
19
2
Share

What is the wheelbase of the BYD M6?

The wheelbase of the BYD M6 is 2960mm, nearly 3 meters. The wheelbase determines the interior space size of a vehicle. The BYD M6 is positioned as a mid-size MPV with 7 seats. In terms of body dimensions, the BYD M6 measures 4820mm in length, 1810mm in width, and 1765mm in height. For the powertrain, this model is equipped with a 2.4L inline 4-cylinder naturally aspirated engine, paired with a 6-speed automatic transmission. It delivers a maximum power of 123KW and a peak torque of 234Nm, with maximum power achieved at 6000rpm and peak torque at 4000rpm. The fuel supply system adopts multi-point electronic injection. The BYD M6 features front-wheel drive exclusively. Regarding suspension, it utilizes a MacPherson strut independent suspension at the front and a torsion beam non-independent suspension at the rear.
14
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.