···
Log in / Register

Where is the cabin air filter located in the Regal?

4 Answers
LaCamila
08/27/25 6:56am

The cabin air filter in the Regal is located behind the glove compartment on the passenger side. To replace the cabin air filter, you need to remove the glove compartment. Taking the 2020 Regal as an example, it belongs to the mid-size car category, with a length of 4904mm, width of 1863mm, height of 1461mm, a wheelbase of 2829mm, a fuel tank capacity of 55 liters, and a trunk capacity of 441 liters. The 2020 Regal features a MacPherson strut front suspension and a multi-link rear suspension. It is equipped with a 1.5T turbocharged engine, delivering a maximum horsepower of 169PS, maximum power of 124kW, and maximum torque of 250Nm, paired with a 9-speed automatic transmission.

Was this review help?
12
5
Share
LondonRose
09/09/25 5:45am

The location of the Regal's cabin air filter is actually quite easy to find—it's right behind the glove compartment on the passenger side. Every time I replace it, I first open the glove compartment, then firmly press down on the retaining clips on both sides, allowing the entire compartment to drop down. Behind it, you'll see a rectangular cover panel, which can usually be unclipped with your fingers. The cabin air filter is hidden behind this panel. Just remember, the filter has a correct orientation—the arrow on it should align with the airflow direction when reinstalling. I recommend replacing it every six months or 10,000 kilometers, ideally during the transition between spring and summer to prevent musty odors in the AC. DIY replacement saves a lot of money—a compatible filter from Taobao costs only 30-50 yuan, much cheaper than at the dealership. Last time I checked, they charged me 120 yuan just for labor.

Was this review help?
14
5
Share
Expand All
LaJordan
10/23/25 6:36am

The Buick Regal's cabin air filter is located behind the glove compartment on the passenger side. First, fully open the glove box, then press inward on both plastic clips to release them, allowing the glove box to fold down completely. At this point, you'll see the white filter cover attached to the inner side of the dashboard. There's a small tab on the edge of the cover - just gently pry it open to remove it. Important reminder: Pay attention to the directional markings when removing the filter. When installing the new filter, the arrow must point downward toward the ground. I once installed it backward by mistake and ended up with half the airflow. By the way, the filter type matters too. For northern regions, I recommend the activated carbon version with PM2.5 protection. For humid southern areas, choose one with an anti-mold coating. Check it every six months - if it turns black or becomes stiff, replace it immediately.

Was this review help?
19
0
Share
Expand All
DelJaxson
12/06/25 7:00am

The Regal's cabin air filter is hidden behind the glove compartment on the passenger side, requiring its removal for access. The process is straightforward: first open the glove box to its maximum angle, then firmly press the limiters on both sides to lower the entire compartment. You'll then see the plastic cover of the filter; simply pry open the clips to remove the old filter. Remember to install the new filter with the arrow pointing in the correct direction. I check it every season, especially before using the AC in summer - skipping this can lead to unpleasant odors. Nowadays there are plenty of online video tutorials; just follow along and you'll be done in ten minutes. Opt for activated carbon filters for best results, as they effectively remove formaldehyde and odors.

Was this review help?
15
0
Share
Expand All
More Forum Discussions

What kind of oil does the Nissan QR25 engine use?

Nissan QR25 engine uses 5W/40 synthetic oil. The role of engine oil: As a lubricant for the engine, engine oil continuously flows into various transmission components during engine operation, forming an oil film between friction surfaces, thereby reducing friction resistance, lowering power consumption, and minimizing component wear. Precautions for using engine oil: The selection of engine oil should be based on the engine's requirements. It is unnecessary to use overly advanced oil in engines with lower requirements, nor should lower-grade oil be used in engines with higher requirements. Therefore, it is advisable to choose multi-grade oil, which offers advantages such as economy, long service life, and high efficiency, providing better protection for the engine. Due to the characteristics of multi-grade oil, phenomena such as premature darkening and lower oil pressure compared to conventional oil may occur during use, which are normal.
15
5
Share

Should You Press the Clutch When Braking in a Car?

You do not need to press the clutch when braking in a car. The correct method is to first press the brake to reduce speed, then press the clutch for gear shifting. When the car's speed is very low, remember to press the clutch to avoid stalling the engine. The purpose of braking is to decelerate, which can either reduce speed or bring the vehicle to a complete stop. The principle of braking involves converting the car's kinetic energy into heat energy to dissipate it. The car's clutch is located within the flywheel housing between the engine and the transmission. The clutch assembly is secured to the rear plane of the flywheel with screws, and the output shaft of the clutch serves as the input shaft of the transmission. During driving, the driver can press or release the clutch pedal as needed to temporarily disconnect or gradually reconnect the engine and transmission, thereby cutting off or transmitting the engine's power to the transmission.
16
4
Share

Will the hood break if slammed shut?

The engine hood has two buffer rubbers underneath that serve as shock absorbers! However, if you frequently slam it shut with force, these buffer rubbers can easily get damaged. Therefore, it's important to be careful when closing the hood in the future. Introduction to the Engine Hood: The engine hood (also known as the bonnet) is one of the most prominent body components and a part that car buyers often inspect. The main requirements for an engine hood are heat insulation, sound insulation, lightweight, and high rigidity. Engine Hood Structure: The engine hood is generally composed of an outer panel and an inner panel, with heat insulation material sandwiched in between. The inner panel enhances rigidity, and its geometric shape is chosen by the manufacturer, typically in a skeletal form.
20
5
Share

How long will it take for a driver's license to be revoked if 12 points are deducted and not processed?

If a driver's license is deducted 12 points and the driver fails to participate in the study and examination within 35 days, the traffic management department of the public security organ will announce the suspension of the use of their motor vehicle driver's license. Relevant regulations: If a motor vehicle driver accumulates 12 points in a scoring cycle, the traffic management department of the public security organ shall detain their motor vehicle driver's license. Participation in study: The motor vehicle driver shall, within 15 days, participate in a seven-day study of road traffic safety laws, regulations, and related knowledge at the traffic management department of the public security organ where the driver's license was issued or where the violation occurred. After the motor vehicle driver completes the study, the vehicle management office shall conduct an examination on road traffic safety laws, regulations, and related knowledge within 20 days.
6
3
Share

How Many Times Will Cylinder Wear Increase Without an Air Filter in the Engine?

Without an air filter, cylinder wear in the engine will increase by 8 times. Hazards of operating an engine without an air filter: During operation, the engine draws in a large amount of air. If the air is not filtered, the suspended dust particles in the air will be drawn into the cylinder, accelerating the wear of the piston assembly and the cylinder. Larger particles entering between the piston and cylinder can cause severe "cylinder scoring," especially in dry and sandy working environments. The air filter is installed at the front of the intake pipe to filter out dust and sand particles, ensuring that sufficient and clean air enters the cylinder. Types of air filters: Air filters generally come in two types: paper and oil-bath. Paper filters are widely adopted due to their advantages of high filtration efficiency, light weight, low cost, and easy maintenance. The filtration efficiency of a paper filter element can exceed 99.5%, while the oil-bath filter typically achieves 95-96% filtration efficiency under normal conditions.
18
0
Share

What is the difference between yellow license plates and blue license plates?

Yellow license plates and blue license plates differ in the following aspects: Requirements for driver's license: Yellow license plate vehicles can only be driven with a B-class driver's license or above; blue license plate vehicles can be driven with a C-class driver's license or above. Different traffic restrictions: Yellow license plate vehicles require a traffic permit to enter urban areas; blue license plate vehicles can directly enter urban areas. Applicable vehicle types differ: Yellow license plates are used for large vehicles, trailer license plates, ordinary motorcycle license plates, low-speed vehicle license plates, and ordinary M2-class light passenger vehicles; blue license plates are used for general passenger vehicles, M1-class light passenger vehicles, light trucks with a load capacity of less than 1.0 tons, and light motorcycles. Different requirements for operating permits: Yellow license plates require an operating permit; blue license plates do not require an operating permit.
1
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.