Where is the cabin air filter located in the Nissan X-Trail?

2 Answers
LaAndres
07/24/25 6:50pm
Nissan X-Trail's cabin air filter is located on the passenger side. Below are additional details: 1. The filter is situated below the glove compartment, near the center console. Looking up from the floor, you can see arrows pointing to the cabin air filter housing, which has three clips. Gently pry them open to access the filter. 2. To replace the cabin air filter, first remove the old one (the white filter) by simply pulling it out. 3. After removing the old filter, run the air conditioner on both cold and hot settings at maximum fan speed for 3 minutes each. Then install the new filter with the black activated carbon side facing the driver's seat, ensuring it's not installed backwards.
Was this review help?
5
5
Share
McLukas
08/11/25 10:27am
As a Nissan X-Trail owner for several years, I can share that the cabin air filter is located behind the glove compartment on the passenger side. You may need to open the glove box first, gently press down or wiggle it to empty any contents inside. Then, you'll notice screws or clips on both sides of the glove box - just loosen them with a regular screwdriver or unclip to remove the entire glove box. Once removed, you'll find a rectangular cover near the center; opening it reveals the filter. I replace mine annually at around 15,000 km, and it's extremely simple to do. Just ensure the arrow on the filter aligns with the airflow direction - incorrect placement affects filtration. After installing a new filter, the cabin air becomes noticeably fresher, reducing odors and dust accumulation while preventing ventilation system blockages, saving you trips to the mechanic. If you frequently drive in sandy/dusty areas, replacing it earlier provides better protection. The whole process takes under ten minutes and is quite practical.
Was this review help?
7
0
Share
Expand All
More Forum Discussions

What Does S Gear Mean?

Car S gear is the sport mode of a car. Many automatic transmission cars are equipped with an S gear, and some high-end models of A-class cars also feature an S gear design. In S gear sport mode, the transmission can shift freely, allowing the car to maintain high RPM at lower gears for an extended period, thereby achieving greater torque output and acceleration. While driving, simply push the gear lever into the S gear position, which is typically used for climbing slopes and quick overtaking. In S gear sport mode, the transmission can shift freely, but the shifting timing is delayed, keeping the engine at high RPM for a longer duration with increased fuel injection. As a result, fuel consumption in S gear mode is higher than in normal mode.
20
2
Share

How to Adjust the Headlight Height of the Lynk & Co 03?

The method to adjust the headlight height of the Lynk & Co 03 is as follows: On the far left side of the dashboard near the door, there is a black button that can be rolled up and down, with indicator lines from thick to thin beside it. Rolling the button up and down adjusts the headlight height. The Lynk & Co 03 headlight height has four levels: Level 0, Level 1, Level 2, and Level 3. The higher the level, the brighter the light. The headlight height should be adjusted according to actual driving conditions. When the front seats are occupied and the trunk is empty, it can be adjusted to Level 0; when the vehicle is fully loaded with passengers and the trunk is empty, adjust to Level 1; when the vehicle is fully loaded with passengers and the trunk is fully loaded, it can be adjusted to Level 2 or Level 3.
9
0
Share

What are the consequences of not wearing a seatbelt on the highway?

Forgetting to wear a seatbelt on the highway will result in a one-time penalty, including a fine and two demerit points on the driver's license. It is essential to fasten the seatbelt while driving a motor vehicle to ensure the safety of the occupants in case of an accident. Below is some relevant information about seatbelts: 1. The primary function of a seatbelt is to protect the safety of the vehicle's occupants. It restrains the occupants in their seats, preventing forward impact and avoiding secondary injuries. 2. Drivers must use seatbelts as required by regulations, and passengers must also wear seatbelts. Both drivers and passengers who fail to use seatbelts will face penalties, though the standards vary by region. Some areas impose demerit points and fines, while others may only issue warnings. The specific penalties depend on the local traffic regulations.
7
4
Share

What brand are the tires on the Baojun 730?

The original tires of the Baojun 730 are from the Giti brand, with two models available: 195/55R16 and 205/55-R16. More details are as follows: 1. Tires are circular elastic rubber products assembled on various vehicles or machinery for ground rolling. They are usually mounted on metal rims to support the vehicle body, cushion external impacts, ensure contact with the road surface, and maintain the vehicle's driving performance. 2. Tires often operate under complex and demanding conditions, enduring various deformations, loads, forces, and high and low temperatures during use. Therefore, they must possess high load-bearing capacity, traction performance, and cushioning properties. 3. Additionally, they are required to have high wear resistance and flex resistance, as well as low rolling resistance and heat generation. Half of the world's rubber consumption is used for tire production, highlighting the significant demand for rubber in tire manufacturing.
1
3
Share

How to Turn On the Sound for the Reversing Camera?

The reversing camera itself does not have sound, so there is no such thing as turning on the sound for it. The reversing camera is only responsible for displaying images, while the sound is emitted by the reversing radar. If there is no sound from the reversing radar, it may be because the reversing radar switch is turned off. Below is some relevant information about the reversing radar: 1. The reversing radar provides sound alerts but does not display images. The reversing camera displays images but does not provide sound alerts. The reversing camera and reversing radar complement each other, both serving as aids to assist drivers in reversing. 2. The reversing radar, also known as the parking radar, operates by using ultrasonic waves for echolocation to detect the distance between the vehicle and obstacles, then provides alerts through sounds of varying frequencies. 3. The reversing radar emits different sounds and frequencies depending on the distance to obstacles. The closer the obstacle, the louder and higher the frequency of the sound; if the obstacle is farther away, the sound is softer and the frequency is lower.
9
5
Share

Does Using Air Conditioning in Winter Increase Fuel Consumption?

Using the air conditioning for cooling consumes fuel, but using it for heating in winter does not. When the air conditioning is used for cooling, the air conditioning unit is in operation, powered by the car's engine, which increases the load and thus fuel consumption. However, using the air conditioning for heating in winter does not consume fuel. Below is an introduction to car heating: 1. The heating comes from the heat generated by the engine during operation: After the engine's cooling system dissipates heat from the engine, a fan directs this heat into the car to create warm air. When the heating is not in use, the fan stops, and the heating vent closes, allowing all the heat to dissipate into the atmosphere. Therefore, car heating is a form of waste heat reuse and does not consume fuel. 2. The AC button controls the air conditioning compressor. In summer, when using the air conditioning, the AC button must be pressed to activate the cooling function. However, heating simply utilizes the car's internal heat cycle and does not require the air conditioning compressor to be activated. Thus, to use the heating, you only need to adjust the air conditioning controls without pressing the AC button.
13
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.