Where is the cabin air filter located in the Ford New Generation?

What Does a Yellow Light in a Car Indicate?

When the yellow light in a car illuminates, it indicates a current fault in the engine system that requires timely inspection and repair. The engine warning light is directly related to the engine's lifespan and driving safety. When the engine warning light comes on, it means the vehicle's electronic control system has detected that certain engine system parameters or information have exceeded the preset range. Poor performance in the engine system can trigger the warning light, such as faults in the throttle pedal sensor, throttle position sensor, mass airflow sensor, or poor circuit connections. A yellow engine light signifies an engine fault. If the car shows no other abnormalities, it can still be driven. However, if severe shaking, loss of power during acceleration, or other serious symptoms occur, it is not advisable to continue driving. Continuing to drive may worsen the fault, damage the engine, or cause additional issues. In such cases, it is necessary to visit a 4S shop or repair center for professional diagnosis and repair. After the engine warning light comes on, there may be some abnormal conditions. If not addressed promptly, it can lead to further problems, such as increased combustion chamber temperature, accelerated wear, and potential early engine damage. Increased engine noise may affect driving and passenger comfort. Higher fuel consumption wastes both petroleum resources and money. The engine may also start burning oil.

11

5

Share

What is the normal mileage for a new car when taking delivery?

Mileage displayed within the range of 0-100 kilometers is considered normal. Under normal circumstances, for domestically produced vehicles, a mileage of generally within 50 kilometers is considered normal, as a car inevitably needs to travel a certain distance from the factory to the 4S dealership. However, for imported vehicles, considering factors such as transportation, port handling, and customs clearance, the mileage generally should not exceed 100 kilometers. There are three key points to note when inspecting a new car: 1. Check the paintwork: The uniformity and smoothness of the seams are the focus of inspection. It is best to compare with two vehicles of the same model. The gaps between the doors, bumpers, and engine hood should be consistent. If the gaps are too large or the width differs from other vehicles, careful consideration is needed; 2. Check the tires: The tires of a new car should have no damage on the sidewalls, and the front tire sidewalls and tread should show no puncture marks. It is ideal if the tread hairs are intact on both front and rear tires, at least the rear tire hairs should be visible. If tread hair marks are missing on both front and rear tires but the odometer shows only a few kilometers, this is abnormal; 3. Check the nameplate: Each vehicle's nameplate corresponds to the unique engine number and chassis number. Verify these numbers with the certificate of conformity to ensure the codes match. Also, check the manufacturing date on the nameplate; the time between delivery and manufacturing should not exceed three months.

14

3

Share

Where is the ETC device installed?

The ETC is generally installed in the upper middle part of the front windshield for most vehicles, while for large vehicles like trucks and buses, it is installed in the lower middle part. The appropriate installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with pre-installed or aftermarket explosion-proof film, which may affect the signal transmission of the microwave communication link, the ETC should be installed in the microwave sunroof strip. ETC stands for Electronic-Toll-Collection, meaning electronic toll collection system. To apply for ETC, the vehicle owner needs to provide their valid ID card and the original and photocopy of the vehicle registration certificate. If the application is made by a non-owner, the agent's valid ID card is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also needed, and the vehicle must be registered under the name of an individual aged between 18 and 60. For company vehicles, the required documents are: An introduction letter from the vehicle owner (with official seal); Copy of the organization code certificate or business license (with official seal); Original ID card of the agent; Original vehicle registration certificate; The vehicle that needs to have ETC installed. Here are some precautions for installing ETC: Do not obstruct the view, it's best to install it behind the rearview mirror: Many car models have a large inclination angle of the windshield, which can reduce the driver's field of vision. If this is not considered during ETC installation, it can increase the driver's blind spot. Installing it on the right side behind the rearview mirror can avoid obstructing the view. Do not affect charging: The ETC electronic tag consumes power, but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, during installation, avoid the blackened areas on the windshield and do not install it where the solar panel can be easily blocked. Do not remove it casually once installed: The button in the middle of the adhesive is an anti-removal lever, connected to a switch underneath. After the electronic tag is installed, the windshield will press the anti-removal lever in. If it is removed casually, the lever will pop out and trigger the switch, locking the electronic tag and making it unusable. You will then need to go to an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device.

5

3

Share

What Are the Buick Business Vehicle Models?

Buick has two business vehicle models: the GL6 and the GL8. Below is more detailed information about Buick's business vehicles: 1. GL6: The vehicle's length, width, and height are 4692mm, 1794mm, and 1627mm respectively, with a wheelbase of 2796mm. The front suspension is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension. It is equipped with a 1.3-liter three-cylinder turbocharged engine, delivering a maximum power of 120 kW, a maximum torque of 230 Nm, and a maximum power speed of 5500 rpm. 2. GL8: The vehicle's length, width, and height are 5238mm, 1878mm, and 1776mm respectively. The front suspension is a MacPherson independent suspension, and the rear suspension is a torsion beam non-independent suspension. It is equipped with a 2.0T turbocharged engine, producing a maximum torque of 350 Nm and a maximum power of 174 kW.

14

0

Share

What does RST mean on a car?

RST on a car stands for reset, which is the abbreviation of the English word 'reset'. It is usually not a port but just a small hole with a tiny switch inside that can restore the navigation system to factory settings. This means that when the navigation system freezes or the program malfunctions, you can use this button to reset it, and the navigation will function normally again. A common scenario that triggers a reset is when a connection request arrives, but there is no process listening on the destination port. For UDP, when a datagram arrives at a destination port that is not in use, it will generate an ICMP port unreachable message, while TCP uses a reset.

12

3

Share

What to Do If ID Card Is Lost During Driver's License Exam?

If you lose your ID card during the driver's license exam, you can apply for a temporary ID card. Below is relevant information about the driver's license exam: 1. Exam Subjects: The subjects of the driver's license exam are standardized nationwide, divided into four categories: theoretical knowledge, field driving skills, road driving skills, and knowledge related to civilized driving. 2. Notes: Before the exam, you need to register first and then undergo a physical examination. The exam must be taken in the order of Subject 1, Subject 2, Subject 3, and Subject 4. Only after passing one subject can you proceed to the next. 3. Exam Content: Subject 1 mainly tests knowledge of road traffic safety laws, regulations, and related information; Subject 2 focuses on field driving skills, including reversing into a parking space, hill start and stop, right-angle turns, curve driving, and parallel parking; Subject 3 primarily assesses road driving skills, which is the most important exam subject; Subject 4 mainly covers knowledge related to safe and civilized driving.

10

0

Share

Where is the cabin air filter located in the Ford New Generation?

What Does a Yellow Light in a Car Indicate?

What is the normal mileage for a new car when taking delivery?

Where is the ETC device installed?

What Are the Buick Business Vehicle Models?

What does RST mean on a car?

What to Do If ID Card Is Lost During Driver's License Exam?

What to Do When Foreign Objects Get Stuck in the Window Glass Gap?

What to do if the driver's license has been overdue for review for 6 months?

What Causes the Engine Warning Light to Illuminate in a Passat?

Can I still drive on the road if one license plate is missing?