···
Log in / Register

Where is the cabin air filter located in the new BMW X1?

6Answers
DeNora
07/29/2025, 12:27:45 AM

The cabin air filter in the new BMW X1 is located on the side panel of the front passenger seat, specifically near the left foot area of the front passenger. Below is additional information regarding the cabin air filter in the new BMW X1: Replacement method for the cabin air filter in the new BMW X1: The glove compartment base plate is secured by two nuts. Use an 8mm socket screwdriver to remove the nuts and take off the base plate. Be careful not to use excessive force when removing the base plate. Disconnect the wiring harness above it before completely removing the base plate. After removing the base plate, proceed to remove the side panel. Use a screwdriver to unscrew the screws. Note that there are three additional snap fasteners inside the side panel. Once the side panel is removed, you will find the cabin air filter and its housing. Open the latch to access the cabin air filter housing, then remove the cover to replace the cabin air filter. Cleaning method for the cabin air filter: If the filter is heavily soiled, use compressed air to clean it from the bottom up. Maintain a distance of 5cm (centimeters) between the air nozzle and the filter, and blow at 500kPa (kilopascals) for approximately 2 minutes.

Was this review help?
102
Share
OSavannah
08/12/2025, 12:48:24 PM

My BMW X1 is the 2022 model, and the cabin air filter is located in the footwell area under the passenger seat, specifically hidden behind the trim panel at the back of the glove compartment. You’ll need to empty the glove box first, locate the plastic clips underneath, and pry them open to access the filter housing. Last time I replaced it myself, it took some time, but be careful not to break the clips. The filter plays a big role in trapping dust and pollen, keeping the cabin air fresh—just remember to turn off the AC system before replacement to avoid inhaling debris. Set a reminder to replace it every 6,000 to 8,000 km, especially after long trips. If you’re unsure about the location, snap a photo and ask in the owner’s group—everyone’s helpful, just don’t force anything open.

Was this review help?
6
Share
Expand All
BradleyFitz
10/02/2025, 11:06:05 PM

Regarding the location of the cabin air filter in the new BMW X1, I found during my research that it's beneath the felt layer on the front passenger side, requiring removal of the glove compartment or adjacent trim panel. When installing the filter, pay attention to the arrow direction to avoid incorrect orientation, which could affect airflow. I usually use a multi-tool to gently pry open the clips and replace it with an OEM or branded filter to improve air filtration and reduce odors. Regular replacement, such as quarterly, helps maintain efficient AC operation and prevents bacterial growth. Additionally, slight design variations exist between different model years of the X1, so filter models may differ—consulting the manual or watching owner-shared videos on automotive forums is more reliable.

Was this review help?
10
Share
Expand All
DeHannah
11/15/2025, 11:45:45 PM

I've been driving the new BMW X1 for half a year now. The cabin air filter is located under the passenger seat, right near the glove compartment. You can easily find it yourself—just open the door, bend down to look under the trim panel, and remove a few screws. The filter should be replaced regularly. After changing it, I noticed the cabin feels less stuffy, and the air is much cleaner. Don’t wait too long to replace it.

Was this review help?
13
Share
Expand All
StRemington
01/06/2026, 01:23:28 AM

Replacing the cabin air filter is quite simple: First, park and turn off the engine, open the glove compartment and clear out its contents. You'll see several clips or screws—use a screwdriver to remove them, pull off the trim panel, and the filter housing will be exposed. Take out the old filter, insert the new one in the direction of the arrow, press it firmly into place (avoid excessive force to prevent damage). I always check the air ducts for dust accumulation after each replacement, then test the airflow by turning on the AC afterward. It's best to wear gloves during the process to keep hands clean, and avoid placing heavy items in the glove compartment to prevent affecting future use. Regular maintenance helps extend the system's lifespan.

Was this review help?
9
Share
Expand All
VonAugust
04/03/2026, 12:48:32 AM

The air filter in the new BMW X1 plays a crucial role in filtering outside air to ensure a fresh interior environment. It's located near the central tunnel at the passenger footwell. Every time I replace the filter, I carefully check if the filter material has aged, such as fraying, and replace it if necessary. It's recommended to inspect it every season, especially during rainy or foggy days, to reduce allergens. Be cautious not to scratch the interior when locating it. A good filter ensures the air conditioning blows cooler and healthier air. Don't neglect maintenance; it makes breathing in the car much more comfortable.

Was this review help?
3
Share
Expand All
More Q&A

What should be noted when replacing the front windshield?

After replacing the front windshield, the following points should be noted: 1. Do not wash the car within three days after replacing the windshield, and remove the tape fixing the windshield position after three days. 2. Try to avoid driving on excessively bumpy roads, and avoid emergency braking and rapid acceleration to prevent the windshield from shifting. 3. Do not insert parking permits or other cards into the gap between the front windshield and the dashboard. 4. Do not drive on highways, and keep the maximum speed below 80 km/h. 5. Do not apply window film within seven days. Methods for maintaining the car windshield: 1. Proper use of windshield washer fluid: In daily windshield maintenance, choose windshield washer fluid reasonably according to the season and weather. 2. Apply film to the windshield: When selecting the UV protection index of the heat-insulating film, the higher the better, as it can protect the dashboard components from premature aging due to prolonged sun exposure. 3. Purchase glass insurance for the car: Glass breakage insurance is a commercial insurance where the insurance company is responsible for compensating for the loss of the insured vehicle's glass during use. 4. Regularly clean the wipers: Because dust in the air and oil stains from vehicle exhaust will adhere to the windshield and wiper blades over time, increasing the friction during wiping, which can cause scratches on the windshield.
109
Share

What are the reasons for different colored warning lights?

Red indicator lights are all fault warning lights, so when you see the car's indicator light turn red, you should pull over as soon as possible. The main red warning lights include: engine oil pressure warning light, engine temperature warning light, charging warning light, and brake fluid level warning light. Once these lights come on, you need to stop immediately or turn off the engine for inspection and should not continue driving. Yellow indicator lights (warning, prevention is better than cure) lack the urgency of red flashing lights, so many car owners do not take yellow indicator lights seriously. However, the appearance of a yellow indicator light means there is a potential safety hazard in your vehicle. For example, if a bulb in the car burns out, the "bulb warning light" will flash continuously to prompt replacement. Other examples include the engine (exhaust system) fault light, oil system fault light, battery and power generation system fault light, etc. When a yellow indicator light comes on, the driver should address the issue as soon as possible. Green indicator lights (safe driving) Green indicator lights are functional indicator lights for the vehicle, such as the turn signals that flash green when turning. In addition, the low beam headlights, front fog lights, and width indicator lights are all very familiar to most car owners. Blue indicator lights (reminder, pay attention) Similar to green indicator lights, blue indicator lights such as the high beam indicator light and the recirculation indicator light generally serve to indicate the working status of various vehicle functions. However, when a blue indicator light comes on, car owners should still be cautious. For example, the high beam headlights turn blue when activated, and you need to be aware of whether the high beams are affecting other vehicles.
109
Share

Can a Car Battery Really Be Repaired?

A car battery can be repaired, but only if its voltage is above 9V, the casing is intact, and its shape has not changed. Methods for maintaining a car battery include: 1. Avoid storing it in a discharged state: A discharged state refers to when the battery is not recharged promptly after use, which can easily lead to sulfation. Lead sulfate crystals form on the plates, blocking ion channels and resulting in insufficient charging and reduced battery capacity. The longer the battery remains idle in a discharged state, the more severe the damage. When the battery is not in use, it should be charged once a month to extend its lifespan. 2. Prevent exposure to high temperatures: An excessively hot environment increases internal pressure in the battery, forcing the pressure relief valve to open automatically. The direct consequence is an increased loss of water from the battery, which inevitably leads to reduced battery activity, accelerated plate softening, and fatal damage such as heat generation during charging, bulging, or deformation of the casing.
119
Share

Reasons Why a Four-Wheel Electric Vehicle with Power Doesn't Move When Accelerating

This issue may be caused by damage to the Hall sensor or regulator. Electric vehicles are a common mode of transportation and have a relatively simple structure. The key components of an electric vehicle include the frame, motor, battery, and regulator. The regulator is usually fixed under the rear seat and is responsible for regulating the entire vehicle's circuit. If the regulator is damaged, the electric vehicle cannot function properly. Below are the possible reasons: 1. Damage to the Hall element inside the accelerator (throttle). 2. The brake power-off system is stuck or not reset. 3. Broken control circuit or faulty controller. 4. Motor failure.
108
Share

What should be turned on when a motor vehicle exits the highway?

When a motor vehicle exits the highway, the right turn signal should be turned on. The turn signal is an important indicator light that is activated when the vehicle turns to alert surrounding vehicles and pedestrians. The turn signal bulb uses a xenon tube, controlled by a single-chip circuit, with alternating left and right flashing in continuous operation. The turn signal employs a flasher to achieve light blinking, which can mainly be divided into three types: resistance wire type, capacitor type, and electronic type. The ramp is a road on the right side of the highway entrance (usually 150 to 200 meters long), serving as the acceleration lane to enter the highway (since the minimum speed on the highway is 70 km/h, all vehicles must accelerate to at least 70 km/h in this lane before entering the highway lane). Before entering the highway, the left turn signal should be turned on. Since the highway lane is on the left, activating the left turn signal allows vehicles behind in the driving lane to clearly understand the intention to avoid accidents.
108
Share

How to Change the Transmission Oil for Haval H2?

Haval H2 transmission oil replacement method: 1. Drain all the oil from the oil pan, then pour in the same amount of new oil; 2. Remove the outlet pipe connecting the transmission to the transmission oil cooler, use an air tank to blow some air into it, and force the oil in the cooler back into the transmission through the return pipe; 3. Connect a long pipe to the interface where the outlet pipe was removed, start the engine, and the transmission will begin circulating. When the oil coming out is the color of the new oil, the replacement is complete. The Haval H2 is a city SUV under the Haval brand, with dimensions of 4330mm in length, 1815mm in width, and 1700mm in height, and a wheelbase of 2560mm. In terms of appearance, the Haval H2 continues the Haval family's hexagonal and large U-shaped grille design, along with standard LED diamond-effect linear daytime running lights.
115
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.