···
Log in / Register

Where is the cabin air filter located in the Nissan Sylphy?

4 Answers
DelKatherine
07/29/25 8:10am
The cabin air filter in the Nissan Sylphy is located behind the front passenger glove box. To replace the cabin air filter, you must first remove the glove box. There are 3 screws at the bottom of the glove box. After opening the glove box, you will see several fixing screws inside. Once these screws are removed, the glove box can be taken out, revealing the cover plate for the cabin air filter inside. The Nissan Sylphy is a Class A sedan under Dongfeng Nissan. In terms of body dimensions, the car measures 4641mm in length, 1815mm in width, and 1447mm in height, with a wheelbase of 2712mm. The vehicle is equipped with dual front auxiliary airbags, front side auxiliary airbags, curtain-style auxiliary safety airbags, speed-sensing automatic door locks, collision-sensing automatic unlocking, LED high-mounted brake lights, a rearview camera monitoring system, and a rear parking sensor system.
Was this review help?
19
4
Share
LeJohn
08/13/25 4:10am
I just replaced the cabin air filter in my Nissan Sylphy, which is conveniently hidden behind the glove compartment in front of the passenger seat, making it DIY-friendly for car owners. To locate it, first clear out any items in the glove box, then find the plastic clips on both sides of the glove compartment—gently press them to release and open the entire box. Next, you’ll spot a small rectangular cover; pry it open to slide out the old filter. I recommend replacing it every 10,000 kilometers or once a year. When installing the new filter, make sure to align the airflow direction arrow to maintain efficiency. Doing it yourself is super easy—saving you a couple hundred bucks in labor costs at the shop—while ensuring clean cabin air, especially during spring when pollen levels are high (replace it more frequently to prevent allergies). Be gentle during removal/installation; use a flathead screwdriver to carefully pry open the cover to avoid damaging plastic parts. Once done, simply push the glove box back into place. Its fixed location here makes maintenance easier. If you notice odd smells while driving, check if the filter is dirty—making it a habit saves money and promotes health.
Was this review help?
10
1
Share
Expand All
DiKyle
10/05/25 4:49am
My car is a Nissan Sylphy, and the cabin air filter is located behind the glove box, which is very easy to find. Replacing it isn't difficult either: first, empty the items in the glove box, gently press down on the clips on both sides to remove the glove box, then lift the small plastic cover to take out the old filter. I often remind my friends to check it every six months or 8,000 kilometers because accumulated dust can reduce the airflow from the AC and cause unpleasant odors. Spending a few minutes to replace it yourself saves money and prevents bacterial growth. The filters are very cheap to buy online—just choose the correct matching model and install it properly, making sure not to reverse the arrow direction to ensure smooth airflow. Its placement on the passenger side is for convenient and quick maintenance, being unobtrusive yet practical. I always check the air from the vents after replacement to ensure it's fresh, addressing any issues early to avoid costly repairs later.
Was this review help?
13
1
Share
Expand All
LeMadelyn
11/18/25 6:21am
I drive a Nissan Sylphy, and the cabin air filter is located in the footwell area on the passenger side. You need to remove the glove box to access it. Changing it yourself is quite easy: open the glove box, press and release the clips on both sides to remove it, then open the cover to take out the old filter and replace it with a new one. Check for clogs every 9,000 kilometers. When installing the new filter, align the markings to ensure the airflow direction is correct for optimal filtration efficiency. The convenient location makes it easy for owners to handle, saving money and being practical.
Was this review help?
17
5
Share
Expand All
More Forum Discussions

Is the Baojun LJO engine a General Motors product?

Baojun LJO engine is a General Motors product. Advantages of Baojun LJO engine: The new Baojun 530 is equipped with a 1.5T engine codenamed LJO, which meets the China VI emission standard. It has a maximum power of 147 horsepower and a peak torque of 250 Nm. The transmission system is matched with a 6-speed manual or CVT gearbox, with a fuel consumption of 6.7L per 100 kilometers. Disadvantages of Baojun LJO engine: The Baojun LJO engine currently has limited application in vehicle models. If not properly maintained after driving, some minor issues may occur. This increases maintenance costs and requires more effort.
9
3
Share

What Causes the Shaking of Audi 01J Transmission?

Audi 01J transmission shaking reasons are as follows: Excessive Carbon Deposits: Too much carbon buildup inside the engine can absorb some oil during startup, leading to a lean air-fuel mixture. Once the carbon deposits become saturated with gasoline, the engine starts operating normally. However, when the mixture is ignited, the gasoline absorbed by the carbon deposits is drawn back into the cylinders by vacuum suction, causing an overly rich mixture. This alternation between lean and rich states results in engine shaking. Dirty Throttle or Air Filter: A clogged air filter restricts sufficient air from entering the engine cylinders, disrupting the air-fuel ratio and causing insufficient engine power, leading to shaking. A dirty throttle may not close properly, resulting in a lean mixture at idle and reduced engine power. Spark Plug Failure: Over time, spark plugs can develop increased gaps or excessive carbon buildup at the ignition points, leading to poor sparking or insufficient ignition energy. This can cause misfiring, reduced power, and engine shaking. Aging Engine Components: Worn-out engine mounts fail to provide adequate cushioning, contributing to the shaking.
5
0
Share

Why does the Vios engine shake when parked?

Vios engine shaking when parked may be caused by the following reasons: Intake system failure: Excessive dirt on the throttle body or intake manifold, or a clogged air filter element reduces the cross-sectional area of the idle channel. This results in less air entering the cylinders than normal, causing the air-fuel mixture to become too rich, incomplete combustion in the cylinders, and ultimately engine shaking. Intake pipe or EGR valve leakage: When more air than normal enters the cylinders, the air-fuel mixture becomes too lean, reducing cylinder power output. If the EGR valve doesn't close properly, some exhaust gas enters the cylinders, increasing residual exhaust gas volume and worsening combustion conditions, leading to reduced engine power and consequent shaking.
19
5
Share

Is the Geely Borui GE a hybrid vehicle?

Geely Borui GE is available in 5 MHEV (Mild Hybrid Electric Vehicle) and 3 PHEV (Plug-in Hybrid Electric Vehicle) models. Differences between hybrid and plug-in hybrid: Charging method: Hybrid vehicles cannot be charged via an external power source and rely solely on the engine for charging, whereas plug-in hybrid vehicles require an additional power source for charging. License plate issue: Hybrid vehicles are not eligible for new energy vehicle license plates, while plug-in hybrid vehicles can obtain new energy license plates. This means hybrid vehicles cannot benefit from local government subsidies for new energy vehicles. Without a license plate, the vehicle cannot be driven on the road, making the license plate issue crucial to resolve.
12
2
Share

Is the Previa Front-Wheel Drive or Rear-Wheel Drive?

Previa is currently rear-wheel drive. Development History: The early Previa models (from the 1990s) were indeed front-wheel drive; however, they were later changed to front-wheel drive. The Previa, originally known as the Toyota Big Bread or Big Overlord, typically adopts rear-wheel drive like most passenger vehicles, but the Big Overlord uses front-wheel drive. Models: Previa is the transliteration of Big Overlord. The 2.4L version is the China-spec model, while the US-spec model is called the Sienna with a 3.3L displacement, all of which are front-engine, front-wheel drive (FF) configurations. The Prado, later renamed the Land Cruiser, features full-time four-wheel drive (4WD) across all models.
11
3
Share

What are the updated key data for BMW G series?

BMW G series updated key data are as follows: Manual transmission method: Maintenance key data is stored in the Comfort Access and Start System and transmitted to the identification transmitter. Transmission occurs automatically when specific conditions are met, or can be done manually. During maintenance, this data can be read out using a BMW key reader. The maintenance key data is automatically updated during each driving session. Data includes: Vehicle condition maintenance data, check control information, fault code memory records. Update conditions are: "Terminal 15 is on", vehicle speed above 40km/h and below 40km/h, data is updated after driving 10km when vehicle speed is below 40km/h. When the engine is off, the remote signal receiver transmits data to the identification transmitter. Even after the identification transmitter leaves the vehicle, data continues to be written. The identification transmitter's data can now be read.
11
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.