Where is the cabin air filter located in the Skoda Kamiq?

1 Answers
McAlice
07/24/25 9:23pm
Skoda Kamiq's cabin air filter is located inside the glove compartment on the passenger side. The function of the cabin air filter is to filter dust and particulate impurities from the air, ensuring clean air inside the vehicle. Taking the 2020 Skoda Kamiq as an example, it belongs to the compact SUV category, with body dimensions of: length 4390mm, width 1781mm, height 1593mm, wheelbase of 2610mm, fuel tank capacity of 55 liters, trunk capacity of 463 liters, and a curb weight of 1270kg. The 2020 Skoda Kamiq is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 112PS, maximum power of 82kW, maximum torque of 145Nm, paired with a 5-speed manual transmission.
Was this review help?
6
3
Share
More Forum Discussions

How Many Times Can a New Car Apply for Temporary License Plates?

New cars can apply for temporary license plates up to three times, and the use of temporary license plates for new cars must not exceed 15 days. Temporary license plates for new cars can be extended, with a maximum of three extensions totaling 21 days. Temporary license plates are paper motor vehicle license plates that permit temporary road use of motor vehicles, also known as temporary driving license plates. Temporary license plates refer to temporary vehicle driving permits issued by the public security vehicle management department for newly purchased vehicles before formal registration. The validity period of temporary license plates generally does not exceed thirty days. There are four types of temporary license plates: temporary license plates within administrative jurisdictions, temporary license plates across administrative jurisdictions, temporary license plates for testing purposes, and temporary license plates for special types of motor vehicles.
14
1
Share

How Often Should Water Be Added to a Car Radiator?

Water should be added promptly when the level in the car's antifreeze reservoir drops below the minimum mark. The replacement cycle is generally every two years or every 30,000 to 40,000 kilometers driven. Vehicles with high usage frequency should consider replacing it earlier as needed. It is important to note that the water referred to here is antifreeze, not tap water. Choose antifreeze based on the vehicle's origin—antifreeze for domestic cars and imported cars cannot be mixed. Therefore, when purchasing, select the appropriate antifreeze according to your vehicle's origin. This is because the rust inhibitors, defoamers, and dyes in imported car antifreeze have different chemical compositions compared to those in domestic car antifreeze. Mixing them can cause chemical reactions, leading to adverse effects such as scaling and corrosion.
15
1
Share

How to Turn on the Fog Lights in the Octavia?

Method to turn on the fog lights in the Octavia: Rotate the knob on the left side of the steering wheel that controls the lights to the right to the small light or low beam positions. Then, pull the knob towards yourself. There are two positions: the first position activates the front fog lights, and the second position activates the rear fog lights. Fog lights are installed at the front and rear of the car and are used to illuminate the road and provide safety warnings during rainy or foggy weather. The rear fog lights are parallel and are usually located on the dashboard inside the car. Turning on the fog lights improves visibility for the driver and other traffic participants. Fog lights are divided into front and rear fog lights, with front fog lights typically being bright yellow and rear fog lights being red. The Octavia has body dimensions of 4675mm in length, 1814mm in width, and 1460mm in height, with a wheelbase of 2686mm.
16
2
Share

What is the function of the idle valve?

The function of the idle valve is to allow the idle controller to act based on the ignition signal. When the engine speed is below 750 RPM, the idle control valve activates to increase the engine speed. Once the engine speed exceeds 1050 RPM, it stops operating. In vehicles equipped with an air conditioning system, this control valve is also referred to as the idle speed-up valve. After the air conditioning compressor engages, it creates an engine load, causing the engine idle speed to drop. The idle control valve then activates to maintain idle stability. The idle control valve is powered by the ignition switch—whenever the ignition switch is turned to the ON position, the idle control valve receives power, and the engine control unit (ECU) manages its circuit grounding. When the engine's operating parameters deviate from normal values, this valve is used to adjust the idle speed.
10
3
Share

Which country is Dongfeng Renault from?

Dongfeng Renault is a joint venture brand between China and France, formed by the partnership of Dongfeng Motor Corporation and French automaker Renault. The Dongfeng Renault Koleos is a standard vehicle under the Dongfeng brand, featuring adjustable rear seat backrest angles for enhanced passenger space. The Koleos measures 4450mm in length, 1840mm in width, and 1600mm in height. The 1.2T variant of the Koleos delivers a maximum power of 86 kW, comes standard with ABS, has a top speed of 182 km/h, and a curb weight of 1394 kg. The Dongfeng Renault Koleos is available in four body colors: Star Blue, Midnight Black, Flame Red, and Pearl White.
15
3
Share

Can LED Lights Be Installed Without Lenses?

It is not suitable to install LED lights without lenses, as this can cause severe light scattering, which actually reduces the visibility of the LED lights. Therefore, if you want to install LED lights, it is necessary to install lenses as well. LED bulbs have excellent light concentration, and the effect of switching between high and low beams can be achieved through the light-blocking plates inside the lenses. Without lenses, the light concentration of LED bulbs cannot be fully utilized due to the absence of light-blocking plates, leading to light scattering instead. Hence, LED lights and lenses should be installed together. If you must install LED headlights without lenses, you typically need to use high-performance LED bulbs and modify the reflector bowls for high and low beams to avoid light scattering and ensure visibility.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.