Where is the cabin air filter located in the Peugeot C3XR?

1 Answers
DeJuliet
07/25/25 12:18am
The cabin air filter in the Peugeot C3XR is located on the lower left side of the passenger seat. The replacement method for the cabin air filter is as follows: 1. Pull out the fixing buckle on the right side of the glove box outward; 2. Remove the fixing buckle of the glove box cover and take off the glove box; 3. Press the fixing buckles on both sides of the cover plate to remove the old cabin air filter; 4. Install the new cabin air filter. The Peugeot C3XR is a compact SUV with the following dimensions: length 4282mm, width 1748mm, height 1557mm, wheelbase 2655mm, and a curb weight of 1220kg. It is equipped with a 1.2L 4-cylinder turbocharged engine.
Was this review help?
12
2
Share
More Forum Discussions

What are the effects of a faulty battery controller in an Audi A6?

A faulty battery controller in an Audi A6 typically manifests as the car being unable to move, or the vehicle lacking power, resulting in weak starts and difficulty pushing the car. Check for poor contact in the wiring and whether any wire connections have water ingress leading to leakage. If there is any sign of melted wiring, it is essential to inspect whether the wires have fused together before determining if the issue lies with the controller. Generally, problems with an electric vehicle controller are accompanied by abnormal noises from the motor. Below is an introduction to the electric vehicle controller: 1. Definition: The electric vehicle controller is the core control device used to manage the motor's start, operation, direction, speed, and stop, as well as other electronic components of the vehicle. It acts like the brain of the electric vehicle and is a critical component. It primarily controls the motor's speed and includes multiple protective functions such as under-voltage protection, current limiting, and brake power cutoff. 2. Composition: The motor control system of an electric vehicle generally consists of the motor, power converter, sensors, and the controller. The control circuit mainly includes: the control chip and its drive system, AD sampling system, power module and its drive system, hardware protection system, position detection system, and bus support capacitor.
1
3
Share

What does engine punching mean?

Engine punching refers to a fault where the engine cylinder gasket is burned and damaged, resulting in poor sealing of the engine cylinder and combustion chamber. This fault has different names in different regions. Some places call it "cylinder gasket blowout," while others refer to it as "cylinder gasket punching" or simply "punching." Below is additional information: 1. Symptoms of engine punching: Reduced power output, difficulty starting, water mixing with engine oil in the cylinder, which reduces the lubrication effect of the oil, increases wear between the piston and cylinder, and may lead to cylinder scoring and eventual scrapping. In more severe cases, the oil pan may be flooded with coolant, causing significant trouble. When severe punching occurs, the engine may have difficulty starting, and white, watery vapor may be emitted from the exhaust port. At this point, attention should be paid to the working condition inside the cylinder. 2. Cylinder gasket: Commonly known as the cylinder head gasket, it is installed between the cylinder head and the cylinder block. Its primary function is to seal the joint surface between the cylinder block and the cylinder head to prevent gas leaks, coolant leaks, and oil leaks. 3. Cylinder gasket materials: Most cylinder gaskets are made of asbestos board. Some are made with copper or iron sheets on both sides of the asbestos board, while others consist of steel sheets on both ends with flexible latex-asbestos board in between. The combustion chamber holes are reinforced with double or single-layer metal edges to prevent combustion gases from damaging the asbestos layer.
20
2
Share

Is it normal for Audi A6 headlights to fog up?

Audi headlights fogging up inside is a normal physical phenomenon. When the temperature outside the headlight cover is low, and the headlights are turned on, the inside of the cover heats up. The temperature difference between the inside and outside causes fog to form. After the headlights have been on for a while, the temperature rises, and the fog will evaporate due to the heat generated by the headlights. More information about car headlights is as follows: 1. Introduction: Car headlights, also known as front headlights, are lighting fixtures used to illuminate the road ahead during night driving. They are symmetrically installed on both sides of the front end of the vehicle. 2. Working principle: LED is an electroluminescent device that uses a solid-state semiconductor chip as the light-emitting material. It emits light directly through the recombination of carriers, which causes photon emission. LED headlights are lighting devices that use LEDs as the light source.
20
4
Share

Where is the fuel tank cap opening switch on the Audi A6?

Audi A6's fuel tank cap switch is located at the lower part of the driver's door, on the left side of the driver's legroom area. The fuel tank cap switch is grouped with the front engine compartment switch - simply press this electronic switch to open the fuel tank cover. For models with keyless entry, keep the key near the vehicle and ensure the engine is off (without locking the car) to open the fuel tank cap. Fuel tank usage precautions are as follows: 1. Don't wait for the low fuel warning light: Check the fuel gauge before driving and calculate whether refueling is needed based on trip distance and gauge readings. Refuel in advance rather than waiting for the warning light. The fuel pump (located inside the tank) generates significant heat during operation and relies on fuel for cooling. When the warning light activates, fuel level has dropped below the pump, which may shorten its lifespan or even cause burnout if repeatedly allowed; 2. Optimal refueling time: Morning or evening is preferable as temperatures are lower and gasoline has lower vaporization points. Gasoline expands with heat and contracts with cold, and is sold by volume. Cooler temperatures yield higher density and greater mass per volume unit, effectively giving more fuel; 3. Avoid full tanks for city driving: There's no need to completely fill the tank for urban commuting. A full tank adds engine load and increases fuel consumption. Since urban areas have abundant gas stations, partial refueling is more practical.
7
4
Share

Which gear to start with a 10-speed FAST transmission?

10-speed FAST transmissions generally start in 2nd gear on flat roads; choose 1st gear when starting on steep slopes. Heavy trucks and light trucks have different starting gears - heavy trucks start in 2nd gear on both flat roads and slopes. Here is additional information: 1. There are two key points to note when operating a FAST 10-speed transmission: First, always depress the clutch when shifting gears; Second, when switching between high and low ranges, first activate the range selector switch before upshifting. 2. FAST transmissions offer high reliability: relatively fuel-efficient, durable, easy to maintain, with readily available spare parts. As an established brand in automotive transmissions, FAST boasts mature technology and strong brand reputation. Most importantly, FAST prioritizes user experience and promptly addresses customer issues.
10
1
Share

How Much Bigger Are 19-Inch Tires Compared to 18-Inch?

19-inch tires are designed for 19-inch rims, while 18-inch tires are meant for 18-inch rims. Both 18-inch and 19-inch tires have similar widths, and their rolling radius difference is less than 0.4%, meaning they should provide nearly identical contact patches. The specific differences are as follows: 1. Braking performance: There is almost no difference in dry braking performance between 18-inch and 19-inch tires, but 19-inch tires offer slightly faster dry handling. In wet conditions, 18-inch tires perform best in braking, and they also excel in cornering hydroplaning resistance. Based on current objective data, these two tire sizes show almost no substantial differences. 2. Subjective handling: During dry handling tests, the subjective feel of the tires improves as the size increases. The faster lap times with 19-inch tires aren't due to increased grip from larger wheels but rather because these tires provide sharper and more responsive steering, while 18-inch tires make the car feel softer and less precise. 19-inch tires give drivers more confidence and stability. 3. Comfort and noise: 18-inch tires transmit more road imperfections to the driver, especially noticeable in the rear of the car. While the noise level of 18-inch tires is acceptable, it's still perceptible inside the cabin. With 19-inch tires, the car's comfort deteriorates significantly, becoming noticeably harsh and uncomfortable.
18
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.