Where is the cabin air filter located in the Dongfeng Citroen C5?

1 Answers
StTalia
07/29/25 6:06pm
The cabin air filter in the Dongfeng Citroen C5 is located behind the glove compartment on the passenger side. To replace the cabin air filter, first pry open the three plastic fasteners at the bottom, then remove the two cover panels in sequence to access it. Due to the angled insertion design of the cabin air filter, it needs to be pulled out gradually when removing. The cabin air filter should be replaced every 15,000 kilometers or once a year, depending on the actual usage conditions of the vehicle. If you notice that the airflow from the air conditioning is weak during use, it may be caused by a clogged cabin air filter and should be cleaned promptly. The Dongfeng Citroen C5 is a vehicle launched by Dongfeng Citroen, equipped with a new 2.3L displacement engine. This engine is an all-new generation of high-efficiency all-aluminum engine designed and developed by the PSA Group R&D Center, featuring an inline four-cylinder VTCS (Variable Timing Control System) with a maximum power output of 126 kW and a maximum torque of 230 Nm.
Was this review help?
9
3
Share
More Forum Discussions

What is the solution for the Zotye T600 P1297 fault?

It is a voltage fault in the vehicle's electrical load sensor circuit. When this fault occurs, it indicates that the voltage in the load sensor circuit is too low. It is a pressure drop between the vehicle's turbocharger and the throttle. The throttle needs to be replaced to solve the problem.
17
3
Share

How to Reset the Maintenance Light on a 2020 Emgrand GL?

With the ignition switch turned off, press and hold the trip reset button without releasing it. Insert the car key and turn it to the position where the dashboard lights up, then release the trip reset button and wait for the maintenance light to go off. There is a button on the dashboard. Press and hold this button for 2 to 3 seconds while idling, and the maintenance reset will be completed once the maintenance prompt turns off.
17
0
Share

How to Maintain a BMW 5 Series?

Correct installation of the air filter can reduce wear on components such as cylinders, pistons, and piston rings. Proper installation of the oil filter prevents impurities from mixing into the engine oil during the operation of the internal combustion engine, avoiding wear on moving parts and clogging of oil passages. Replace when necessary, and clean the fuel injectors without disassembly. Check if the idle valve is excessively dirty and clean it if necessary. (If well maintained, replacement may not be needed) Suspension control arm bushings.
8
5
Share

What happens if the steering wheel is turned too early or too late during the reverse parking in Subject 2?

When reversing a motor vehicle into a parking space, turning the steering wheel too early will cause the right side of the vehicle to press against the boundary line. Turning the steering wheel too late will cause the left side of the vehicle to press against the boundary line. When reversing a motor vehicle into a parking space, it is essential to observe and adjust promptly through the left and right rearview mirrors.
13
1
Share

What are the steps for matching a 10-year-old Passat remote control?

Then click on system selection, choose 46 central module, the computer model will be prompted, select channel adjustment matching. Select 001 remote control matching, then input data "0" as prompted, choose to input "1", press the remote once to let the ECU recognize the remote signal. When prompted "channel matching successful", turn off the key and exit the software, press the remote, if the door lock motor responds, it indicates successful remote matching.
4
5
Share

How to reset the tire pressure light on a 2014 base model Tiguan?

Check if the tires have been punctured. After resolving any tire issues and ensuring the tires are properly inflated, proceed to clear the warning light in the vehicle's computer system. Press the buttons on the right side of the multifunction steering wheel. Use the left and right function keys to navigate to the settings menu, then locate and select the tire pressure option. There should be an option to reset the tire pressure monitoring system after completing the checks. Once these steps are completed, the tire pressure monitoring light should no longer illuminate.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.